熱穩定試驗 的英文怎麼說

中文拼音 [rèwěndìngshìyàn]
熱穩定試驗 英文
heat stabilization test
  • 穩 : 形容詞1 （穩定; 穩當） steady; stable; firm 2 （穩重） steady; staid; sedate 3 （穩妥） sure; rel...
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 穩定 : 1 （使穩定） stabilize; steady 2 （穩固安定） stable; steady 3 （物質的性能不易改變的作用） stabi...
  • 試驗 : trial; experiment; test
  1. Test method for thermal stability testing of gallium arsenide wafers

    砷化鎵晶片熱穩定性的試驗方法
  2. Methods of testing plastics - thermal properties - determination of the thermal stability of polyvinyl chloride by the congo red method

    塑料試驗方法.第1部分:熱性能.試驗方法130a :剛果紅法測定聚氯乙烯熱穩定性
  3. Through the experimental research, we think : the technological capacity of fiberglass asphalt macadam if weaker than asphalt macadam, however, if use elasticized capacity to solve blending technological problem. adjust the breed of fiber silk, extend its diameter, its paving capacity is still worth exploring, asphalt - rubber macadam structure lager have good deformed - become capacity and crazed - resistance capacity, small gap rate. good water - resistance capacity, good hot - stability and simple construction technology. therefore. pitch rubber spall is a good cover material which is suitable for the second class or lower whose asphalt pavement has split open because of fatigue. and is the good structural measure of preventing half - rigidity grass - roots unit shrink - rift reflecting. pave a thin layer of pitch rubber spall between asphalt - type pavement layer and half - rigidity basic level, although the cost of building is higher than paving togongbu in the middle, the construction technology, crazing - resistance and water - resistance are better than togongbu, not only could reduce greatly the reflex of half - rigidity grass - roots unit material, long then the use lifespan of pavement, but also it is possible to reduce suitably the thickness of asphalt mixture layer, though the cast of building in the early days becomes more, in the long - term opinion, it have fully important technological and economical significance

    通過試驗研究認為：玻璃纖維瀝青碎石的技術性能不如瀝青碎石好，但路用彈性性能較好，如能解決拌和工藝問題，調整纖維絲的品種，增大其直徑，其路用性能仍值得探討，瀝青橡膠碎石結構層具有變形性能和抗裂性能良好，空隙率小，防水性能好，熱穩定性較好，施工工藝簡單的特點，因此，瀝青橡膠碎石是二級及二級以下公路因疲勞而開裂的瀝青路面的良好罩面材料，也是防止半剛性基層收縮裂縫反射的良好結構措施，在瀝青類路面面層和半剛性基層之間夾鋪瀝青橡膠碎石薄層，雖然造價比夾鋪土工布高，但其施工工藝，抗裂性能和防水性能均優于土工布，不僅可以大大減少半剛性基層材料的反射裂縫，延長路面使用壽命，而且可能適當減薄瀝青混合料面層的厚度，雖然初期造價有所增加，從長遠來看，具有十分重要的技術和經濟意義。
  4. Uv & heat * * 80 % tensile strength retention after 350 hours stabilised weatherometer exposure, masterbatch in both tapes and coating

    紫外線和熱穩定性在老化試驗機中試驗350小時后保留80 %的拉伸強度
  5. The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine

    用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌：用xrd進行原料物相分析，及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度；用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性；用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化；用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試；採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定；用萊次偏光顯微鏡（ pm ）測試固體潤滑劑的硬度；用材料試驗機測試固體潤滑劑的抗壓強度等。
  6. Insulating and sheathing materials of electric cables. common test methods. part 3 : methods specific to pvc compounds. section 2 : loss of mass test. thermal stability test

    電纜絕緣和護套材料.通用試驗方法.第3部分:聚氯乙烯化合物專用方法.第2節:質量損耗試驗.熱穩定性試驗
  7. Railway rolling stock. " extreme pressure " oils for mechanical transmissions of motive power units. part 3 : high thermal stability oil. endurance test method on fixed post machine

    鐵路車輛.原動力機械傳輸用耐"極端壓力"油.第3部分:高熱穩定性油.固定柱機械的耐久性試驗
  8. Methods for testing pigments for paints - comparison of heat stability

    塗料用顏料試驗方法.第c8部分:熱穩定性比對
  9. Standard test method for measurement of thermal stability of aviation turbine fuels under turbulent flow conditions hirets method 1, 2

    在快速流動條件下測定飛行器渦輪機燃料的熱穩定性的標準試驗方法
  10. Test methods for pigments - part 10 : heat stability using a stoving medium

    顏料試驗方法.第10部分:用烘乾法測定熱穩定性
  11. Test method for oxidation and thermal stability characteristics of gear oils using universal glassware

    用通用的玻璃器皿測定齒輪油氧化和熱穩定特性的試驗方法
  12. Standard test method for oxidation and thermal stability characteristics of gear oils using universal glassware

    使用通用玻璃器皿測定齒輪油氧化和熱穩定特性的標準試驗方法
  13. Test method for thermal stability of organic heat transfer fluids

    熱傳送有機流體的熱穩定性試驗方法
  14. According to experiments, lab6, with high conductivity, good heat stability and chemical stability, low work function, and active cathode appearance, has become an ideal material for field emission array cathodes

    經試驗證明，六硼化鑭（ lab6 ）具有高導電率和良好的熱穩定性、化學穩定性、低功函數以及活性陰極表面，因此從理論上成為了場發射陰極的理想材料。
  15. Standard practice for oven heat stability of poly vinyl chloride compositions

    聚氯乙烯復合物的試驗爐加熱穩定性標準規程
  16. Standard test method for heat stability of hot - melt adhesives

    熱熔膠粘劑的熱穩定性的標準試驗方法
  17. Test methods of rare earth three - band phosphors for fluorescent lamps - determination of thermostability

    燈用稀土三基色熒光粉試驗方法熱穩定性測定
  18. Testing of mineral oils and related products - determination of thermostability of unused heat transfer fluids

    礦物油和相關產品的試驗.未使用的傳熱流體的熱穩定性
  19. Methods of test for adhesives - determination of heat stability of hot melt adhesives in the application equipment

    粘合劑試驗方法.第h1部分:應用設備中熱熔粘合劑熱穩定性測定
  20. Thermal stability test

    熱穩定試驗
分享友人
分享到 Line

分享到臉書