熱偏轉 的英文怎麼說

中文拼音 [rèpiānzhuǎn]
熱偏轉 英文
thermal deflection
  • 偏 : Ⅰ形容詞1 （不正; 歪斜） inclined to one side; slanting; leaning 2 （只側重一面） partial; prejudi...
  • 轉 : 轉構詞成分。
  1. It compute the parameter of deflexion caused by thermal distortion in orbit, deduce the general expression for spreading beam after thermal distortion of reflector and the center deflexion of facula received in ccd. with the method of fixing etc, it put forward the restrain measures adopted accordingly

    計算了在軌運行條件下反射鏡面熱變形引起的表面法向偏轉參數，推導了鏡面變形后出射光線的通用表達式以及鏡面變形前後在ccd探測器上的接收光斑中心偏轉量的計算表達式。
  2. Firstly, simulate flow field of rear smoke channel, plot velocity magnitude and ash concentration distribution in section of entry of heat pipe air preheater, compare with data which were measured in guiyang power station, verify simulation to be reasonable and right. secondly, simulate all kinds of factors which affect flow field ' s uniformity such as length, thickness, location of diffluent board, ash concentration, ash diameter, and so on, find the chiefly factors. thirdly, install guide board in curve channel in rear smoke channel, then simulate its " flow field, plot velocity magnitude and ash concentration distribution

    在此基礎上模擬在冬夏兩季不同情況下，不同流速對熱管空氣預熱器壁面溫度的影響；然後對影響整個流場分佈的各種因素：包括分流板長度、厚度、偏離中心流道位置的偏離度、飛灰濃度、飛灰粒徑等因素進行數值模擬；最後提出在分流煙道轉彎處加裝導流板，並模擬加裝導流板后的流場分佈，得到下級空氣預熱器出口、熱管空氣預熱器進口處的斷面速度場分佈、濃度場分佈，以論證加裝導流板能達到流場均勻化的作用。
  3. Part 2 analyses beam landing shifts made by thermal deformations of a shadow mask and vibration of a new type of shadow mask - aperture grille. an automatic measurement system for cpt decolorization and a vibration measurement system for aperture grille are established. part 3 analyses the difference of perception and discrimination to color between the human eyes and ccd system, and develops a new method based on ccd technology to evaluate the screen white - balance

    主要內容分為三部分： （ 1 ）分析著屏電子束分佈與電子槍、偏轉系統及蔭罩之間的關系，研製自動測試裝置，為設計和改進相關結構提供依據； （ 2 ）分析蔭罩熱變形和振動對顯示屏色純度影響，建立了色純漂移自動測試裝置和張緊式蔭罩振動測試系統； （ 3 ）分析了人眼與ccd對彩色刺激的不同響應，建立了基於ccd的顯示器全屏色純均勻性測試方法。
  4. The effect on display characteristic made by thermal deformations of the shadow mask is comprehensively investigated. by using the electron beam distribution automatic measurement system with a micro - deflective coil, a concave spot in luminance distribution can be get. it changes its position when the shadow mask changes its form

    本文系統全面地分析了傳統蔭罩的各類熱變形對顯示屏特性的影響，利用本文研製的電子束亮度分佈自動測試系統，附加一個微偏轉磁場，使相鄰兩電子束打在同一顏色的熒光粉條，並形成一個亮度凹點，當蔭罩變形時，凹點位置作相應的位移，以此原理跟蹤測量凹點位移量，即可得到色純漂移動態變化曲線。
  5. The earth ' s rotation, through the coriolis effect, deflects rising fluids inside the earth ' s core the same way it twists ocean currents and tropical storms into the familiar spirals we see in weather satellite images

    地球自轉造成科氏力效應，會使地核內上升的流體偏向，就像造成洋流及熱帶風暴被扭轉成在氣象衛星影像中常見的漩渦狀那樣。
  6. The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine

    用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌：用xrd進行原料物相分析，及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度；用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性；用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化；用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試；採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定；用萊次偏光顯微鏡（ pm ）測試固體潤滑劑的硬度；用材料試驗機測試固體潤滑劑的抗壓強度等。
  7. This paper first introduced the pbd technique ' s basic principles and characters, these characters show that the pbd technique has many advantages in the nde ( non destructive evaluation ) field. then it described the theory model of pbd technique - three layers medium model, and explained the physical meaning of the model ' s solution

    然後描述了光熱偏轉方法的理論模型- -三層介質模型，對三層介質模型的解的物理意義加以了說明，並著重論述了引起光熱效應的物理量，即沿正向傳播和反向傳播的熱波的物理意義。
  8. Standard test method for beam deflection of " fiberglass " glass - fiber - reinforced thermosetting resin pipe under full bore flow

