燈絲的 的英文怎麼說
中文拼音 [dēngsīde]
燈絲的
英文
ligamental-
An inert gas such as argon is introduced to reduce evaporation of the filament.
將諸如氬那樣的惰性氣體充入燈泡中,以減少燈絲的蒸發。The cathode at the left is raised to a high temperature by the heater, and electrons evaporate from its surface.
左邊的陰極被燈絲加熱到高溫,同時電子從陰極表面蒸發出來。The source of electrons in an electron microscope is a heated filament.
電子顯微鏡中的電子源,是一加熱的燈絲。The effect is caused by the escape of electrons from the hot filament.
這個效應是由於電子從熱燈絲逸出而引起的。Measuring methods of the heater or filament current and voltage for electronic tubes
電子管熱絲或燈絲電流和電壓的測試方法Measurements of the electrical properties of electronic tubes. part 2 : measurement of heater or filament current
電子管電性能的測量.第2部分:熱絲或燈絲電流的測量This article introduces briefly the process of design and characteristic of structure of db930 tube and discusses the main problems of technology and technique which was met during the manufacture and the measures having been adopted are emphatically. it discusses the solve measures in following six aspects : the filament current is too large, carbon deposits during the carbonizing of cathode, the capacitance between the first grid and the second grid is too large, transpiring happens inside the tube, the insulation resistance between the electrodes is too lower when the filament is on and the ability of bearing high voltage is too lower
本文簡略地介紹了db930的設計過程及其結構特點,重點論述了在試制過程中遇到的主要工藝技術問題及解決問題的措施,圍繞解決燈絲電流大、陰極碳化時積碳、一柵和二柵之間的電容大、管內蒸散、熱態時極間絕緣低、耐高壓的能力差等六個方面的問題進行了論述。Phase conductor not connected to the centre contact of the edison - type screwed lamp holder
相導線並非接駁至螺絲頭燈座的中間觸點。To attain the high - power, well - proportioned and steady high - energy particle beam is the base of analyzing beam loss. the factors that influence the emission performance of the filament are analyzed, and the parameters are calculated. the experiment results proved the correctness of analyses
獲得大功率、均勻、穩定的高能粒子束是進行束流損失分析的基礎,本文分析了影響燈絲發射特性因素,對燈絲各參數進行了設計計算,實驗證明了分析的正確性。Edison ' s efforts to invent an electric light bulb did not pan out until he used tungsten wires
愛迪生發明電燈泡的努力直到使用鎢絲才獲得成功。Fire hazard testing for electrotechnical products - test methods - glow - wire test
電工產品的火災試驗.試驗方法.熱燈絲試驗To develop the carbonized cotton - thread filament for the incandescent light bulb
才發明出適合白熾燈泡使用的碳化棉絲燈絲You know, thomas edison tried and failed nearly 2000 times to develop the carbonized cotton - thread filament for the incandescent light bulb
你知道,托馬斯?愛迪生經過近2千次失敗才發明了炭化棉線燈絲的白熾燈泡。The filament of an incandescent light cannot burn up because the bulb in which it is enclosed contains no air
白熾燈的燈絲不會被燒掉,因為被封閉著的燈炮中沒有空氣。Physically, the filament minutely heats up and cools down at twice the line rate, due to ac applied to the filament
實際上,由於加載在燈絲上的交流電,燈絲基本上是以兩倍市電頻率加熱或冷卻。Designation method for mounted filaments of incandescent tungsten lamps
白熾鎢絲燈安裝燈絲的命名方法Safety requirements of luminaires with built - in transformers for filaments lamps
內裝變壓器的鎢絲燈燈具的安全要求Lcq14 : situation in government departments using compact fluorescent lamps in place of tungsten light bulbs
立法會十四題:政府部門採用慳電膽代替鎢絲燈泡的情況You should follow the installation instructions for the luminaires, such as installing away from combustible surface ( wall paper, wooden false ceiling ), allowing sufficient room for heat dissipation ( particularly luminaires fitted with tungsten halogen lamps ), ensuring effective earthing connection ( such as adding star and spring washers at the earth terminal ), and adopting proper anchorage to support its weight
燈飾應按照指示安裝,注意要遠離容易燃燒的表面(例如墻紙、木製假天花) ,預留足夠的散熱空間(尤其是裝有鎢絲鹵燈的燈飾) ,確保有效接地(例如在接地終端加上菊花介指和彈弓介指) ,並因應燈飾的重量,選用適當的安裝方法(例如大型的吊燈,須選用拉爆螺絲等) 。Thomas edison and his employees worked for many months to find the right material to act as the filament
托馬斯.愛迪生和他的員工用了數月的時間來尋找作燈絲的合適材料。分享友人