熱氣管道 的英文怎麼說

中文拼音 [guǎndào]
熱氣管道 英文
hot-gas duct
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : Ⅰ名詞1 (管子) pipe; tube 2 (吹奏的樂器) wind musical instrument 3 (形狀似管的電器件) valve;...
  • : Ⅰ名詞(道路) road; way; route; path 2 (水流通過的途徑) channel; course 3 (方向; 方法; 道理) ...
  • 熱氣 : hot-gas熱氣干(燥) desiccation; 熱氣發動機 [機械工程] hot-air engine
  • 管道 : [工業] pipeline; channel; tunnel; piping; canalis; pipe run; duct; conduit; conduit pipe; ducting...
  1. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法,在不考慮燃燒的冷態情況下,研究了風爐燃燒室內的流分佈規律.在此基礎上,比較了2種不同設計方案的流流動特徵,尤其是研究了燃燒器空內阻流板的設置與否對空和煤的流動和混合的影響.結果表明,阻流板的設計對加強空和煤的混合有著極為重要的作用,同時也增加了空的阻力損失,在同樣的工況條件下需要提高系統的總壓力
  2. The paper mainly consider the followings : the performance parameter determination of cryopump, heat load determination and heat transfer of large cryopanel, reasonable distribution of heat load, the condition for construct steady flow in small vertical circle pipeline, balance condition for gas and liquid two - phase flow in the connection pipe between cryopanel and dewar, the safety of cryopump

    文中探討了低溫泵性能參數的確定;大抽速低溫抽面的負載的確定及合理分配;冷凝面上豎直圓內受建立穩定流動的條件;冷凝面與杜瓦間的連接液「雙相流動」的平衡條件;低溫泵系統運行的安全問題。
  3. Heated air is forced into the upper tier of ducts.

    流被送入上面的一排
  4. Wearproof porcelain plate developed by this factory can be used as inside lining plate, coal delivery pipework, bin, bunker, separation port, wind pipe bend, exhauster, inner pipe of mill fan, air preheater, air fule and various dedust equipment for antifriction. besides, it can extend the service life of equipment

    耐磨瓷板系是我廠自行研製的適用於磨煤機內襯板,輸煤、料倉、料斗、粗、細粉分離口、一、二次風彎頭、引風機、排粉機內殼、空器、尾部煙等以及各類除塵系統設備的防磨抗蝕、延長設備的使用壽命。
  5. Construction ministry " housing project quality guarantees method " made lowest guarantee to housing project the regulation of deadline : among them 1, foundation foundation project and project of main body construction, to design the reasonable use fixed number of year of this project that the file sets ; 2, the waterproof project, toilet that has waterproof demand, room mixes the building outside of metope prevent leakage, for 5 years ; 3, heat addition and supply cold system, for 2 heating period, offer cold period ; 4, electric cop, to catchment conduit, equipment installation is 2 years ; 5, decorate a project to be 2 years

    建設部《房屋建築工程質量保修辦法》對房屋建築工程作了最低保修期限的規定:其中1 、地基基礎工程和主體結構工程,為設計文件規定的該工程的合理使用年限; 2 、房屋防水工程、有防水要求的衛生間、房間和外墻面的防滲漏,為5年; 3 、供與供冷系統,為2個採暖期、供冷期; 4 、電線、給排水、設備安裝為2年; 5 、裝修工程為2年。
  6. Measures should also be taken to provide protection from heat effects of steam or hot - water service pipes or both

    還應採取措施防止蒸和(或)的發影響。
  7. Well hidden by the winglet / chimney combination, they dramatically improve hot - air extraction from the sidepods, allowing the engineers to lower the rear section of the car, including the exhaust

    它們被很好地隱藏在小翼/風組合部件的下面,可以極大地改善吸取來自於側箱的,讓工程師們可以降低賽車的尾部,包括排
  8. Air - heating systems circulate air through ducts to and from an air heating collector ( figure 1 )

    系統使空循環,通過通往或是通出空收集器的(見圖一) 。
  9. Plastics piping systems. thermoplastics piping systems for soil and waste discharge. test method for airtightness of joints

    塑料系統.污物和廢料排出用系統.接縫密性的試驗方法
  10. Plastics piping systems - thermoplastics piping systems for soil and waste discharge - test method for airtightness of joints ; german version en 1054 : 1995

    塑料系統.建築物排污系統.連接件密性
  11. For long - term protection of heated pipelines, exhaust pipes, smoke stacks and other heated surfaces up to 550 - 600

    長期保護加、排、煙囪及其它溫度可高達550 - 600的受面。
  12. Study on calculation of compound heat transfer in air layer of steam heating pipeline

    蒸汽層復合傳計算的研究
  13. For manufacture water cooling panels, coal - saving devices, reheaters, superheaters and steam pipelines of boilers

    用於鍋爐水冷壁、省煤器、再器、過器和蒸的製造。
  14. Pneumatic fluid power - push - in connectors for thermoplastic tubes

    壓傳動.用推入式連接器
  15. Plastics piping systems - thermoplastics piping systems for soil and waste discharge - test method for airtightness of joints

    塑料系統.建築物內糞水和污水排放下水系統.連接件的密性試驗方法
  16. Some popularly concerned hot problems and fast developed techniques in present nondestructive testing field were introduced, such as on - line monitoring for pipe laying, gas pipeline and embedding pipes, inspection for the adhesive coating of composite material, imaging techniques and signal processing

    摘要介紹當前無損檢測領域幾項快速發展的並受人普遍關注的點問題和技術,如輸油、輸和地下網的在線監測、復合材料粘接層的檢測、成像技術以及信號處理。
  17. Test method for thermal performance of cooling - air duct sections, using a calibrated hot box

    用校驗盒法測量冷段的特性的試驗方法
  18. Gas unit heaters and gas - fired duct furnaces same as cga 2. 6

    體裝置加器和燃
  19. When a buried pipeline goes through permafrost zone, thermal action between medium in pipeline and permafrost occurs and causes the frozen earth thawing, so the thaw settlement forms around the pipeline

    摘要埋地油通過永凍土地帶時,由於內介質與周圍的凍土發生了力作用,使冰土解凍,在周圍形成融化圈。
  20. 2 3. installation and maintenance of gas - fired ducted air heaters of rated input not exceeding 70 kw net 2nd and 3rd family gases - specification

    額定輸入凈值不超過70kw的燃式空器的安裝和維修
分享友人