熱分配 的英文怎麼說
中文拼音 [rèfēnpèi]
熱分配
英文
heat distribution-
A method to calculate quantitatively the adsorption volume or adsorption space of per mass of adsorbent derived from both the adsorbed molecule volume and the maximum adsorbance of a solute in an adsorption isotherm under a given experimential condition is presented firstly for a solid / liquid adsorption system of the solute in a dilute aqueous solution. this method is suitable for not only mono - layer adsorption, but also mani - layer adsorption and micelle adsorpion of surfactant constructed by hydrophile and lipophile groups. therefore, the surface concentration of the adsorbate, cs, deduced from the adsorption volume is possessed of the meaning of true concentration, and the value of the patition coefficient of the adsorbate between solid and liquid phass, p, attained by the cs and the c, solution concentration of the adsorbate, can be accurate. the foregoing a set of calculations are presented for the solid - liquid adsorption systems consisted of the wool fiber and separately dodecyltrimethyl - ammonium bromide ( dtab ) and hexadecyltrimethyl - ammonium bromide ( ctab ) in this paper. this provides a strong basis for adsorption thermodynamic investigation of adsorbate
對稀溶液中溶質的固/液吸附體系，首次提出了根據吸附分子體積和實驗條件下吸附等溫線中的最大吸附量計算單位質量吸附劑的吸附體積或吸附空間的方法.此法適用於單層吸附，也適用於多層吸附和具有親水親油結構的表面活性劑分子的膠團吸附.由此，吸附質的表面相濃度cs具有真實濃度的含義，相應地，計算得到的溶質的固/液分配系數p就有了準確值.分別計算由溴代十二烷基三甲銨（ dtab ）和溴代十六烷基三甲銨（ ctab ）與羊毛纖維構成的液/固體系分配系數等，為溶質吸附的熱力學研究奠定了基礎The paper mainly consider the followings : the performance parameter determination of cryopump, heat load determination and heat transfer of large cryopanel, reasonable distribution of heat load, the condition for construct steady flow in small vertical circle pipeline, balance condition for gas and liquid two - phase flow in the connection pipe between cryopanel and dewar, the safety of cryopump
文中探討了低溫泵性能參數的確定；大抽速低溫抽氣面的熱負載的確定及合理分配；冷凝面上豎直圓管內受熱建立穩定流動的條件；冷凝面與杜瓦間的連接管道內氣液「雙相流動」的平衡條件；低溫泵系統運行的安全問題。District heating. hot or cold water transport and distribution networks. terminology
地區供熱.冷水或熱水輸送和分配網路.術語District heating - hot or cold water and distribution networks - particularities of pumping stations
地區供熱.冷水或熱水分配網路.泵站特徵District heating. hot or cold water transport and distribution networks. particularities of design
地區供熱.熱水或冷水輸送和分配網路.設計的特殊性Based on analysis of geologic foundation record about pingzhuang basin, a lot of sino - foreign geothermal geology record and investigation of field geology, measuring of ground temperature in person and geo - chemical analysis of ascension spring, gushing water of fault, the fact that the anomaly of geothermal gradient of pingzhuang basin, which is in region of low geothermal gradient, is caused by redistribution of conduction - oriented geothermal heat flow which is result from upheaval and depression of basin foundation bed is pointed out. after the field of ground temperature is simulated under the background of conduction - oriented geothermal heat flow by means of ansys, the characteristic of ground temperature distribution of top surface of basin foundation bed ( yixian team ) is revealed. the sound condition of transmissibility fault and feeding water source, which are imperative in formation of the low - medium temperature geothermal system of convective type, is possessed in pingzhuang basin
