熱力學參數 的英文怎麼說

中文拼音 [rèlìxuéshēnshǔ]
熱力學參數 英文
state function
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 學 : Ⅰ動詞1 （學習） study; learn 2 （模仿） imitate; mimic Ⅱ名詞1 （學問） learning; knowledge 2 （學...
  • 參 : 參構詞成分。
  • 數 : 數副詞（屢次） frequently; repeatedly
  1. Study on the thermodynamic parameters for adducts of lewis a - b by gas liquid chromatography

    酸堿加合反應的熱力學參數
  2. Secondly, the basic methods for parameter identification and the identifiability of parameter identification are dissertated. through the example of the problem of heat emission in one - dimensional infinite slab, the identifiability of thermodynamic parameter of concrete is proved theoretically

    論述了參數辨識的基本方法和參數可辨識性的條件，以一維無限大平板的散熱問題為例，從理論上論證了混凝土熱力學參數可辨識性。
  3. The results are compared with the data offered by asher. 3. the factors of compressibility of humid air are calculated by this new state equation

    計算了本文提出的熱力學參數范圍內真實濕空氣的焓和熵; 5 .用eos法和活度系數法對濕空氣的汽液相平衡進行了計算。
  4. According to the parameter range of humid air used in humid air turbine and compressed air energy storage ( caes ) system, the applied range of thermodynamics properties of humid air is determined. 2. based on virial state equation and the corresponding - state principle, expand - corresponding - state principle is introduced to describe the virial coefficients of state equation

    對應態理論是一個普適性理論，因此對應態維里方程具有一定的外推性，計算了本文提出濕空氣熱力學參數范圍內的壓縮因子; 4 .應用本文提出的對應態維里方程，計算了濕空氣的偏差焓和偏差熵。
  5. Differential scanning calorimeter ( dsc ) combined with melt fluxing technique was used to realize undercooling of melt and its specific heat was measured at the same time, and its thermodynamics were calculated simultaneously and compared to four well - known models

    本文將差示掃描量熱法（ dsc ）和助熔劑處理技術相結合，研究了熔體的過冷現象，測量了過冷狀態下熔體的比熱，計算了過冷熔體凝固過程中的其它熱力學參數，並與四種近似模型進行了比較分析。
  6. Following these two examples of two and three phases, regarding ternary and quarternary metallic melts involving eutectic as melts consisting of three and four non - homogeneuos solutions correspondingly, and using thermo - dynamic parameters of binary metallic melts involving eutectic, calculating models of mass action concentrations for ternary symmetrical melts formed from similar metastable compounds, ternary unsymmetrical melts formed from unsimilar metastable compounds and quarternary metallic melts involving eutectic have been formulated

    仿照這兩個二、三相熔體的例子，將含共晶體三、四元金屬熔體看作由3 ， 4個溶液組成的非均相熔體，並利用含共晶體二元金屬熔體的有關熱力學參數，針對由同類亞穩態化合物組成的對稱型三元系、不同類型亞穩態化合物組成的非對稱型三元系及四元系含共晶體金屬熔體，制定了相應的作用濃度計算模型。
  7. Based on the analysis of the forms and facilities of the scwr system, the status of scwr was investigated in the industry of printing and dyeing. two projects of scwr system were brought forward and the thermal economics of the scwr system was studied

    首先對印染企業的冷凝水回收進行調查研究，提出了兩種蒸汽冷凝水回收方案，對兩種回收系統進行了管路水力和熱力計算，確定了系統各點的熱力學參數。
  8. On the basis of the equation of mass equilibrium, the important kinetics and thermodynamics parameters in the extraction process of safflower yellow pigment were obtained by experimental determination, the mathematical model for the extraction process of safflower yellow pigment was established

    摘要以質量平衡方程式為基礎，通過實驗剛定，求得了紅花黃色素浸提過程中重要的動力學和熱力學參數，建立了紅花黃色素浸提過程的數學模型。
  9. On the other hand, explosive boron nitride ( e - bn ), another high - pressure phase of bn, was obtained in the resultant films. we also studied the thermodynamic parameters of the growth of e - bn films

