燒結膨脹 的英文怎麼說

中文拼音 [shāojiēpéngzhàng]
燒結膨脹 英文
clinkering expansion
  • : Ⅰ動詞1 (使東西著火) burn 2 (加熱或接觸某些化學藥品、放射性物質等使物體起變化) cook; bake; hea...
  • : 結動詞(長出果實或種子) bear (fruit); form (seed)
  • : 動詞(物體的長度或體積增加) expand; swell
  • : 動詞1. (膨脹) expand; dilate; inflate 2. (脹大) swell; distend; bloat
  • 膨脹 : expand; swell; dilate; inflate; puff; bulge; inflation; expansion; dilatation; buckling; swelling...
  1. Among the ways that motorists have made this clear : spraying the cameras with paint ; knocking them over ; covering them in festive wrapping paper and garbage bags ; digging them up ; shooting, hammering and firebombing them ; festooning them with burning tires ; and filling their casings with self - expanding insulation foam that, when activated, blows them apart

    駕車者的下列行為清楚地表明了這一點:給相機噴灑顏料;撞倒相機;用喜慶的包裝紙和垃圾袋將它們蓋住;把相機挖出來;用槍射擊、用錘子砸和用燃彈炸;用燃的輪胎在上面彩;將自身的絕緣泡沫塞進相機外殼,一旦泡末起來,能將相機撐開。
  2. As the result, we found natural scale graphite. expanded graphite by self - made, expanded graphite all had a certain flam - retardant effect and the composite inclusive of expanded graphite had the best flam - retardant effect

    論文同時還據于石墨阻燃的特性,測試了復合材料的燃性能,果表明,天然鱗片石墨、石墨、化石墨都具有一定的阻燃作用,以化石墨的阻燃效果最佳。
  3. Study on the synthesis of corundum - mullite - gahnite multiphase materials by one - step sintering process using high purity raw materials showed that the more the content of gahnite in multiphase materials, the high the volume expansion would be introduced in the system, which resulted in the sintering difficulty of the multiphase materials. while the content of gahnite was controlled about 30wt % and the content of mullite was about 70wt %, the densified multiphase materials can be obtained after fired at 1600 or 1700

    採用高純原料一步合成剛玉?莫來石?鋅鋁尖晶石復相材料研究表明:復相材料中鋅鋁尖晶石含量越高,則合成鋅鋁尖晶石時產生的體積越大,性也就越差;當鋅鋁尖晶石含量為30wt ,莫來石含量較高為70wt左右時,在1600或1700后都能得到顯微構較為緻密的復相材料。
  4. The studies indicate that different content of pyrophyllite and dolomite can cause the following three cases : ( 1 ) making the refractory point decrease linearly and, to some extent, influencing the microstructure and properties of sintered body ; ( 2 ) acceleratingmullite formation during sintering, reducing thermal expansion coefficient of bond, reinforcing the matching nature and improving the flexural strength and shock strength ; ( 3 ) preventing sic grinding tool from generating black core, expanding suitable sintering temperature range of sic grinding tool

    同時,也不同程度地影響了磨具體的微觀構和性能; ( 2 )可促進在過程中莫來石的形成,降低合劑的熱系數,加強了合劑與磨料的匹配性,提高了磨具的抗折強度和抗沖擊強度; ( 3 )在一定溫度范圍內還可防止碳化硅磨具出現黑心現象,拓寬了碳化硅磨具的溫度適應范圍。
  5. The expansion and dehiscence behavior during the vacuum reactive sintering below 660 of compact ti / al composite powders was experimentally investigated, and the reasons of expansion and dehiscence were theoretically analyzed. the method of low temperature reactive sintering was generalized, and the experiment testified the method effective. the rule of the expansion of the billets was generalized from the result of density of the billets

    低溫反應工藝:研究了高能球磨ti / al復合粉體在溫度低於660下真空無壓反應過程中的和開裂行為,分析了產生和開裂的主要原因;並提出了能夠有效預防坯料開裂的方法;通過測定坯料在低溫后的密度,總了其體積的規律;通過x射線衍射技術分析了隨球磨時間不同,金屬間化合物的生成情況。
  6. But it also includes two fatal disadvantages : first, at is difficult to be sintered and its density is low, which causes its lower strength ; second, in the temperature range of 1023 - 15 73 k, at can decompose into al2o3 and tio2 easily, which can cause the stress concentrated and raise the heat expansion rate

    但是該材料本身存在的兩大致命的缺點,在很大程度上限制了它的廣泛應用: ( 1 ) 、鈦酸鋁難以體的緻密度低,因而強度不高; ( 2 ) 、在750 1300的溫度范圍內易分解成氧化鋁和二氧化鈦,造成材料內部應力集中,並使材料的熱率升高。
  7. Agglomerated stone - test methods - determination of linear thermal expansion coefficient

    石料.試驗方法.線性熱系數測定
  8. Agglomerated stone - test methods - part 11 : determination of linear thermal expansion coefficient ; german version en 14617 - 11 : 2005

    石料.試驗方法.第11部分:線性熱系數測定
  9. The results show that : the fillers of sio2 based investment consist of sio2, al2o3 and mgo, and the binder is nh4h2po4 for sio2 based investment, the bulk density and the compression strength decrease, the apparent porosity and the thermal expansion increase, when the specimens are heated to 900 ; the fillers of al2o3 based investment consist of al2o3 and mgo, and the binder is nh4h2po4 ; for al2o3 based investment, the bulk density decreases and the apparent porosity increases when the specimens are heated to 900 ; the fillers of mgo based investment consist of mgo and al2o3, and the binder is ca cement ; for mgo based investment, the compression strength decreases and the thermal expansion increases greatly when the specimens are heated to 900

