熱擴散度 的英文怎麼說

中文拼音 [rèkuòsǎndù]
熱擴散度 英文
thermal diffusivity
  • 擴 : 動詞（擴大） expand; enlarge; extend
  • 散 : 散動詞1. （由聚集而分離） break up; disperse 2. （散布） distribute; disseminate; give out 3. （排除） dispel; let out
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  1. The third model was designed to investigate atom diffusion at contacting point. fe was sintered at 500, 550 > 600, 650 > 700 under bpec and radiation heating. the test results of image processing indicated that the average pore size took on wavelike with temperature under bpec heating

    脈沖大電流加熱條件下，其它條件相同時，分別在800 、 900的溫度武漢理土大學碩士學位論文下擴散連接cu絲和ni絲，結果表明接觸線處cu和ni的擴散系數隨溫度的升高而增大。
  2. Pulse electric current heat treatment ( pecht ) developed by sodick, ltd., of japan, is a recently developed material processing method which consists of spark plasma sintering and welding, plasma activated sintering and welding, big pulse electric current ( bpec ) diffusion welding etc. the following are basic merits of pecht : rapid heating and cooling ; short sintering or welding time ; lowering sintering or welding temperature

    脈沖電流熱加工（ pulseelectriccurrentheattreatment ，比如燒結，焊接等）是九十年代發展起來的一種材料快速制備新技術，它包括放電等離子燒結與焊接、等離子活化燒結與焊接、脈沖大電流擴散焊接等。它具有升溫、降溫速度快、能在較低的溫度下燒結或焊接以及時間短的特點。
  3. A transfer model is established, which can be used to study the interaction between the land surface physical processes of inhomogeneous region and the structure of atmosphere boundary - layer over urban and rural terrains. the model has simulated surface heat flux, surface temperature, temperature profiles, height of mixture layer and so on. and the differences between urban area, suburban area and rural area have been compared. this model mainly depends on the parameters below : surface albedo, surface roughness coefficient, moisture available coefficient of soil, thermal capacity and thermal diffusion coefficient of errain, cloudage. the result shows that this model can simulate the structure and eigenvalues of atmosphere boundary layer and their changes in a day. parameters used in this model aim at beijing city, and the time is at the beginning of september. to other cities, or other time, the parameters should be adjusted accordingly. in addition, being adjusted, the model can also be used for other homogeneous and inhomogeneous terrains

    模式主要依賴于以下參數和物理量：地面反照率下墊面粗糙度土壤的可含水量下墊面的熱容量和熱擴散系數雲量等參數。結果表明，本模式能合理地模擬不同地表熱量平衡地表氣溫混合層高度湍流交換系數湍流動能位溫廓線等，以及它們的日變化。該模式所取參數主要針對北京市，時間為九月初，對于其他城市，參數應作相應的調整。
  4. The diffusion carrier concentration profile and junction depth were measured and compared with conventional furnace processing diffusion ( cfd ). it presented following conclusions : 1 ) the temperature distribution in quartz chamber of rtd furnace is uniform because square resistance is uniform after rtd ; 2 ) the diffusion velocity of rtd furnace by a factor of three compare to conventional furnace processing diffusion ( rtd ) ; 3 ) if diffusion temperature and doping phosphorus are equivalent, doping phosphorus of rtd are more than of cfd in equivalent distance to the silicon surface

    實驗研究了快速熱擴散（ rtd ） ：通過旋塗磷膠和印刷磷漿兩種方式考查了2 4和103 103單晶硅的快速熱擴散特性，發現： 1 ）此樣機的溫度場在空間分佈上是均勻的； 2 ）快速熱擴散可以比傳統擴散快3倍的速度進行擴散； 3 ）在擴散溫度和摻雜磷源相同的條件下，與傳統擴散相比，快速熱擴散將雜質向結更深的地方推進。
  5. The voltage of lithium - intercalation reaction, impedance and structural stability of intercalation - type cathode material were analysed and calculated. theoritical results show that the reaction voltage depends on the content of lithium and the bond energy, and that the key ways to lower the electrode impedance are to increase the electronic conductivity of the electrode and the diffusion coefficient of lithium ion in the host and to decrease the size of powder. in addition, the thermal stability of lithium - insertion structure can be improved by using crystallographic co - lattice theory and doping treatment

    本文從嵌入式陰極材料的嵌鋰反應的電壓、阻抗及結構穩定性的分析和理論計算著手，得到了電壓取決于基體中各種離子間的鍵能及鋰含量、降低電極阻抗的關鍵是提高電子型導電性和li ~ +在基體中的擴散系數及減小粉末粒度的理論依據及其利用晶體的共格原理和摻雜改性的方式來提高材料嵌鋰結構的熱穩定性的設計思路。
  6. A two - dimensional double diffusive laminar natural convection in rectangular enclosure is detailed analyzed. the results show that when the thermal and solutal buoyancies aid each other, the airflow consists of one main cellular structure and is steady, regardless of the relative strength variation between the heat and pollutant sources. there are multiple flow structures, however, according to the relative strength when the buoyancies opposing each other

    模擬結果表明雙擴散自然對流系統的空氣流動與傳熱傳質特性完全是由離散熱源與污染源浮升力之間的相互作用關系訣定的：當離散熱源與污染源浮升力協同作用時，自然對流呈比較穩定的單一流動結構；而當熱源與污染源浮升力對抗作用時，自然對流系統隨它們之間強度變化呈現出多種流動狀態。
  7. The activation energy of the tpl peak is calculated being about 1. 5 ev for four heat treated samples ( furnace cooling, air cooling, dry ice quenching, liquid nitrogen quenching ), and it is near the self diffuse activation energy of aluminum 1. 45ev

    爐冷、空冷、乾冰冷和液氮冷四種熱處理制度根據幾，峰峰溫數據計算的激活能的結果約為1 ? sev ，接近於鋁的自擴散激活能1 . 45ev 。
  8. These kinds of measurements are necessary for determinations of thermal diffusivities from the thermal conductivity and densities.