    另外，在我們所制備的薄膜中還得到了氮化硼的另一高壓相-爆炸結構氮化硼（ e - bn ） ，並初步研究了其生長的熱力學參數。
  10. The unstable gas stream is characterized by oscillations with transient velocities of about + 100 m / s and frequencies from 50 - 200h /. the enhanced mixing and transport processes lead to a highly efficient moisture evaporation rate during pulsating spray drying. the computational fluid dynamics ( cfd ) method was used for the analysis and investigation of flow, temperature and humidity fields in a pulsating flow spray - drying chamber

    長期以來，對噴霧乾燥過程進行了各種試驗和模擬研究，但這些研究並不能揭示噴霧乾燥室內氣體運動狀態，顆粒群的運動軌跡和各種熱力學參數分佈信息，常規的測試手段又很難測得，而這些參數分佈信息對乾燥器沒計和過程優化具有重要指導作用。
  11. Identification of concrete thermal parameters based on fuzzy theory

    基於模糊理論的混凝土熱力學參數識別方法
  12. The application examples of thermodynamic phase diagram in new ceramic

    熱力學參數狀態圖在新型陶瓷材料中的應用實例
  13. The great deviation of thermodynamic parameter will be brought on the calculation of thermodynamics process by using the common idealized assumption for humid air

    為了滿足工程設計的要求，濕空氣必須看作實際氣體，以便在高溫高壓條件下準確確定其熱力學參數。
  14. As a result, we focus on applications of spr and qcm biosensors for high - throughput screening and the acquisition of thermodynamic and kinetic parameters of different biding systems in this article

    本文中，筆者針對表面電漿共振與壓電石英微天秤在小分子藥物活性篩選、動力學及熱力學參數的求測來進行探討。
  15. Selecting thermal characteristic parameters of concrete according to the feedback analysis of the data determined in spot is a kind of reliable method when big physical volume concrete temperature field is in simulative calculation

    摘要大體積混凝土溫度場模擬分析時，根據現場實測資料對溫度參數反分析是選取熱力學參數的一種比較可靠的方法。
  16. A kind of improved accelerating genetic algorithm and its parallel method are introduced the good result is obtained with the application of the method in feedback analysis for the rmnal chatacteristic porameters of concrete in some actual engineerings

    提出一種并行化的改進加速遺傳演算法，應用於某實際工程的混凝土溫度場熱力學參數的反分析，取得了較好的效果。
  17. Concentrated on simulative analysis of 3 - d temperature and stress fields of concrete dams, determination of thermodynamic parameters, cracking mechanism, crack prevention, crack control and crack repairs, the mainly work in this dissertation are as follows : 1

    本文圍繞混凝土壩三維溫度場與應力場模擬分析、熱力學參數確定、裂縫成因機理、防裂限裂措施及裂縫補救方法等，作了如下的工作： 1
  18. For researching behaviours revealed in most products of condensed explosives at cj state which is undissolvable each other, the technjques to prepare an iso - mole adinixture consisted ofwaer ( h, o ) and benzene ( c, h, ) has been developed and measured some useful enersetics parameters by using emulsificaton at normality

    為了研究叮態凝聚炸藥不相互溶的絕大部分產物特性，引入乳化技術對典型物質，水刃）苯c札l進行常態等摩爾混合制樣，並測得一些有用的熱力學參數。
  19. The main work and the conclusion are as follows : based on the parameter of the 10kw space solar power system designed by our own country. built up the dynamic math model of the heater, radiator, thimble reheat, single turbine. and then applied the acsl language to compiled the corresponding simulation program, analyzed the steady state parameter

    本文的主要工作和結論如下：在我國自行研製的10kw空間熱動力電源系統設計方案的幾何參數和熱力學參數的基礎上，建立了包括吸熱器、輻射器、管式回熱器、單級壓氣機在內的系統動態數學模型，並應用acsl語言編制了相應的模擬程序。
  20. Thirdly, according to the thermodynamic parameters calculated from adsorption test data, further studies of adsorption mechanism of methane on coal are made. it ' s put forward that, adsorptivity should be evaluated from the three aspects, including specific surface area, adsorption capacity on per surface area and interaction between methane molecule and coal surface

    以吸附熱力學參數為討論對象，較深入地研究了煤吸附甲烷機理，提出評價煤的吸附能力時，應考慮比表面積、單位面積上的吸附量和甲烷分子與煤表面之間的相互作用三方面的綜合影響。
分享友人
分享到 Line

分享到臉書