熱流動率 的英文怎麼說

中文拼音 [liúdòng]
熱流動率 英文
rate of heat flow
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : 率名詞(比值) rate; ratio; proportion
  • 流動率 : flow rate
  • 流動 : 1. (液體或氣體移動) flow; run; circulate 2. (經常變換位置) going from place to place; on the move; mobile
  1. The move came after china announced on may 18 hikes of benchmark interest rates and bank reserve requirement as well as widening yuan floating range against the u. s. dollar, in a bid to curb excessive liquidity and cool the overheated economy

    這是國家繼5月18日宣布提高基準利和銀行存儲利以及放寬對美元的浮范圍后所推出的新一項舉措,旨在控制性過剩以及給過的經濟降溫。
  2. A transfer model is established, which can be used to study the interaction between the land surface physical processes of inhomogeneous region and the structure of atmosphere boundary - layer over urban and rural terrains. the model has simulated surface heat flux, surface temperature, temperature profiles, height of mixture layer and so on. and the differences between urban area, suburban area and rural area have been compared. this model mainly depends on the parameters below : surface albedo, surface roughness coefficient, moisture available coefficient of soil, thermal capacity and thermal diffusion coefficient of errain, cloudage. the result shows that this model can simulate the structure and eigenvalues of atmosphere boundary layer and their changes in a day. parameters used in this model aim at beijing city, and the time is at the beginning of september. to other cities, or other time, the parameters should be adjusted accordingly. in addition, being adjusted, the model can also be used for other homogeneous and inhomogeneous terrains

    模式主要依賴于以下參數和物理量:地面反照下墊面粗糙度土壤的可含水量下墊面的容量和擴散系數雲量等參數。結果表明,本模式能合理地模擬不同地表量平衡地表氣溫混合層高度湍交換系數湍能位溫廓線等,以及它們的日變化。該模式所取參數主要針對北京市,時間為九月初,對于其他城市,參數應作相應的調整。
  3. The investigation on the evaporation heat transfer characteristics in a horizontal micro - fin tube for r290 - 3gs mixture shows : a ) the average evaporation heat transfer coefficient of the mixture increase with the increasing of the mass flux

    R290含油混合物在水平微肋管內沸騰換特性的實驗研究表明: a )隨著質量的增加,含油混合物微肋管內的沸騰平均換系數增加。
  4. Coal - water slurry is a new type of clean fuel as a replacement for oil. this paper introduces the tests of maoming no. 2 oil - fired 220 t / h utility boiler being retrofitted to fire coal - water slurry, including slagging tendency, heat transfer performances and pollutant emissions. firstly the k - ? two - equation turbulence model is used in numerical simulation for the side - air burner, compared with the practical measures and tests, good accordance achives

    水煤漿是一種低污染、高效性強的代油新型清潔燃料,本文針對廣東省茂名電廠2 #油爐改燒水煤漿示範工程,對鍋爐改造后的結渣特性、爐內傳特性和污染物的排放特性進行了試驗研究。
  5. The rate of heat flow between any two points increases with difference of temperature.

    任何兩點間的則隨溫差的加大而增加。
  6. Comparing with internal heating type fluidized bed, vibration fluidized bed, which get the material to fluidized state through mechanical vibration, can improve thermal utilization factor, quality and reduce steam and power consumption, and one time investment while keeping all advantages of internal heating type fluidized bed

    化床是一種利用機械的振,使物料達到化狀態,它在保留內化床乾燥器優點的基礎上,在利用,產品質量,降低蒸汽及電力消耗,設備一次性投資低等方面均較內化床有較大提高。
  7. This conversation runs through my mind as the five men and women in their twenties sit smiling opposite me, claiming that they love their jobs, as do some of the positive facts dished out by their two managers and public relations executive, such as the centre ' s below - average absence and employee turnover rates rates that can be as high as 30 per cent and 100 per cent respectively in the industry

    當那5名20來歲的男女員工微笑著坐在我對面,表示他們如何愛這份工作時,上述對話在我腦海中掠過,兩位經理和公關主管擺出的一些正面事實也在我腦中掠過,例如中心低於平均數的缺勤和員工,在這個行業中,這兩個指標分別可高達30 %和100 % 。
  8. 08. 03 test method for flow rates for poly vinyl chloride and rheologically unstable thermoplastics

    聚氯乙烯及變的不穩定塑物質測試方法
  9. Electron type omnipotent testing machine cmt5504, hot to link card appearance xwb - 300a, pulling force testing machine lj1000, melting body flow speed appearance xrz400, simple to prop up roof beam strike testing machine xjj - 50j, etc

    、電子式萬能試驗機cmt5504 、變形維卡儀xwb - 300a 、拉力試驗機lj1000 、熔體儀xrz400 、簡支梁沖擊試驗機xjj - 50j等
  10. Servo control computer system / microcomputer universal testing machines, ozone tester, compression flexometer, computer hdt / vicat tester, digital impact tester, melt flow indexer, moving die rheometer, mooney viscometer, lamination of pvc plastic press tester

    伺服控制電腦系統微電腦式拉力試驗機,耐臭氧機,橡膠壓縮生試驗機,塑料用維卡變形,數位沖擊試驗機,塑膠熔體機,無轉子密閉膜腔硫化儀,門尼黏度試驗機等等。
  11. The relations between the parameters of gas charging and exhausting, heat quantity through the shell of tube ( q ), the length of the tube ( l ), the ratio of gas charging time to gas exhausting time ( ), the frequency of the jet flow ( f ), the ratio of the expansion ( ), the nature of thermal separator and the unsteady flow in the tube were established