    果表明:氧化硅系包埋料的骨料是氧化硅、氧化鋁、氧化鎂,合劑為磷酸二氫銨,其900鍛后顯氣孔率增加,體積密度下降,耐壓強度降低,熱增大;氧化鋁系包埋料的骨料是氧化鋁和氧化鎂,合劑為磷酸二氫銨,其900后顯氣孔率增加,體積密度下降,熱變化不大;氧化鎂系包埋料的骨料是氧化鎂和氧化鋁,合劑是鋁酸鈣水泥,其900后耐壓強度明顯降低,熱明顯增大。
  10. ( 2 ) the oxygen - rich spinel material from sintering the precursor at low temperature changed into perfect spinel structure due to releasing the excess oxygen when raised the sintering temperature slowly, which caused the lattice expanded and at the same time the system energy lowered and the bonding energy raised, and tansformed into the stoichiometric limn2o4 at 700

    ( 2 )低溫合成的材料為富氧型尖晶石材料,隨著溫度的升高,構中多餘的氧逐漸釋放,系統能量降低,合能增加,品格發生,樣品向完整的尖晶石構逐漸過渡。 700得到的材料為化學量的limn _ 2o _ 4 。
  11. The thermal stress of ceramic regenerator resulting from its temperature difference and restricted extension and contraction has been calculated and analyzed, the result provides a theoretical basis for design and operation of high temperature air combustion system

    對于由溫度分佈不均勻,陶瓷蓄熱體或收縮受限制而產生的熱應力進行了計算和分析,其果為蓄熱式高風溫燃系統的設計及運行參數的選擇提供了理論依據。
  12. Experiment adopts a series of technology, such as expansion technology, solid burning technology, mullite crystallizing technology and anti - clarifying technology etc. through orthogonal optimized proportion and suitable accelerated burning test, experiment has successfully produced high strength and performance fly ash lightweight aggregate

    研究中,採用了技術、固相技術、莫來石晶化技術和反澄清保氣技術。通過配合比正交優化和適宜的快速焙實驗,制出了輕質、高強、低吸水率的優質粉煤灰輕集料。
  13. If appropriate m2t is introduced, the composite can also obtain fine thermal properties. when the content of m2t is 10mol %, the thermal expansion coefficient is - 0. 45x10 - 6 /

    同時引入適量鈦酸鎂,鈦酸鋁體的熱系數仍然很低,鈦酸鎂的含量為10mol時其熱系數為- 0 . 45 10 ~ ( - 6 ) 。
  14. The results show that the shrinkage of cement paste can be compensated by the new mgo - based expansive materials well, only if the burning temperature and burning time of expansive material are controlled and the dosage of expansive material in cement is suitable according to the hydration temperature and with fly ash or not

    果表明,根據一定條件下(如養護溫度、摻加粉煤灰等)水泥漿體的收縮特性來調整材料的煅溫度和煅時間,控制合理的摻加量,新型鎂質材料可以有效地補償水泥漿體的收縮。
  15. Perovskite - type complex oxides of la1 - xcaxcro3 compositions are attracting growing attention because of their superior electronic conductivity and excellent chemical stability in both oxidizing and reducing atmospheres, which makes them promising candidate materials for many important applications, such as interconnectors for solid oxide fuel cells ( sofc ), heating elements for high temperature furnaces, and current collecting electrodes in magneto - hydrodynamics ( mhd ). in this dissertation, the gnp ( glycine - nitrate process ) method has been employed to synthesize la1 - xcaxcro3 oxides. the synthesis and preparation, sinterability, electrical conducting properties and thermal expansion properties of la1 - xcaxcro3 oxides have been investigated

    本文採用gnp ( glycine - nitrateprocess )法制備了la _ ( 1 - x ) ca _ xcro _ 3材料,對制備方法與工藝參數、材料性能、電性能以及熱性能進行了研究,分析了ca ~ ( 2 + )含量、粉體顆粒形態對材料行為、緻密化溫度的影響,並研究了ca ~ ( 2 + )含量、粉體顆粒形態對材料晶體構、顯微構和物理性能的影響,其目的在於為該類高溫電子導體的進一步研究利應用提供實驗和理論依據。
  16. Adding sic can decreases sintering temperature of al2o3 efficaciously, but also can make the al2o3 crystal growth as flake, strengthen the coalescent of the al2o3 crystals, and the residual sic during sintering can strengthen the al2o3 ceramics. because the reaction between sic and al2o3 begins from the surface of samples, there is a compact protecting field on the surface of the samples to restrain o2 enter into the samples, and leave more pore in them to decrease the thermal expansion coefficient and increase their the al2o3 ceramics " thermal shock resistanc e times

    引入sic的樣品在過程中,首先在樣品的表面產生sic與o _ 2及al _ 2o _ 3的反應,形成一層緻密的保護層,阻礙o _ 2進入材料內部,在材料的內部留下較大的氣孔率,可以降低其熱系數,並使材料在受熱過程中有一定的空間進行構調整,能夠顯著的提高al _ 2o _ 3陶瓷材料的抗熱沖擊次數。
  17. In the process of preparing glass / mullite composite material, research on shrink rate, bending strength, dielectric constant, dielectric loss tangent, etc have been carried out. in the experiment, the thermal expand coefficient of samples is tested, and through sem, insides structure of sintered sample is studied, so the relationship of

    在制備玻璃/莫來石復合材料的過程中,我們研究了成后徑向收縮率、試樣的抗彎強度、介電常數、介質損耗及其影響因素,並測試了試樣的熱系數,通過sem觀測成試樣的內部構情況,找出性能和構之間的關系。
分享友人