熱裂紋試驗 的英文怎麼說

中文拼音 [rèlièwénshìyàn]
熱裂紋試驗 英文
hot crack test
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 紋 : 名詞（花紋; 紋縷兒） lines; veins; grain
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 試驗 : trial; experiment; test
  1. Several materials with large coefficient of expansion were selected to make packaging components, and it was found that the packaging materials have good temperature sensitivity and compatibility with optical fibers. experimental accuracy and repetition of fbg temperature sensitivity and compensation were discussed. have selected several materials which has bigger coefficient of expansion to do packaging components, have made many temperature experiments, there have not flaws, such as aging, crackle, absciss layer, packaging materials have good temperature sensitivity and compatibility with optical fiber ; have designed the simple and practical packaging components, have performed a serials of experiments about accuracy and repetition of fbg wave - length, have obtained the first step conclusion ; have analyzed the result and made comparison between the result of different experiment, have summarized the best packaging effect and several rules to reduce mistskes

    本文所做的主要工作包括以下幾個內容：一、選取了常見的熱膨脹系數大的材料製作封裝元件，經過多次一80到80反復測試，封裝元件沒有出現老化開裂、封裝裂紋、空洞、離層等缺陷，封裝材料具有良好的溫敏穩定性及復用性，與光纖相容性較好；二、對光纖光柵進行簡單、實用的封裝處理，就封裝效果的優劣性、波長測量的準確度、重復性和封裝時產生的波長損失等方面進行了一系列的實驗，得出了初步的結論；三、對溫敏和溫度補償式封裝的實驗數據進行了詳細的分析和對比，從數字上對溫變過程中光纖光柵中心波長的改變及溫變曲線進行了定量的分析，在大量實驗數據分析結果的基礎上，總結出哪種材料封裝效果更好，以及如何有效的減小實驗誤差。
  2. With the very low water to cement ratio, rpc has ultra - high strength high ductility and low permeability. in this paper, the compressive strength of rpc can reach to a high point with the number approximately 135mpa. as illustrated from the study results, we can approve some fundamental conclusions : there are big effects on rpc with deferent kinds and properties of raw materials and deferent curing conditions ; stress - strain curve shows the process of destroy with rpc samples ; x - ray diffraction analysis indicates that heat treatment at temperatures 90 accelerate the hydration of rpc sharply, therefore, mechanical and microstructural properties of rpc are highly dependent on heat treatment ; it is believed that rpc materials have excellent resistance to chloride permeability ; during the heat treatment, the shrinkage of rpc developed quickly because of chemical reactions ; the rpc with slag mostly has the advantage of rpc without slag about resistance to solutions corrosion

    研究結果表明：通過對rpc各組分摻量變化的研究，可以找到rpc的最優配合比；試件成型后的熱養護制度對rpc的性能影響巨大； rpc的抗壓應力?應變曲線可以反映出試件受破壞時微裂紋的擴展情況，剛纖維的摻入可以大幅改善rpc的韌性； rpc在成型后存在較大的收縮，而其中的化學收縮要遠遠大於乾燥收縮； rpc具有很強的抗氯離子滲透性能，漿體的密實度很高；通過x射線衍射實驗，可以發現rpc的膠凝體中ch晶體已經幾乎不存在，膠凝體主要由c - s - h凝膠和未水化水泥顆粒組成；在抗溶液侵蝕的實驗中，摻礦渣rpc的抗溶液侵蝕性能在絕大多數情況下要好於不摻礦渣試件，酸、堿溶液和浙江工業大學碩士學位論文摘要一些鹽溶液都會對rpc的結構產生侵蝕作用，但是機理各有不同。
  3. Methods of test for rubber and plastics hoses and hose assemblies - physical tests - determination of fracture resistance of rigid polymer helical reinforcement in thermoplastics hoses

    橡膠和塑料軟管組件的試驗方法.第103部分:物理試驗.第7節:熱塑軟管用剛性聚合物螺紋鋼筋耐斷裂性測定
  4. Destructive tests on welds in metallic materials - hot cracking tests for weldments - arc welding processes - part 3 : externally loaded test iso tr 17641 - 3 : 2004 ; german translation of cen iso tr 17641 - 3 : 2004

    金屬材料焊接的有損檢驗.焊件的熱裂紋試驗.弧焊過程
  5. Method of controlled thermal severity weld cracking test

    受控的熱嚴酷焊接裂紋試驗方法
  6. This segregation behavior of sn accords with the mechanism of non - equilibrium segregation. it can be obtained through the theoretical calculations that the critical time of sn non - equilibrium segregation is 124 seconds at 750 and the critical cooling rate is 8 / s when cooling from 1320. it is suggested that controlling the cooling rate during continuous casting to avoid the critical cooling rate ( 8 / s ) and avoiding high stress near the trough temperature ( 750 ) may control the form

    通過研究殘留元素sn的偏聚機制及其對o . 15wt . % c鋼熱塑性的影響，對試驗鋼進行脆性預測:建議在該鋼的連鑄過程中彎道矯直溫度盡量避開塑性谷底溫度750 ，二冷區的冷速盡量避開臨界冷卻速率8 / s ，從而可以減少該低碳鋼連鑄坯表面裂紋和橫向裂紋，提高其成材率。
  7. Ir - ta - ti metal oxide coated titanium anodes of variable composition were prepared by thermal decomposition. their micro morphorogies and electrochemical properties were characterized by scanning electron microscope, open circuit potential, cyclic voltammetry, consumption rate measurements and accelerated life test. the sem results indicated that all coatings were of a porous and cracked - mud microstructure influenced greatly by the composition of coatings. the electrochemical measurements showed that the ir - ta - ti ternary oxide - coated anodes exhibited excellent electrochemical activity and electrochemical stability in both acidic media and seawater which were affected by the composition and microstructure of the coatings. owing to good corrosion resistance and low consumption rate in seawater, metal oxde coated anodes belong to insoluble material, and can be potentially applid in impressed current cathodic protection systems as an anode

    採用熱分解方法在鈦基體上制備銥鉭鈦金屬氧化物陽極，用掃描電鏡對陽極塗層顯微形貌進行分析，通過強化電解壽命試驗、開路電位測試、消耗率試驗及循環伏安曲線研究了金屬氧化物陽極的電化學性能. sem分析結果表明銥鉭鈦金屬氧化物陽極塗層呈現多孔多裂紋形貌結構.隨陽極塗層組成不同，塗層顯微形貌表現出很大差異，這種差異直接影響陽極電化學性能.電化學性能試驗結果表明銥鉭鈦金屬氧化物陽極在酸性介質和海水中具有良好的電化學穩定性和電化學活性.此外，銥鉭鈦金屬氧化物陽極在海水中的消耗率很低，屬于不溶性的陽極材料，作為外加電流陰極保護用輔助陽極具有廣泛的應用前景
  8. Testing method of flex cracking and crack growth for rubber, vulcanized or thermoplastic de mattia

    硫化的或熱塑性橡膠曲撓龜裂和裂紋增長的試驗方法
分享友人
分享到 Line

分享到臉書