通過對平莊盆地基礎地質資料、國內外大量地熱地質資料的分析和野外地質調查、礦井實測地溫以及上升泉、斷層涌水的地球化學分析等工作基礎上，指出地處低地溫梯度背景區的平莊盆地地溫梯度異常是由於盆地基底隆起和坳陷引起傳導型大地熱流再分配所致；運用州sys數值模擬了大地熱流向地表傳導背景下的盆地地溫場，從而揭示了盆地基底（義縣組）頂界面地溫分佈特徵；闡明了盆地具有形成中低溫對流型地熱系統所必需的導水斷裂、補給水源等的良好條件，中低溫對流型地熱系統是地熱勘查的主要對象；圈定了平莊盆地北部朝陽溝?駱駝營子地熱勘查遠景區。The calculation and design procedures of air conditioning load, ground loop heat exchangers, radiant floor system, distribution system between heat pump and build are mainly introduced
重點介紹了建築空調負荷計算、地下埋管換熱器系統、輻射地板系統以及熱泵和建築物內分配系統設計等方面的內容。Heating, ventilation and air - conditioning ; testing of air distributions systems serving operating theatres
加熱通風和空調.操作場所用空氣分配系統的試驗This paper researches the basic statistical rule of oil - gas dynamic system from the systematic theory, combining with the common characteristic and structure characteristic of oil - gas dynamic system, taking the design requirement of oil field development programming into consideration, by using of functional simulation principle ( including nn method, differential simulation method ) and historical data of oil field, establishes the in - out conjunctional relationship of dynamic index of oil field development, and researches the two level index prediction of development dynamic with both oil field and oil production plant on the basis of the in - out conjunctional relationship. furthermore, this paper analyzes the " decision - making variable ", " object " and " restriction terms " by the optimization theory and set up several optimal models which compose the oil field development programming, it is following : optimization model of the production composing ( solving the optimal composing of each subentry production and cor responding cost, workload, including the onshore thin oil production, the heavy oil thermal process production, tertiary oil recovery production, and the offshore production ) ; optimization model of measure production structure ( determining the optimal composing of each measure production and measure workload, which is composed of fracture, acidulation, capital repair and so on ) ; optimization model of the production distraction ( optimal distribution of the whole oil field production to each oil production plant ) and the integrated development programming model of oil field
本文從系統理論出發研究油氣動態系統基本統計規律，結合油氣動態系統的一般特點，結構特點，兼顧油田開發規劃設計的要求，利用功能模擬原理（含神經網路方法、微分模擬方法） ，依據油田歷史數據，建立了油田開發動態指標間的輸入輸出關聯關系，並在此輸入輸出關聯關系的基礎上研究了油田及採油廠兩級的開發動態指標預測，同時利用最優化原理，在分析「決策變量」 、 「目標」及「約束條件」的基礎上建立了多個構成油田開發規劃的「優化模型」 ，這些優化模型包括：產量構成優化模型（解決陸上稀油產量、稠油熱采產量、三次採油產量、海上產量及對應的成本、工作量的最優構成問題） ；措施產量結構優化模型（解決壓裂、酸化、大修等各項措施產量及措施工作量的最優構成問題） ；產量分配優化模型（將油田的產量最優地分配到各採油廠）以及油田綜合開發規劃模型。Through adjust the initial vaiue of the water supplied tcmperature in the second - net, the amomation systcm can auto run with a depressed standard to distribllte the energy averagely
即當供熱能力不足時，通過調整二次供水溫度的設定值，使自動控制系統在降低供熱標準的基礎上自動運行，實現熱量的平均分配。A nonlinear mathematical model is developed to determine the flow rate distribution in the parallel tubes of boiler superheater and reheater by depending on the relation of pressure drop among individual tubes and accounting for the static pressure variations in the inlet and outlet headers
根據並聯管組各根管子進、出口壓力降之間的關系，並考慮到分配集箱與匯集集箱中流體的靜壓變化，建立了鍋爐過熱器、再熱器流量分配的非線性數學模型。The uplink access dynamic bandwidth allocation algorithm is a hotspot of the research at home and abroad now
