燃燒比耗 的英文怎麼說

中文拼音 [ránshāobǐhào]
燃燒比耗 英文
specific fuel comsumption
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 耗 : Ⅰ動1 （減損; 消耗） consume; cost 2 [方言] （拖延） waste time; dawdle Ⅱ名詞1 （壞的音信或消息） ...
  • 燃燒 : （物質劇烈氧化而發光、發熱; 燒） burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  1. In recent years at iron - making plant of pangang, the coke ratio of pig iron has reduced evidently by insisting on “ burden preparation ” course, improving quality of sinter, raising wind temperature, increasing rich oxygen quantity and injecting abundant pulverized coal into bf. the solid fuel consumption of sinter has been decreased greatly through insisting on using high - quality calces, practising high feed sintering, actualizing many techniques in solving key problems. at the same time, the energy source base management has been strengthened, and energy - saving work has made great progress, profits generated by energy - saving have exceeded a hundred million yuan

    近年煉鐵廠通過堅持「精料」方針，改善燒結礦質量，提高風溫，增大富氧，實施大噴煤，使入爐焦比有明顯下降；燒結堅持用好生石灰，推行厚料層燒結，實施多項技術攻關，固體燃耗大幅度下降；同時加強能源基礎管理，節能工作取得長足進步，節能創效益1億元以上。
  2. This paper facous on the micro - computer control of the burning furnace system. taking to meet the requirements of the user ' s as basis, it is designed about computer in hardware and software it brings forward a scheme of intelligent & fuzzy - control based on 8098 single - chip micro - computer to get the best proportion of fuel oil and burning air, to realize the auto - contral of the temperature of flue gas in or out the burning furnace. so the accurate efficiency is received, this can ensure the ahf unit having a high production and low costs and energy

    在控制上以滿足新爐型的設計要求為基礎，進行了微機控制的硬體與軟體開發，提出了採用8098單片機進行模糊智能控制的設計方案，實現了燃料油與燃燒空氣最佳比例控制、燃燒爐出口煙氣溫度控制、燃燒爐進口煙氣溫度控制和安全聯鎖報警控制，提高了燃燒爐出口溫度的控制精度和燃料使用效率，為整個裝置提高產量和降低消耗提供可靠的保證。
  3. For example, distillation6 processes that separate out any dissolved minerals by boiling and condensing water require costly amounts of fuel

    比如，要用燒開然後冷卻的蒸餾方式從水中分離出任何溶解礦物質，也要耗費大量燃料。
  4. High burning heat ratio and low gas consumption. in comparison with traditional electric baker, it saves the power baker plus and power circuit cost, economic and practical

    燃燒熱效率高且耗氣量少。與傳統電烤爐相比，可省去電力增容和配電線路等所需支出，經濟實用。
  5. A new calculation method for optimizing diesel engine performance, called nonlinear regression - mess method, is put forward. in this paper, 25 groups of simulated values are calculated from the diesel engine working model, specific fuel consumption, peak pressure, rate of pressure rise, nox and peak temperature are fitted into explicit function about compression ratio and fuel injection advance angle

    本文利用柴油機工作過程模型，得出25組模擬計算數據，利用非線性回歸將油耗、最大爆發壓力、壓力升高率、 no _ x濃度及最高燃燒溫度擬合成壓縮比和噴油提前角的顯函數，並用網格法進行優化，用c語言編制了優化計算程序，得出最佳的壓縮比和噴油提前角，使其優化匹配。
  6. First, the use producer gas generator may enhance the thermal efficiency, also the coal burning full, may reduce the energy to disappear, with direct coal - burning, may reduce disappears 20 - 40otranslation

    首先，使用煤氣發生爐可以提高效率，且煤燃燒充分，可降低能源消耗，與直接燃煤相比，可降低消耗20 - 40 。
  7. The repeating experiments show this kind of emulsified diesel oil can reduce fuel consumption by at least 10 percent, smoke density and nox emission by more than 40 percent. and the exhaust temperature and the maximum combustion pressure also decrease. la addition, the experiments about emulsified heavy oil and emulsified mixture of heavy oil and diesel oil are done on 1135 diesel engine

    經反復試驗表明該型乳化油與0 ~ #柴油相比平均節油率不低於10 ，主要排放物nox 、碳煙降低40以上，同時排溫和最高燃燒壓力降低，另外，在1135柴油機上進行了乳化重油和乳化重油與柴油混合物的試驗，結果表明燃油耗率和so _ 2排放均顯著降低。
  8. Based on the variables of inlet length, compression ratio, inlet opening phase and the exhaust closing phase, multi - objective optimization was conducted for power, torque, combustion noise and fuel consumption indicators with constraint conditions of fuel consumption rate and the maximum breakout pressure

    以進氣道長度、壓縮比、進氣開啟相位、排氣關閉相位為可變因素；以比油耗、最高爆發壓力為約束條件，針對滿足功率、扭矩、燃燒噪聲和油耗指標進行多目標優化設計。
  9. A new method is put forward on thermodynamics combustion model to make imitating research on egr - a software is made to calculate the amount of no from the gasoline by connecting with the practical condition in our country, starting with thermodynamics and experiment at the same time make a system research to influence by the exhaust gas returning system on the gasoline, such as exhaust gas, fuel economy, and power, finally a new thought is afforded for optimizing all the egr parameter in chapter 6