    根據熱導率和密度確定熱擴散率必須進行這種測量。
  9. The effect of thermal conductivity of membrane on the distribution of temperature in the fuel cell is discussed, and the effect of inlet velocity and porosity of porous diffusion layers on the fuel cell performance are analyzed

    討論了質子膜的導熱率對電池內溫度分佈的影響。分析了進料速度和多孔擴散層孔隙率對電池性能的影響，結果表明較快的進料速度和較大的擴散層孔隙率都能有效提高電池的性能。
  10. Taking into consideration of the factor include heat diffuse coefficient of soil and time, which affect soil temperature of differential deep, the model can calculates temperature of any time in different depth

    模型中充分考慮了土壤熱擴散率、時間對溫室土壤不同深度的溫度影響，可計算出任一時間、土壤不同深度的溫度。
  11. It presents a mathematical heat transfer model of air and soil temperature in greenhouse basing on the theory of transmission of heat. the model calculates the heat diffuse coefficient of soil by difference method and establishes regression equation on experimental data by sas

    基於傳熱學的熱傳導方程，利用測試的地溫數據，選用差分法計算了土壤熱擴散率，應用sas軟體擬合了非線性方程，建立了日光溫室土壤溫度場的數學模型。
  12. The effects of interfacial resistance, superheating, free convection due to both temperature and concentration gradients, mass diffusion and thermal diffusion, and variable properties in both the liquid and gas - vapor regions were considered

    分析中，考慮了相間阻力、液膜波動、蒸汽過熱度、因溫度和濃度梯度引起的自然對流、質擴散和熱擴散以及物性的變化。
  13. Abstract : water solution polymerization and precipitation polymerization of ethenyl radical monomers were carried out at same conditions, and the differences between the products in molecular weight and other aspects were investigated

    文摘:針對目前溶液聚合體系中、後期粘度高，熱擴散不利，從而影響分子量提高的問題，進行乙烯基類單體在同等條件的水溶液聚合及沉澱聚合，比較了獲得的聚合物產物在分子量及應用性質上的差異。
  14. As well, the compress stress existed in ( 002 ) crystal plane are found and can be explained by the matching between film material and substrate material as well as the different thermal expand coefficient between them

    同時， zno薄膜（ 002 ）方向上存在著內應力，內應力是由膜材料與基底材料之間的晶格失配和不同熱擴散系數造成的，退火可可使內應力的到不同程度的釋放。
  15. We give ptr ' s amplitude and phase signal of one dimension based on the theory of ptr, discuss the ptr ' s signal ' s frequency characteristic, and a method for measuring thermal diffusivity of opaque materials is introduced. then, we study on anisotropic materials " thermal conductivity, the temperature field and thermal conductivity tensor of anisotropic materials is theoretically deduced from the theory of ptr, and is proved by the experiment

    從光熱輻射理論出發，推導出一維情況下ptr信號的振幅和位相表達式，討論了光熱信號的頻率特性，介紹了一種用ptr技術測量不透明材料熱擴散系數的優化方法；接著研究分析了各向異性介質受調制激光束輻照下產生的光熱信號，在理論上推導出各向異性介質的溫度場以及熱導率張量並給予一定的實驗驗證。
  16. A new thermal probe method for determining thermal conductivity based on the minimal dispersion of thermal diffusivity

    據熱擴散率最小離散度確定導熱系數的新熱探針法
  17. The results show that the thermal diffusivity of thin film is smaller than its corresponding bulk material, and with the decreasing of the thickness, the thermal diffusivity also decreasing

    ）的二氧化硅薄膜、氮化硅薄膜、多晶硅薄膜的熱擴散率，實驗結果表明，薄膜的熱擴散率比其體材料的要小，並且隨著薄膜厚度的減小，熱擴散率也減小。
  18. The heat transfer and thermophysical properties of thin films, including thermal conductivity and thermal diffusivity, differ from the corresponding bulk material when it comes into microscale regime

    進入微尺度以後，薄膜材料的導熱規律以及熱物性（包括熱擴散率、熱導率）與體材料相比發生了很大的變化，出現了超常現象。
  19. Dr low - grade hot regeneration absorbing type desiccator, comprehensive varyimg voltage absorb and become the warm advantage that absorb, absorb under the high steam partial pressure of the normal atmospheric temperature ( work ) ; in high temperature, low steam partial pressure is it analyze to lay ( regeneration ), namely moisture that absorbent absorbed in the course of absorbing, rely on high - quality getting angry between thermal diffusion and low partial pressure two mechanism common to act on and can drive out completely in the course of regeneration

    Dr微熱再生吸附式乾燥機，綜合變壓吸附和變溫吸附之優點，在常溫高蒸汽分壓下吸附（工作） ；在較高溫度，低蒸汽分壓下解析（再生） ，即吸附劑在吸附過程中吸附的水分，在再生過程中依靠高品質再生氣（乾燥空氣加熱）的熱擴散和低分壓兩種機理的共同作用而得以徹底清除。
  20. Molecular diffusion induced by temperature is thermal diffusion, and that from an external field is forced diffusion

    由溫度引起的分子擴散稱為熱擴散，由外場力引起的擴散稱為強制擴散。
分享友人
分享到 Line

分享到臉書