爐熱試驗 的英文怎麼說

中文拼音 [lúrèshìyàn]
爐熱試驗 英文
oven test
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 試驗 : trial; experiment; test
  1. Tests and analyses performed by experts and technical personnels show that, the brown coal used by hongwei power plant is extremly prone to produce reside in the process of power generation. this paper discusses the problem of burning residue in the coal fired boiler 410t / h of hongwei heat & power plant

    本文對宏偉熱電廠410t / h燃煤鍋爐的煤灰特性等進行了試驗分析，試驗結果表明，宏偉熱電廠燃用的褐煤是一種有嚴重結渣傾向的煤，運行中極容易結渣。
  2. Basic environmental testing procedures. test methods. fire behaviour. analysis and titrations of gases evolved during pyrolysis or combustion of materials used in electrotechnics. exposure to abnormal heat or fire. tube furnace method

    基本環境試驗程序.試驗方法.火災特性.氣體在高溫分解過程中的分析和滴定或電工用材料的燃燒.異常熱力或火災輻照.管式爐法
  3. Coal - fired water - heater with storage boiler, without pressure for test pressure of 1 atmosphere ; terms employed, construction, quality, capacity and testing

    1個大氣試驗壓力的裝有無壓力貯水鍋爐的燒煤的水加熱
  4. It is designed according to electrical stove or microwave oven request. heating pipe adopts high temperature resistance mgo powder as the insulation medium and the stainless steel case is passed oxidation deal through the advanced web band protection oven 1050c in order to become the a special oxidation layer and improve the high temperature oxidation and bittern corrosive performance of the heating pipe. the heating tube has high power density and strong heat radion. this product with good safe performance can work normally after 3000hrs life test

    加熱管選用耐高溫氧化鎂作絕緣介質，不銹鋼外殼經過先進的網帶氣體保護爐1050的氧化處理，形成一種特殊的氧化層，提高電熱管的抗高溫氧化及鹽鹵的腐蝕性能。電熱管的功率密度較高，熱輻射能力強。產品經長達3000h的壽命試驗后，仍能正常工作，安全性能好。
  5. The experimentation of cool and hot diagnosis reflected the structure and disposal of combustor, slag bonding and smirch of hearth are the main factors of hearth ' s outlet overheat and output of boiler decline

    冷、熱態診斷試驗反映出爐膛結焦、粘污及燃燒器的結構和布置等因素是造成爐膛出口煙溫偏高，鍋爐出力下降的主要因素。
  6. We select ni / cr alloy resistor as element together with ceramic embedding hearth ; select small flat - and - disc heat - even hubby ceramic sample holder, select ni / cr & ni / si thermoelectric couple ( type k ) as thermoscope with threads 0. 5 mm in diameter which is installed in the middle of the holders symmetrically ; select aluminum silicate fire - retardant fiber as materials for heat preservation ; design some hardware, for example temperature controller & transporter, signal amplifier etc ; design controlling curve to heat stove ; and introduce the method of least squares nonlinear regression and subsection function to deal with data. in order to obtain the reasonable operation conditions and operation curve, we have also done many theory analysis and experiment discussions

    通過理論和試驗探討，選用鎳鉻合金電阻絲作為加熱元件，配以陶瓷質埋入式爐膛；選用陶瓷質小尺寸扁平?圓盤均熱塊體型樣品支持器；選用0 . 5mm絲徑鎳鉻?鎳硅熱電偶（ k ）作為測溫元件；熱電偶對稱安置在樣品支持器容器的中部；選用硅酸鋁耐火纖維作保溫材料；合理選用和設計了溫度控制器、溫度變送器、信號放大電路等硬體；採用升溫曲線來控制爐膛供熱過程；採用最小二乘法非線性回歸與分段函數相結合的曲線模擬方法，進行圖形處理。
  7. Standard test method for measuring the static heat resistance of a self - cleaning oven coating

    自清洗爐覆層的靜態耐熱性測量的標準試驗方法
  8. Test method for coal - burning air heater

    燃煤熱風爐.試驗方法
  9. The combustion test and analysis of a 2. 8mw hot - water traveling - grate boiler retrofitted for firing coal - water slurry

