特超聲頻 的英文怎麼說
中文拼音 [tèchāoshēngbīn]
特超聲頻
英文
hypersonic frequency-
Based on the character of ultrasonic spectrum analysis, considering the affection of the circuit responsion of checking system, coupling state, position of checking transducer, this thesis established reasonable ultrasonic spectrum analysis method. using this method, several kinds of linear spectrum ( such as phase amplitude spectrum, phase power spectrum ) were researched and discussed
本文根據超聲波頻譜分析的特點，綜合考慮了檢測電路響應、耦合狀況、探頭位置等因素的影響，制定出了一套合理的超聲波頻譜分析方法，並用此方法對幾種線性譜（如相位幅度譜、相位功率譜等）進行了研究和探討。We rounded analysis that ring stator ’ size parameter how to affect ring stator ’ characteristic frequency by use the software for numeric analysis, and afford theoretical foundation for the optimum design of ultrasonic motor ’ structural parameter
本文還利用分析軟體，全面地分析了定子圓環各個尺寸參數對特徵頻率的影響，為超聲波電機結構參數的優化設計提供了理論依據。By integrating conventional fourie transformation with the smooth average method of spectrum, the high frequency noise was not only removed, but also the signal was smoothed and the main frequency of the signal was found easily and then was extracted as the coarse features of the signal. on the basis, in order to analyze the detail features of the signal, the signal can be decomposed using the db6 mother wavelet function
在譜分析方法的傅立葉變換中引入平滑平均法對蜂窩結構材料和纖維增強材料聲-超聲檢測信號進行處理，不僅可以有效地去除信號的高頻噪聲，而且可以平滑信號，突出檢測信號的主頻，實現了對檢測信號「粗信息」特徵的提取；在此基礎上，合理選用db6小波基函數，對信號進行小波分解，對信號的特徵進行進一步的細微分析。The research results show that the influence of sampling frequency, sampling error of peak value, strobe - position and strobe - width on fft and ifft is obvious
研究發現，超聲信號的采樣頻率、采樣特徵點、閘門位置及閘門寬度對超聲信號的fft及ifft結果有明顯的影響。Ultrasonics fields. guidance for the measurement and characterization of ultrasonic fields generate by medical ultrasonic equipment using hydrophones in the frequency range 0, 5 mhz to 15 mhz
超聲場.使用頻率范圍在0 . 5mhz至15mhz水下聽音器的醫療超聲設備所產生的超聲場的測量和特性化指南Acoustics - measurement and characterisation of ultrasonic fields in the frequency range 0. 5mhz to 15mhz - hydrophone method
聲學在0 . 5 15mhz頻率范圍內的超聲場特性及其測量水聽器法Because the characteristics of frequency domain is slightly affected by the coupling state and only related with the defects by revising of the system, the technology of ultrasonic wave spectrum analysis is necessary tool for quantity or automatic testing
由於頻域特徵受耦合狀態等的影響較小，且經過系統修正後，能夠做到頻域特徵僅與缺陷有關，因此超聲波頻譜分析技術是超聲波定量檢測或自動檢測不可少的工具。Specification for measurement and characterisation of ultrasonic fields using hydrophones in the frequency range 0. 5 mhz to 15 mhz
採用頻率范圍為0 . 5mhz至15mhz的水珍器的超聲波場測量和特性規范For those biological signals like echo of bat or whale, as well as man - made system signals like radar or sonar signal, the instantaneous frequency of signal component contains important information and could be used for signal model parameters extraction. so that the proper choose of transformed domain and signal characteristic extraction method is of crucial important. the ridge extraction method used for signal characterization was first proposed in the 1990s, it ' s based on the study of the phase of the wavelet ( or other linear ) transform
