燃燒理論 的英文怎麼說

中文拼音 [ránshāolún]
燃燒理論 英文
burning theory
  • : 動詞1. (燃燒) burn 2. (引火點著) ignite; light
  • : Ⅰ動詞1 (使東西著火) burn 2 (加熱或接觸某些化學藥品、放射性物質等使物體起變化) cook; bake; hea...
  • : Ⅰ名詞1 (物質組織的條紋) texture; grain (in wood skin etc ) 2 (道理;事理) reason; logic; tru...
  • : 論名詞(記錄孔子及其門徒的言行的「論語」) the analects of confucius
  • 燃燒 : (物質劇烈氧化而發光、發熱; 燒) burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  • 理論 : theory
  1. Afterburner systems, designed to operate up to a stoichiometric overall mixture strength, are always fairly close to combustion instability or screech.

    要使加力系統在化學組成量的總混合濃度下還在一直工作,這樣的設計通常都很接近於不穩定或振蕩
  2. T crowe, et al. effect of spin on the internal ballistics of a solid - propellant motor r. aiaa 66 523

    曹泰岳,常顯奇,等.固體火箭發動機過程基礎m .長沙:國防科技大學出版社
  3. C t crowe, et al. effect of spin on the internal ballistics of a solid - propellant motor r. aiaa 66 523

    曹泰岳,常顯奇,等.固體火箭發動機過程基礎m .長沙:國防科技大學出版社
  4. D r greatrix. acceleration - base combustion augmentation modelling for non - cylindrical grain solid rocket motors r. aiaa 95 2876

    曹泰岳,常顯奇,等.固體火箭發動機過程基礎m .長沙:國防科技大學出版社
  5. Because of its extensive application and underdeveloped research level in our country, this paper establish the numerical model of blank cartridge ejecting device, the whole process from blank cartridge burning to eject missile is analyzed by classic interior ballistic theory and gas dynamics. several simulation examples are given, and the effect of different parameter structure on ejecting device is discussed

    鑒于這類系統在我國的廣泛應用與相對滯后的研究水平,本文針對三種類型五種型號的掛彈鉤建立了拋放彈彈射機構的數學物計算模型,用經典內彈道和氣體動力學分析了火藥彈到彈射活塞完全推離懸掛物的整個過程。
  6. The sensitive time lag theory circumvents the problems inherent in the description of unsteady combustion by use of a simplified two-parameter response function.

    敏感時滯用簡化的雙參數響應函數來描述不穩定,從而繞過了某些固有的難點。
  7. Relatively little effort has been expended in this country to applying two-phase detonation theory to the combustion stability problem.

    在把兩相爆震應用於穩定性方面,該國家幾乎沒做過多少工作。
  8. Long - hole and geometrical proportion type of mixing unit is finally adapted in lpg supply system, and power and torque output of lpg engine are improved by increasing compression ratio, and ignition characteristic is tried to adjusted to satisfy engine performance. meantime emission performance and noise level of lpg engine at full - throttle and other various part - throttle operations are tested and compared with former gasoline engine. ( 3 ) it is verified by engine dyno tests that lpg engine has better synthesized performance at aspects of power and torque, fuel economy, as well as emission than former gasoline engine

    選擇了等比例長孔式混合器控制空比;通過提高壓縮比來彌補動力性的損失;以動力性為主控目標,對最大功率點、最大扭矩點、中等轉速、最低轉速點所對應的發動機轉速做了點火特性的調節;通過空比的合控制,直接改善發動機的動力性、經濟和排放指標;作為對缸內過程的分析,進行了特性的實驗測試;對原汽油機和新開發的液化石油氣發動機,進行了外特性和部分負荷特性以及怠速的排放及噪聲對比性測試。
  9. This thesis establishes the main factor of heating surface slagging of no. 1 boiler, that it is due to irrational layout of furnace heating surface, improper angle of burner which lead to flames attaching to furnace walls. such deduction is built on the basis of necessity of analyzing the heating surface slagging, the type of coal, the design of the furnace and burner, the operational condition and other factors effecting slagging of boiler. the research is mingled with practical operations of no. 1 boiler in inner mongolia fengtai electric power generation co, ltd

    文從分析煤鍋爐結渣問題必要性出發,從煤種、爐膛及器設計、運行工況等因素對鍋爐結渣的影響著手,結合內蒙古豐泰發電有限公司~ # 1鍋爐實際運行中存在的問題,確定了~ # 1爐受熱而結渣的主要原因是爐膛受熱面布置不合器角度不合適導致火焰貼壁所致。
  10. The fractal theory application to fault diagnosis is tried in order to overcome the defec t of wavelet transform to nonlinear signal analysis and complicated machine diagnosis, including the concept, function and application about fractal dimension and the process of applying it to analyze the libration signal of rolling bearing and engine burning

    針對小波變換分析復雜非線性機械繫統時表現出的力不從心,又嘗試探討了分形在故障診斷領域中的應用,討了分形維數的概念、物意義和應用,並通過滾動軸承和發動機振動信號的分析例示探討和展示了應用分形方法進行故障診斷的方法和過程。
  11. According to finite element segmentation principle, by combining test with observation, the author has measured the air streamline and speed distribution of burning equipment in dally situation, which provides some guide for research of air field in hearth on cold and hot conditions. and the law is found of air speed distribution by measuring its speed and distribution of upper and lower deck on cold condition, thus it lays the foundation for analysis on hot condition. under four burning states, we measure the air speed in single, double - deck, and find out its corresponding distribution law