    在滿管水流情況下玻璃纖維增強熱固樹脂管射束偏轉的標準試驗方法
  9. Standard test method for thermal deflection rate of spiral and helical coils of thermostat metals

    熱雙金屬螺旋形元件熱偏轉率試驗方法
  10. During the thermal cycling cracks propagation, cracks deflection, bridge and pinning are the most predominant reasons that the improvement of thermal shock fatigue resistance of composites

    在熱震循環裂紋擴展中，裂紋偏轉、橋聯和釘扎是復合陶瓷熱震疲勞抗力得到改善的主要原因。
  11. It is a sensitive photothermal methods and widely used in the thin film characterizations not only for its high precision but also for the ability to get the fu - ll distribution of the surface deformation

    由於它既保持了光熱偏轉技術高靈敏性、高精度和非接觸的優點，又能獲得完整的表面形變的分佈，因而得到廣泛的應用。
  12. Standard test method for thermal deflection rate of spiral and helical coils of thermostat metal

    恆溫雙金屬螺旋形線圈的熱偏轉率的標準試驗方法
  13. At present, photothermal deflection technology and surface thermal lensing technology are widely applied in weak absorption measurement

    目前，廣泛使用的測量弱吸收的方法有光熱偏轉技術和表面熱透鏡技術。
  14. After broad investigation on this topic, the photo - thermal beam deflection technique ( pbd technique ) was applied on the evaluation of the optical thin films " laser damage by us as our lab ' s advantage

    在廣泛調研的基礎上，結合本實驗室自身的優勢，提出了應用光熱偏轉方法來評價光學薄膜的激光損傷。
  15. The experimental setups have been built in the use of the photothermal deflection technology and surface thermal lensing technology, respectively. the weak absorption of different optical thin films has been measured. the experimental results obtained from the above two methods were compared

    4 .分別建立了表面熱透鏡技術和光熱偏轉技術測量光學薄膜微弱吸收的實驗裝置，對多種光學薄膜樣品的微弱吸收進行了測量，並將兩種方法測得的實驗結果進行了比較。
  16. Finally, the experimental results obtained at three types of laser which was used as the pump source were presented, the experimental results were analyzed and some factors which effect the testing precision and rate of the pbd technique were discussed. in the end of the paper, the lab work was summarized and the future plan was viewed

    最後給出了應用三種不同的激光器作為泵浦源而得到的實驗結果，對這些實驗結果作了對比分析，並對一些影響光熱偏轉法測量精度和速度的因素作了討論和總結，並提出了今後的發展思路。
  17. During explaining the model ' s physical meaning, it focused on the physical parameter ' s character which induced the photo - thermal effect. then this paper introduced three types of pbd technique applied in the experiments - that is transverse photo - thermal deflection technique ( mirage effect ), photo - thermal reflectance detection technique and transmission photo - thermal deflection technique

    然後介紹了在實驗中具體應用到的三種光熱偏轉方法- -即掠射式的光熱偏轉方法、反射式的光熱偏轉方法和透射式的光熱偏轉方法。
  18. Upon reaching the surface, the heated liquid will spread laterally in all directions until it reaches the edges of the container, where it will be deflected downward to the bottom of the liquid layer, eventually to be drawn back towards the heat source

    一旦達到地幔的上表面，被加熱的流體將在各個方向上橫向擴展，直至達到儲層的邊緣，在這里流體將向下偏轉到流體層的底部，最後向熱源退卻。
  19. There is a part of beam loss during the course as the neutralization of high - energy particles dragged from the ion source, the deflexion of charged particle on the beam stream and the scraped beam of exceeding beam waist and low density. it is necessary to analyze the beam loss and bring forward a rational project for absorbing beam stream

    將離子源引出的高能粒子進行中性化，再偏轉掉束流中的帶電粒子，將超過束腰半徑、密度較小的束流削除，在此過程中有一部分束流損失，它直接影響加熱功率的因素，因此，對束流損失進行了分析，對損失束流的吸收提出了吸收方案。
  20. To consolidate its competitive position, the group has continued its vertical integration of in - house production of critical components including crt monitor deflection yokes and lcd monitor panel assemblies

    為了在競爭熾熱的商業環境中鞏固地位，集團持續推行垂直整合，包括自行生產映像管顯示器的偏轉線圈及自行組裝液晶體顯示板。
分享友人
分享到 Line

分享到臉書