    熱水鏈條鍋爐改燒水煤漿燃燒試驗分析
  10. En 303 - 5 heating boilers. part 5 : heating boilers for solid fuels, hand and automatically stocked, nominal heat output of up to 300 kw. terminology, requirements, testing and marking

    供暖鍋爐.第5部分:公稱熱輸出值在300kw以下的手動和自動進料的固體燃料的供暖鍋爐.術語要求試驗和標記
  11. Coal - water slurry is a new type of clean fuel as a replacement for oil. this paper introduces the tests of maoming no. 2 oil - fired 220 t / h utility boiler being retrofitted to fire coal - water slurry, including slagging tendency, heat transfer performances and pollutant emissions. firstly the k - ? two - equation turbulence model is used in numerical simulation for the side - air burner, compared with the practical measures and tests, good accordance achives

    水煤漿是一種低污染、高效率、流動性強的代油新型清潔燃料，本文針對廣東省茂名熱電廠2 #油爐改燒水煤漿示範工程，對鍋爐改造后的結渣特性、爐內傳熱特性和污染物的排放特性進行了試驗研究。
  12. The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine

    用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌：用xrd進行原料物相分析，及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度；用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性；用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化；用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試；採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定；用萊次偏光顯微鏡（ pm ）測試固體潤滑劑的硬度；用材料試驗機測試固體潤滑劑的抗壓強度等。
  13. After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %

    摘要通過對加熱爐幾種工況進行熱力計算、冷態試驗的流場分佈及阻力測定和熱態試驗的爐膛溫度場分佈及管壁溫度等參數的測定，確定將管式加熱爐爐膛內直流燃燒改為旋流場燃燒和增加輻射筒，增設煙氣含氧量分析，可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下，極好地改善爐膛內的燃燒狀況和對流輻射傳熱效果，從而降低排煙溫度45 ，減少加熱爐排煙損失，節約了煤氣量6 %以上。
  14. Residential independent boilers fired by solid fuel - nominal heat output up to 50 kw - requirements and test methods

    居民分戶固體燃料鍋爐.額定熱輸出大於50kw .要求和試驗方法
  15. Test method for expansion or contraction of coal by the sole - heated oven

    用底部加熱爐對煤的膨脹性和收縮性測試的試驗方法
  16. The reform scheme of no. 1 boiler in fengtai company is confirmed on the basis of cold / hot tests, theoretical discussions and calculations. in the process of field retrofit, it is indicated in the operation of the improved furnace that without the change of furnace structure, the transform of the burner angle has shrunk the tangential diameter and prevented flames burning on furnace walls, and the burning state of furnace has been bettered, simultaneously, lowering the slagging wi in furnace, thus laying sol id foundation for the safe and economic operation of generating units. wuyanrong ( power plant thermal power engineering ) directed by prof

    本論文通過冷、熱態試驗，經過論證和計算，確定了豐泰公司~ # 1爐燃燒器的改造方案，並進行了現場改造，改造后實際運行狀況表明：在無法改變爐膛結構的情況下，改變燃燒器角度，縮小切圓直徑，使火焰不貼壁，改善了爐內燃燒工況，同時降低了鍋爐結渣的程度，為機組的安全經濟運行奠定了必要的技術基礎。
  17. 05. 02 storage stability of water - in - oil emulsions by the oven test method, test method for

    用爐內加熱試驗法測定油中含水乳液的存儲穩定性的試驗方法
  18. Iec 60779 : 20 industrial electroheat equipment - test methods for electroslag remelting furnaces iec 60779 : 2005 ; german version en 60779 : 2005

    工業用電加熱設備.電渣重熔爐的試驗方法
  19. Test methods for batch furnaces with metallic heating resistors

    有金屬加熱電阻的間歇生產爐的試驗方法
  20. Industrial electroheating equipment - test methods for direct arc furnaces

    工業電加熱設備.直接電弧爐的試驗方法
分享友人
分享到 Line

分享到臉書