    5 .根據有限元分割原布置測點,採用降溫方法,用k五江9106等儀器分別測出單雙爐排方式4種不同工況下,該設備爐膛內coz 、 02 、 co氣體濃度,並找到了隨爐膛高度方向及深度方向變化規律;從分析評價了2種方式爐膛內coz 、 02 、 co氣體濃度場分佈特點及相應料層內乾燥、干餾、氧化、還原、灰渣層厚度,肯定了雙層爐排方式爐膛中c02 、 02 、 co氣體濃度場分佈合性,從燃燒理論找出了最佳濃度場分佈狀態及料層內各反應層厚度。
  12. Ln this paper, the flame stability function is anaiyzed, and high concentration puiverized coai theory is researched, which is on the base of the fire and combustion characteristics of the coai

    文從煤的著火和特性出發,分析了煤的著火穩性能,研究了高濃度煤粉燃燒理論
  13. Theoretical analysis on combustion of ultra - clean micronized coal - water slurry in a small high - speed internal combustion engine

    精細水煤漿在小型高速內機上的燃燒理論分析
  14. Theory of boiler combustion

    鍋爐燃燒理論
  15. With the rapid development of both computer hardware and software including combustion theory and computational fluid dynamics, numerical simulation has become more and more important

    隨著燃燒理論和計算流體力學的迅速發展,加上計算機的廣泛應用,燃燒理論與數值方法相結合是必然的發展趨勢。
  16. With the rapid development of computational fluid dynamics and combustion theory, applying the computer to numerically simulate the complicated processes in the plasma ignition is possible. using numerical simulation can estimate the parameters which are not essay to measure and not doing so many experiments can improve its reliability and reduce the cost. so numerical simulation is a new pattern way to study the inner mechanism of the plasma ignition

    隨著計算流體力學和燃燒理論的發展及計算機的廣泛應用,用數值模擬等離子點火器內部系統流動、傳熱、傳質、化學反應等復雜的過程已成為可能。應用數值模擬的方法可以對實驗難以測量的量進行預估,而不需要大量的試驗,應用數值模擬的方法來解決等離子點火器性能的分析和工程設計,有利於提高工作的可靠性和經濟性。
  17. There are much complicated and exquisite physical and chemical processes when the oil and the air been mixed. for some theories of the combustion are not clear and the differential eguations are so complicated, it is very difficlut to get the accurate flow field distribution. so it limits the combustion theory to design conb ustion equipment

    由於對某些料的過程機至今尚不完全清楚,並且描述這一現象數學模型的控制微分方程很復雜,所以很難用解析方法求得等離子點火器流場的精確分佈,這樣就極大的限制了人們應用燃燒理論指導這一設備的設計研究。
  18. The paper adopts active measure, reconstructs parts on the equipment, and come up with micro - computer controlling system which will be used on the domestic oil heaters, taking into account the change of users ' needs and the current situation all over the world, based on machanism of emission producing and theorizition of combustion

    本研究採取主動措施,根據污染物的生成機、傳熱學、燃燒理論等,針對該設備的部分結構進行了合改進,並按照用戶使用要求的變化以及國外的發展狀況,提出了在國產汽車油加熱器上採用微型計算機控制的技術方案。
  19. This paper analyzes the occurring of land conversion with burning theory, and points out that land conversion is results from population increase, resource endowment, economic development, farmland ' s low comparative economic benefit, unreasonable distribution of framland ' s income, vague land property right, shortsighted activities of local government, the first revolution of urban land use system and rapid urbanization

    文運用社會燃燒理論分析了農地非農化過程的發生,認為農地非農化是在「物質」人口增長、資源稟賦、經濟發展, 「助劑」農地比較經濟效益低、農地非農化收益分配不合、土地產權、權能模糊和地方政府的短期行為, 「點火溫度」城市土地使用制度的第一次革命和快速城市化下共同作用的結果。
  20. In order to study the regeneration mechanism of dpf in detail, we still need a mathematical model of the channel unit, which present temperature field and the soot reaction rate of the channel. finally, it points out the influences of various factors to the regeneration process by computing the numerical solution of model under different boundary conditions and geometry parameters, such as the initial temperature, the gas flow rate, the oxygen concentration, the sediment quantity and the wall thickness of the filters, and so on. in this way, the paper provides theoretical guidance for optimization design of the dpf

    首先研究了干凈壁流式過濾體的加熱特性,然後在加熱和燃燒理論的基礎上建立了微粒捕集器再生過程的數學模型,並對模型進行了數值計算,得到了捕集器內部的三維溫度場分佈以及溫度梯度分佈,結果與實驗值吻合較好,驗證了模型的正確性;為了詳細的研究微粒捕集器的再生機,建立了孔道單元數學模型,得到了孔道內的溫度場分佈和微粒反應速率分佈;最後,通過求解模型在不同邊界條件和不同幾何參數下的數值解,分析了各種因素對再生過程的影響,如過濾體初始溫度、過濾體內氣流的流動速率、氧濃度、微粒沉積量以及過濾體壁面厚度,為微粒捕集器的優化設計提供指導。
分享友人