燃料流量 的英文怎麼說

中文拼音 [ránliàoliúliáng]
燃料流量 英文
fuel flow
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 燃料 : fuel
  • 流量 : rate of flow; flow; runoff; discharge; throughput; （flow） rate; quantity （of flow）; flux
  1. Afc airflow controlled fuel injection

    空氣流量控制燃料噴射
  2. Test method for the determination of the aromatic content and polynuclear of diesel fuels and aviation turbine fuels by supercritical fluid chromatography

    超臨界流體色譜法測定柴油燃料和航空燃氣渦輪燃料中芳香烴含量和多核芳香烴的試驗方法
  3. Standard test method for determination of aromatic content and polynuclear aromatic content of diesel fuels and aviation turbine fuels by supercritical fluid chromatography

    用超臨界流體色譜法測定柴油和航空渦輪燃料中芳香烴含量和多核芳香烴含量的標準試驗方法
  4. Tga. insulating and sheathing materials of electric and optical cables - common test methods - part 4 - 1 : methods specific to polyethylene and polypropylene compounds - resistance to environmental stress cracking - measurement of the melt flow index - carbon black and or mineral filler content measurement in polyethylene by direct combustion - measurement of carbon black content by termogravimetric analysis - assessment of carbon black dispersion in polyethylene using a microscope

    電纜和光纜的絕緣和護套材料.通用試驗方法.第4 - 1部分:聚乙烯和聚丙烯化合物專用方法.抗環境應力致裂.熔化流動指數測量.通過直接燃燒測量聚乙烯中炭黑和或礦物填料含量.通過熱重分析法
  5. The sumiyaki tatsujin natural style charcoal kiln series is an environmentally friendly charcoal kiln that can be fired by a small amount of wood without the use of fossil fuels

    自然流醋炭燒窯「炭燒高手」系列無需使用化石燃料，只需少量木材和一個可以達到燃點的環境即可實現無污染燒炭。
  6. 3. on boiler retrofit, the calculation of fuel burning, the heat calculation of boiler inside structure and convection section, and the design of structure parameter of feed water heat exchanger are made. the flue gas channels " resistance calculation and the boiler strength verifying are also carried out. replacement of water cooling wall improves heat exchanging and decreases loss of heat radiant

    對鍋爐本體進行了燃料燃燒計算、爐膛結構熱力計算、對流受熱面結構熱力計算、鍋爐給水加熱器結構參數設計、煙道阻力計算及鍋爐元件強度校核等；改進了水冷壁布置使換熱效果更好，減少輻射換熱損失；改進對流段結構，更充分的利用爐膛出口煙氣余熱，提高熱效率；並且進行了煙氣阻力計算、熱效率計算和能量平衡測試，對改進后的稠油燃料和改進前進行了對比，燃燒狀況和熱效率有明顯改善。
  7. Ceramic fuel cells are electrochemical devices that directly convert fuels such as gasified coal or natural gas into electricity without the limitation of the carnot cycle ( an ideal thermodynamic cycle in which heat is taken onto a working fluid at a constant upper temperature and rejected at a constant lower temperature )

    陶瓷燃料電池是一種電氣化學裝置，能直接將煤氣、天然氣等燃料直接轉化為電能而不會受到卡諾循環（一種理想的熱力循環，熱量在恆定高溫下轉化成工作流體，在恆定低溫下被釋放）的限制。
  8. And study the quantified methodology of self - restraint the source, the soil erosion reducing, the soil nutrient prediction and reservoir mud alluvial prediction, and applies the model count the water conservation benefit in lingchuan county magedang experimental unit in shanxi province

    並分別探討了涵養水源、減少土壤侵蝕、減少土壤養分流失及減少水庫泥沙淤積的效益量化計算方法，以山西省陵川縣馬屹當小水電代燃料試點工程為例進行了水土保持效益的實例計算。
  9. Authorized limits for normalized releases of radioactive effltuents from nuclear fuel cycle

    核燃料循環放射性流出物歸一化排放量管理限值
  10. The fuel cells models are presented in chapter 3. based on the balance conditions in fuel cells stack, the dynamic performance is analyzed. the dynamic model is developed with a set of correlation equations of voltage, fuel utilization, current density and other variables involved in the operating course, which are some partial differential equations with variable coefficients