    第五章採用上述診斷和預測模型對bj492q發動機進行了模擬計算和實驗研究，並探討了點火提前角、殘余廢氣系數、燃空比、壓縮比和火花塞位置對發動機性能的影響。第六章提出了基於熱力學燃燒模型對egr進行數值模擬的方法，系統地研究了車用汽油機加裝egr系統后對排放、油耗、功率的影響，並結合排放標準。提出了egr參數的全局優化的新思路。
  10. High rates of carbohydrate use reduce combustion of fat

    高比例地消耗醣類會減少脂肪的燃燒。
  11. The titanium alloy valve is more superior than ordinary steel valve in lighter, smaller expansion coefficient, improves the tightness in inletting and exhausting, helps in complete combustion, and at the same time reduces noise, friction, oil consumption, vibration, and gas waste

    鈦合金汽門比一般鋼閥材質的產品更輕化、膨脹系數小，于進、排氣時可提升它的氣密動作，幫助完全燃燒，同時減少噪音、摩擦、油耗、震動及廢氣。
  12. Planar laser induced fluorescence ( plif ) and multi - dimensional cfd software was used to study the fuel - air mixing process in traditional combustion chamber and bump combustion chamber, the experimental and simulated result agree well in room condition. the fuel - air mixing process in high pressure and temperature in traditional and bump combustion chamber were compared. the result show that fuel and air can mix more quickly in bump combustion chamber than in traditional combustion chamber, fuel - air mixture in bump combustion chamber is more homogenous than in traditional chamber

    進一步對高溫高壓下傳統燃燒室和bump燃燒室內燃油空氣混合好壞進行了對比研究，提出了衡量燃油與空氣混合好壞的三個指標，發現bump燃燒室內燃油能在更大的體積內與空氣混合， bump燃燒室內燃油比傳統燃燒室內燃油分佈相對更均勻， bump燃燒室內燃油濃度耗散率為傳統燃燒室內燃油耗散率2 . 8倍，能更快與空氣混合。
  13. Characters including : fuel atomization device replaced by gas sprayer, gas supply controlled by gas flux valve ; separate fuel supply from combustion - supporting air, regulate air supply through changing the electioneering voltage to make the fully burning and improve efficiency and reduce fuel consume ; arts and crafts are simple, the modification of the oil heater ' s configuration is little and the heating power is not below the oil heater ' s level ; because of falling the voltage of electioneering, greatly descend the noise of the sample machine compared with the original

    其特點是：以燃氣噴頭替代原機燃油霧化裝置；以燃氣流量控制閥控制燃氣的供給；燃氣的供給與助燃空氣的供給相分離；通過改變主電機的電壓，調整空氣的供給量，使燃燒更加充分完全，並進一步提高了熱效率，降低了燃料消耗；工藝簡單，對原機型改動較小；樣機的加熱功率不小於原機型水平；此外，由於主電機電壓的降低，使樣機的整機噪聲比原機大大下降。
  14. Because the flue gases contain substantial amounts of nitrogen ( the result of burning coal in air, which is about 80 percent nitrogen ), the carbon dioxide would be recovered at low concentration and pressure ? which implies that the co2 would have to be removed from large volumes of gas using processes that are both energy - intensive and expensive

    由於廢氣中絕大部份是氮（這是在空氣中燃燒的結果；空氣本身含有80 %的氮） ，二氧化碳在廢氣中所?濃度和分壓都很低，這也表示移除二氧化碳時，必須處理的是比二氧化碳更大量的廢氣，這樣的處理方式既耗能又昂貴。
  15. E. g., if take food everyday the hot check that rekabi uses up is little 900 calories ( of course this decreases more greatly, just go to the lavatory for computation ), what mean breach of these 900 calories of quantity of heat to want to go up through using up your body then is adipose will make up for, overcome adipose combustion to be able to supply 9 calories of quantity of heat, those 900 calories are about to use up 100 grams adipose

    舉例來說，假如天天進食的熱卡比消耗的熱卡少900卡（當然這減少得比較大，只是為了計算方便） ，那就意味著這900卡熱量缺口要通過消耗你身上的脂肪來彌補，一克脂肪燃燒可以提供9卡熱量，那900卡就要消耗100克脂肪。
  16. Besides, in this paper, the velocity distributes and recirculation areas of two phases are shown, and the differences between simulations and experiments are diminutive. turbulence kinetic energy ( ?, turbulence dissipation rate ( e ), reynolds stress and turbulence intensity are also simulated to reflect turbulence flow

    另外，本文計算了旋流燃燒器內氣固兩相的速度和迴流區的分佈，並和已有的實驗數據進行了比較，同時還計算了湍動能、湍能耗散、雷諾應力和湍流強度等反映湍流的物理量。
分享友人
分享到 Line

分享到臉書