    建立了進、排氣參數、管壁散量( q ) 、管長( l ) 、充、排氣時間比( ) 、射( f ) 、膨脹比( )等參數與分離機性能及管內非定常的關系,並分析了有關因素對分離機性能的影響。
  12. Through analyzing the effect of temperature and nitrogen on crude oil viscosity the influences of different nitrogen injection volume and injection modes on steam displacement are contrasted, the mechanism of nitrogen - assisted steam stimulation is clarified, which includes : heat carrying capacity is raised, the saturation of remaining oil is reduced after nitrogen - assisted injection is made ; crude oil flow is enhanced because of nitrogen compression and dispersion and the change of oil flow shape ; water back - production rate is improved by expanding the steam sweep volume and compensating in - situ energy ; steam distillation effect is enhanced

    通過分析溫度、氮氣對原油粘度的影響,對比不同注氮量、不同注入方式等對蒸汽驅油效果的影響,弄清了氮氣輔助蒸汽增產的機理主要表現在:氮氣輔助后增加攜能力,降低殘余油飽和度,氮氣的壓縮膨脹作用分散和改變了原油形態,增強了原油性;擴大蒸汽的波及體積,補充地層能量,提高回採水,強化蒸汽蒸餾效應。
  13. As a new type of energy - saving equipment, the tubular heat exchanger with longitudinal flow of the shellside fluid ( thelfsf ) has many remarkable advantages. it betters anti - vibration and anti - smudge performance, enhances heat transfer efficiency, and decreases the shellside pressure loss. it also prolongs service lifetime, reduces the weight and saves material

    新型縱殼程換設備作為一種新一代節能降耗設備,具有優良的防體誘導振性能、傳性能好、傳高、阻力小、抗結垢能力強、重量輕等優點,是鄭州大學「能工程研究中心」專利產品,為了加快該設備的推廣, 「中心」研發了hecad軟體系統,實現了新型換設備工藝設計、機械設計、零部件,圖及總裝圖繪制一體的cad軟體化。
  14. Much works has been distributed to the development of a vacuum system to simulate the outer space and a measurement system to test the arcjet performance. ignition experiments in various operational modes have been done with argon as propellant. macroscopical working parameters including thrust, mass flow rate, voltage, current, inlet pressure and vacuity are obtained by the test measurement system and actual performance parameters including specific impulse, thrust efficiency, ratio of thrust and power and ratio of power and mass flow are calculated

    以氬氣作為推進劑,在不同工況下進行點火實驗,測量獲得了其工作推力、電弧電壓和電、推進劑和弧室壓力等宏觀參數,得到了不同實驗條件下其工作的實際比沖、推力效、推力/功比以及比功等性能參數,分析了推進劑質量、電弧功、電弧加機電弧室結構尺寸等因素對其性能的影響,為數值模擬研究和實際的低功電弧加機優化設計及研製提供了實驗基礎。
  15. The influence of various waterpower and configuration parameters on heat transfer is analysed and the rules of convective heat transfer coefficient and the ratio of heat transfer enhancement with mass flux are obtained. at the same time, we gain important results as below : as for resonance chamber with certain configuration, self - oscillation can be generated under suitable configuration and waterpower parameters. for the same configuration resonance chamber, the intensity of the self - oscillation is changed by the waterpower parameters

    量及壓差降低至一定程度時,共振腔還可能削弱換;加的提高會增加體(水)的溫度,體的粘度會隨著降低,這會減少對體脈的阻礙,使脈衰減得更慢,而脈幅度的增加會增強換,故加對有脈的對是有影響的;自振腔產生的體脈是自振腔固有頻或其整數倍,體脈過高或過低都不利於對,存在一有利於強化換的頻范圍。
  16. According to the physical model, a mathematical model and computational method were proposed. an axially symmetric transient thermal conduction equation was put forward, which included material pyrolysis, pyrolysis gas flow and chemical reaction in charred layer. chemical reaction was controlled by chemical dynamics, and the reaction rate was computed using arrhenious equation

    針對物理模型提出了相應的數學模型和數值計算方法,在材料內部建立了二維軸對稱的非穩態導控制方程,其中加入了材料解、解氣體以及炭化層內的化學反應等因素的影響,化學反應由化學力學控制,通過arrhenius公式確定其反應速
  17. The author found that the stable heat source presumption or the t2 design fire is also not agree with the experimental data. the simulation of fire in an atrium has shown that the new model is more accurate to predict the fire scenarios than any other models that include a general mathematical model of fires

    該模型充分考慮了火區燃燒與蔓延情況對煙氣數值模擬的影響,從而可以更加準確地反映出火源釋的變化等因素的影響,改善了中庭火災煙氣數值模擬的精度與可靠性。
  18. The result of analysis shows that the convective heat flux has main effect on fuel pyrolyzing and vaporizing, the liquid layer of pe fuel can increase the regression rate but also can cause unstable burning. 4

    研究結果表明:對是引起燃料解氣化的主要因素, pe熔化產生的液體層提高了燃料解退移速,但液體層厚度增加到一定程度時,對發機工作穩定性有負面影響。
  19. Analysis on flow resistance effects on stirling heat engine power and efficiency

    阻力損失對斯特林機功和效影響的理論分析
  20. Standard test method for flow rates for poly vinyl chloride with molecular structural implications

    聚氯乙烯和變的不穩定塑性材料的測試試驗方法
分享友人