    第三章以熔融碳酸鹽燃料電池為例，以數值分析的方法，根據mcfc電堆發電過程中物質與電量平衡，分析了電堆的內部動態特性，就輸出電壓與燃料氣體利用率和電流密度等相關量建立了由一組變系數偏微分方程和積分方程描述的數學模型。
  11. Then, a three - dimensional, comprehensive, steady - state mathematical model is described to investigate the fluid flow, heat transfer, species transport and electrochemical reaction in the pem fuel cells

    然後，發展了一個用於研究質子交換膜燃料電池特性的三維綜合的數學模型，模型同時考慮了流體流動、熱量傳遞、電荷傳遞、多組分傳遞和電化學動力學。
  12. Studying the heat - mass transfer and multi - spices electric - chemical reaction, a dynamic temperature model was deduced for molten - carbonate fuel cell stack. the thermal radiation, shift reaction, and the change of gas spices were considered in this model. establishing momentum equation, the paper has developed a 3d temperature and flow fields model for mcfc stack based on cfd technique

    建立了熔融碳酸鹽燃料電池堆內部單體的暫態溫度模型，並考慮了電堆的輻射換熱、轉換反應、反應氣體組分變化對溫度場的影響；根據mcfc的微分控制方程組，考慮氣體組分的熱力學性質及動量變化的影響，利用數值分析方法求解熔融碳酸鹽燃料電池堆的三維流場與溫度場，分析了各作用因素對熔融碳酸鹽燃料電池堆溫度分佈的影響機制。
  13. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  14. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  15. Based on simulation, 2 - dimension fuzzy control system was researched, which was used to control two correlative variables of circulating fluidized bed boiler " s combustion control system

    本論文在模擬的基礎上，研究用二維模糊控制實現流化床鍋爐燃料量控制系統的兩關聯變量的控制。
  16. The heat balance equations on incineration of organic liquid waste in fluidized - bed incinerator with coal as auxiliary fuel is established in this paper. the relations between the feeding rate of auxiliary fuel and the lhv of liquid waste, the incineration temperature, and the preheated combustion air temperature have been discussed. this paper also discussed the relation between the lhv of liquid waste and combustion air temperature as the auxiliary fuel is not necessary, and provides the theoretical foundation for the design and operation on fluidized - bed incinerator

    建立了以煤為輔助燃料的，有機廢液在流化床中焚燒的熱平衡方程，求得輔助燃料耗量與各影響因素的計算式，得出輔助燃料耗量與廢液中可燃基的低位發熱值、密相區燃燒溫度、熱風溫度之間的關系曲線，以及不需要輔助燃料時，有機廢液熱值與熱風溫度之間的關系，為流化床焚燒爐的設計與運行提供了理論依據。
  17. In order to realize the optimum control of the temperature in the billet reheating furnace, the fuzzy control and expert control of the fuel flow, the optimization extreme of the air / fuel ratio, and the fuzzy pi control of the pressures in furnace are discussed

    摘要為了實現鋼坯加熱爐爐溫的優化控制，研究了燃料流量的模糊專家控制，空燃比的極值尋優以及爐膛壓力的模糊pi控制策略。
  18. According to the definition and expression of the thrust, as well as the condition derived from them, a method of solid rocket ramjet thrust determination and its program are provided on the basis of engine ground simulation test

    本文以西北工業大學固體火箭沖壓發動機直連式試車臺為研究對象，探討固體火箭沖壓發動機地面試驗技術。首先，從推力的定義出發，建立了試驗中來流空氣流量、燃料流量與固體火箭沖壓發動機推力之關系。
  19. Characters including : fuel atomization device replaced by gas sprayer, gas supply controlled by gas flux valve ; separate fuel supply from combustion - supporting air, regulate air supply through changing the electioneering voltage to make the fully burning and improve efficiency and reduce fuel consume ; arts and crafts are simple, the modification of the oil heater ' s configuration is little and the heating power is not below the oil heater ' s level ; because of falling the voltage of electioneering, greatly descend the noise of the sample machine compared with the original

    其特點是：以燃氣噴頭替代原機燃油霧化裝置；以燃氣流量控制閥控制燃氣的供給；燃氣的供給與助燃空氣的供給相分離；通過改變主電機的電壓，調整空氣的供給量，使燃燒更加充分完全，並進一步提高了熱效率，降低了燃料消耗；工藝簡單，對原機型改動較小；樣機的加熱功率不小於原機型水平；此外，由於主電機電壓的降低，使樣機的整機噪聲比原機大大下降。
  20. Ffcs fuel flow control system

    燃料流量控制裝置
分享友人
分享到 Line

分享到臉書