熱差電偶 的英文怎麼說
中文拼音 [rèchādiànǒu]
熱差電偶
英文
thermocouple-
Thermocouples age with time and readings drift.
熱電偶隨時間而老化,讀數會偏差。4. the thrust measurement device was calibrated, and the accuracy was 2 % fs. at the same time the signal of thrust measurement was input to the computer. e - type chromel - constantan thermocouple was used to measure the temperature of mpt, and the accuracy was 5 % fs. the vacuum measurement was realized by using zdf - 5427m vacuometer, and the accuracy was 3 % fs
( 4 )對推力測量系統進行了標定並實現了計算機採集,推力測量系統最大相對誤差為2 fs ;溫度測量目前還只限於對mpt諧振腔壁溫的測量,使用e型鎳鉻?康銅熱電偶即可較容易實現,其測量精度為5 fs ;真空測量採用zdf - 5427m微機型復合真空計,其由熱偶計和熱陰極電離計復合而成,該真空計測量控制精度為3 fs 。Standard specification for magnesium oxide and aluminum oxide powder and crushable insulators used in the manufacture of metal - sheathed platinum resistance thermometers, base metal thermocouples, and noble metal thermocouples
金屬外殼的鉑電阻溫度表基金屬熱電耦和貴金屬溫差熱電偶製造中使用的氧化鎂和氧化鋁粉末及壓扁絕緣子的標準規范The problem may be minimized by mounting wire wound resistors to ensure that temperature differentials are minimized
調整電阻的安裝方式,盡量降低兩端的溫度差異,可以降低熱偶誤差。The temperature rises and the dc voltage are proportional to the power dissipated, which is equal to the power of the source being measured if the input impedance is suitably matched to the source impedance
熱偶冷熱結之間的溫度差和熱電勢均正比于耗散在ta2n電阻上的微波功率,如果熱偶的工作電阻與同軸傳輸系統電阻匹配適當,該功率就等於被測源的功率。Furthermore, we compared the mechanical properties between the modified nano - cac03 / pp and unmodified nano - cac03 / pp. we have investigated the composites by means of mechanical testing, dsc, xrd, ft - ir, tem, sem, etc. the relation between the structure and property of the composites has been discussed in this thesis. we studied the nano - particles by means of ls particles size analysis, we also studied the modified nano - cac03 by means of ft - ir
論文中對caco _ 3粒子進行了粒度與比表面測試分析,對經鈦酸酯偶聯劑表面改性的納米caco _ 3粒子進行了紅外吸收光譜分析,對改性后的復合材料進行了力學性能測試、差熱掃描量熱分析、 x射線衍射譜、紅外吸收光譜、透射電鏡、掃描電鏡等分析,討論了樣品中結構和性能之間的關系。Thermocouples ; part 3 : extension and compensating cables ; tolerances and identification system
熱電偶.第3部分:加長電纜和補償電纜.容差和鑒定系統At the same time, we use 42 pairs of thermopiles as the temperature sensor to keep the two samples to be at same temperature. it increases not only measurement sensitivity, also is easy to perform continuous heating the samples and improves measurement efficiency. b
C .為了保證與環境絕熱,在樣品架與銅塊之間安裝了20對熱電偶,同時還在銅塊和內輻射屏之間裝了5對熱電偶來監視樣品與環境的溫差,以便於自動加熱控溫。Thermocouples - part 2 : tolerances
熱電偶第2部分:允差Note : the tolerance of this list is indicated by v. the tolerance expressed by centigrade is linked the temperature of measuring side of thermocouple
注:本表所列允差用微伏表示,用攝氏度表示的允差與熱電偶測量端的溫度有關,括號中的溫度值是按表列熱電偶測量端溫度換算的。Reference junciton error of thermocouple
熱電偶的參比端誤差Differential method of calibrating thermocouple
熱電偶微差檢定法Extension lead error of thermocouple
熱電偶的延長導線誤差The inhomogeneity of the thermocouple wire will normally be evaluated to assess its effect on the calibration uncertainty
熱電偶線的非均勻性將被評估,以評定其對校正誤差的影向。Thermocouples ; part 3 : extension and compensating cables ; tolerances and identification system iec 60584 - 3 : 1989, modified ; german version hd 446. 3 s1 : 1993
熱電偶.第3部分:加長電纜和補償電纜.容差和標識系統3 for type k, n, e and t, which tolerance class or only suitable for above - 40
3對k n e t型鎧裝熱電偶材料,級和級允差只能分享友人