爐溫 的英文怎麼說

中文拼音 [lúwēn]
爐溫 英文
[冶金學] furnace temperature爐溫梯度 furnace temperature gradient
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  1. Foundation of black body furnace temperature time series prediction model based on bpnn

    神經網路的黑體爐溫度時序預測模型的建立
  2. Pipe furnace temperature control system based on epa

    爐溫監控系統開發
  3. Optimal setting model of reheat furnace temperature

    加熱爐的爐溫優化設定模型
  4. The process of growing ktp crystal of high quality and low conductivity was studied. it was pointed out that many factors such as the uniformity of temperature distribution in the furnace, the accuracy of temperature control, the quality and direction of seed crystal and the speed of temperature drop all had an important influence on the quality of ktp crystal

    研究了生長高光學質量、低電導率ktp晶體的工藝過程，指出晶體生長爐溫度場的均勻性、控溫精度、籽晶的質量和定向以及降溫速度的快慢對晶體的光學質量有著重要的影響。
  5. Ser elements can be replaced while the furnace is at operating temperature

    在熔爐溫控范圍內， ser型硅碳棒可以被替換。
  6. It is found that the appropriate lowering of the chamber temperature of water gas producer and the thickness of coal bed is favorable to controlling the volume fraction of o2 and co in the recovered flue gas

    通過試驗與分析，發現適當降低水煤氣發生爐爐溫與煤層厚度，有利於控制回收煙氣中o2及co的體積分數。
  7. To determine the recommended wattage capabilities of the elements start with figure 1

    要測算其理想的負荷能量看圖1后，了解到將在何種熔爐溫度和大氣環境下進行溫控。
  8. Vacuum furnace bed temperature control system based on singlechip

    基於單片機的真空爐溫控系統
  9. Fuzzy predictive functional control strategy for decomposing furnace temperature system of cement rotary kiln

    模糊預測函數控制在水泥回轉窯分解爐溫控系統中的應用研究
  10. For many years, the drying furnace has been adopted with sealed structure and electrical heated, dial instruments are used to control the temperature of the drying furnace and to keep it invariable. parameter setting is inputted by manual method, heating time is completely controlled by operators ’ experiences or their moods, meanwhile, its control function is singular, not only having no automatic heating time and insulating monitoring, having no drying process monitoring, but also having no function of automatic recording and report printing, the workers ’ labor intensity is bigger. thus two abnormal situations are always come forth, one is the insulating performance and intensity of works cannot be guaranteed reliably, it perhaps need to be dried repeatedly, the other is always to extend the drying time in order to ensure the drying quality

    多年來乾燥爐一直採用悶罐式結構和電加熱方式，溫度控制採用指針式溫度控制儀表來實現爐溫的恆定，其參數設定由人工輸入，時間控制則完全憑操作者的經驗、情緒來掌握，其控制功能單一，沒有時間控制、絕緣自動監測功能，也沒有乾燥過程監視功能，更沒有多要素記憶、列印存檔功能，工人的勞動強度較大，所以就經常出現兩種異常結果:一是工件的絕緣性能和強度得不到可靠保證，需要反復乾燥;另一種是為保證乾燥質量，往往要延長乾燥時間。
  11. Avoiding the difficulties of detecting the difficult parameters in furnace control and of building up the models, integrated with fuzzy control and conventional pid control, abb ’ s control it system is used to predict the bloom surface and center temperature directly based on the temperature of furnace wall easily to be detected so that the temperature settings in various furnace sections can be self - corrected, the furnace temperature of each section self - adjusted and on - line parameters of combustion control self - optimized. in addition, the heating parameters and the operating status of the field plant can be monitored with alarm

    採用abb公司的controlit控制系統，避開爐子控制中遇到的困難參數檢測及建模困難等因素，直接根據容易檢測的爐壁溫度來推知鋼坯表面溫度及鋼坯中心溫度，將模糊控制技術與常規pid控制相結合，實現各段溫爐設定值自修正、各段爐溫自協調、各參數在線自整定的自尋優最佳燃燒控制;對熱工參數、現場設備的運行情況進行監視、報警，實現爐膛壓力、管道壓力、換熱器的保護控制，並將重要參數送往廠級mis網路。
  12. K - 006 series of blowing thermocouple are applicable to measure temperature in gas making furnace of chemical fertilizer which principle is a gas way come into being between sheathed thermocouple and outer protective tube

    一概述wrk - 006系列吹氣熱電偶產品適用於測量化肥造氣爐溫度，原理是在鎧裝熱電偶和外保護套管之間構成一定的氣路，在
  13. The silicon content in hot metal tapped from blast furnace is a very important factor which should be controlled in iron making process. it is not only a very important criteria in evaluating the quality of hot metal, but also an index of the thermal level in blast furnace. so, it is essential to keep its stabilization for the blast furnace manufacturing

    高爐鐵水硅含量是高爐生產過程中需要控制的重要因素之一，它不但是反映生鐵質量的重要指標，而且還可以反映高爐的爐溫水平，同時也是表徵高爐內熱狀態的一個重要指標，對維持高爐的穩定、順行、高產尤為重要。
  14. Fuzzy self - adaptive pid control for temperature of resistance furnace

    的電阻爐溫度控制系統
  15. The fuzzy control for temperature of decomposition furnace of cement rotating kiln

    水泥回轉窯分解爐溫度的模糊控制
  16. Research on combustion temperature fuzzy neural network model of incinerators

    垃圾焚燒爐爐溫控制模糊神經網路模型研究
  17. Fuzzy control design and simulation of the temperature in the precalciner kiln

    預分解窯分解爐溫度的模糊控制設計與模擬
  18. The temperature of the bake box could be adjusted from 50 - 300

    爐溫可在50 - 300范圍內任意可調，操作方便性能穩定。
  19. Soft - sensing system of gasification furnace temperature based on chaos - rbf neural network

    神經網路的氣化爐溫度軟測量系統
  20. On - line fuzzy decision based on mechanism modeling for reheating furnace temperature

    基於機理模型的加熱爐在線爐溫模糊決策
分享友人
分享到 Line

分享到臉書