上行接入帶寬分配演算法是目前國內外研究的熱點。The results indicated that the dimension, shape and purity of base material could meet the functional demand of solid lubricant ; the thermal decomposition temperature of ptfe resin exceeds 400 c, but organic and inorganic packing filler added in ptfe made the water absorption rate of composite material increased, melting temperature and decomposition temperature decreased, in the meanwhile oxidative decomposition reaction was accompanied ; polar groups such as c = o, c - o - c and so on in the carbon fiber surface is advantageous to increase compatibility with other components and interlayer shearing strength ; uniform design experimental method could help to find the relationship between formula and frictional property by relatively small tests. the developing trend of each formula ' s friction coefficient could be showed by fitting curve ; the friction coefficient with no copper powder or graphite in formula was relatively big. this fact showed that copper powder and graphite should be used cooperatively ; it was found that when the ratio of copper powder to graphite by weight is 15 : 60, 30 : 30 - 40 and 60 : 15 - 30 respectively, the friction coefficient was relatively small. the degree of crystallinity of pure ptfe reached maximum by air cooling and the abrasion loss also reached maximum among three ones ; at the same time, the abrasion loss of solid lubricant sample was also the biggest among three ones ; when solid lubricant matched with 45 # steel axle or gcrl5 steel axle, lubricant transfer film could be formed on metal surface, thus direct contact between the surface of metal friction pair rings was reduced. their working life was elongated extremely ; there was mainly much graphite, a little ptff, moo3, feso4, cus and so on in lubricant transfer film
試驗結果表明：所選原料的尺寸、形狀及純度可滿足固體潤滑劑的性能要求；聚四氟乙烯樹脂熱分解溫度超過400 ，但在ptfe中加入無機填料會使復合材料吸水率提高，熔融溫度及分解溫度降低，且伴有氧化分解反應；碳纖維表面含有c = o及c - o - c等極性基團，有利於提高其與其它組分的相容性，提高層間剪切強度；均勻設計試驗方法能夠用較少的試驗次數找出配方與摩擦性能間的關系，擬合曲線基本能表示各配方的摩擦系數發展趨勢；配方中不加銅粉或不加石墨，其摩擦系數均較高，說明銅粉和石墨應該配合使用；當銅粉15份、石墨60份時，銅粉30份、石墨30 - 40份時，銅粉60 、石墨15 - 30份時，摩擦系數均具有較低值；純聚四氟乙烯樹脂在空氣冷卻時結晶度最大，磨損量也是三者中最大的；同時，固體潤滑劑試樣在空氣冷卻時的磨損量也是三者中最大的：不論是固體潤滑劑與45 #鋼軸配副或是固體潤滑劑鑲嵌入銅套后與gcr15鋼軸配副，在金屬表面均可形成潤滑轉移膜，從而減少金屬摩擦副表面間的直接接觸，大大延長其使用壽命;轉移膜中主要含有較多的石墨、少量聚四氟乙烯、 moo 。Based on the investigation of the average heat load during heating period and non - heating period, the paper conducts the distribution of heat load, thermodynamical calculation and economic index calculation for the union operation of various heating units
根據調查採暖期和非採暖期的平均熱負荷，對不同類型的供熱機組聯合運行進行了熱負荷的分配、熱力計算及經濟指標的計算。Methods for testing and rating induction units for air distribution systems - thermal and aerodynamic performance
空氣分配系統用感應裝置試驗及評定方法.第1部分:熱特性和空氣動力特性Heat cost allocators for the determination of the consumption of room heating radiators. appliances with electrical energy supply
測定房間暖氣片損耗用的熱量成本分配器.帶供電源的器具Heat cost allocators for the determination of the consumption of room heating radiators - appliances without an electrical energy supply, based on the evaporation principle
測定房間暖氣片消耗的熱成本分配器.以蒸發原理為基礎的不帶電源器具Heat cost allocators for the determination of the consumption of room heating radiators. appliances without an electrical energy supply based on the evaporation principle
測定房間暖氣片損耗用的熱量成本分配器.以蒸發原理為基礎的不帶電能源的器具Heat cost allocators for the determination of the consumption of room heating radiators - appliances with electrical energy supply
測定房間暖氣設備損耗用的熱量費用分配器.帶電能源的器具Contains pertinent information regarding event, heat and lane assignments for all participating swimmers at a meet
允許包含與測試比賽相關的信息，為比賽中的所有運動員加熱分和配泳道。分享友人