對于許多實際的信號，如蝙蝠發出的超聲波、鯨魚的叫聲等生物信號，以及雷達、聲吶等人造系統產生的信號而言，信號瞬時頻率的變化規律反映了信號重要的特徵，並且也是信號模型中關鍵的參數，因此選擇合適的變換域提取信號的瞬時頻率信息，並選擇合適的方法對信號進行重建是很重要的問題。Finally, some important conclusions were drawn, that is, using distributed pzt transducers, ultrasonic guided waves are generated and received in a pipe. usually, there are many different modes of guided wave propagating in the pipe and these modes are generally dispersive, the specific exciting signal of a harming windowed toneburst with a central frequency of 70khz for decreasing the effect of dispersion was selected. and guided wave are generated using 16 distributed pzt transducers in a circumferential direction for suppressing flexural modes
首先，對當前本課題研究領域的進展作出綜述，並簡要介紹與超聲導波技術相關的理論基礎；其次，建立了一套有效的實驗裝置，在此實驗裝置基礎上，重點研究了採用分散式pzt傳感器在管中激勵和接收特定模態超聲導波的方法：根據在管狀波導中傳播的超聲波具有頻散現象及多模態特徵，選擇具有單一頻率的特定信號激勵超聲導波，使其頻散最小；同時採用分散式傳感器抑制不同模態的波型。The ability of checking out flaw in the ultrasonic testing is so worse because of the noise signal. but at present, the ultrasonic signal processing methods are only frequency spectrum analyses based on fourier transform. so it is difficult to analysis the time characteristic and frequency characteristic at one time
超聲檢測信號的干擾波使檢出缺陷的能力大打折扣，而目前採用的超聲信號的處理方法還多數只是基於傅立葉變換的頻譜分析，難以把信號的時域特性和頻域特性結合起來分析，處理效果很不理想。Based on the research of the respective characteristic of speed measurement sensors, several kinds of ultrasonic speed measurement methods are provided. aiming at their insufficiencies in measuring accuracy and operating range, a new method of ultrasonic spread spectrum speed measurement is proposed. the operating principle is analyzed in detail and the feasibility of this method is demonstrated in theory
在深入了解國內外多種測速傳感器特點的基礎上，討論了超聲測速的幾種常用方法;針對這些方法在測量精度和作用距離方面的不足，提出了超聲擴頻測速方法，詳細分析了其工作原理，並從理論上對該方法的可行性進行了論證。In the second part, the new method is compared with the old one in such aspects as system structure and signal processing methods. in the third part, the properties of dsss and lfm systems, especially the echo signal correlation processing of the systems are discussed. the last part are the respective analyses of water - pipe simulation experiment results and the trial results in zhong yuan oil field
本文首先介紹了超聲測距的基本原理，分析了通道的聲傳輸特性；接著將傳統液位測量方法和新型液位測量方法的系統構成和信號分析處理方法做比較；然後對系統的發射信號（直接序列擴頻信號和線性調頻信號）的特點進行了研究，並著重討論了回波信號的相關處理；最後對水管模擬實驗測量結果和油田實地測量結果分別進行了分析和討論。Abstract : frequency automatic tracking and amplitude stabilizing are two important characteristics of ultrasonic machining power
文摘:頻率跟蹤和恆定振幅控制是超聲加工電源兩個重要的特性。The wavelet ' s characteristic of focus " varieties make wavelet better analyses ability in the time field and the frequency field. it is a perfect method of analyzing non - steady signal, and it is fit to analysis ultrasonic pulse echo signal
而小波的「變焦距」特性使得小波分析在時域和頻域中都具有良好的分析能力，是一種理想的分析非穩態信號的途徑，適于對超聲脈沖回波信號的分析。Along with increase of pressure, the parameters such as velocity, amplitude, main frequency and quality factor of seismic wave change big gradually, while change very weakly with the change of temperature. through testing research for artificial crack and pore model, we conclude that crack density, azimuth, opening and the change of pore have obvious influences on speed, amplitude, attenuation ( or quality factor ) and main frequency of seismic wave etc. but, seismic wave dynamic characteristics are more evident than its kinematical characteristics for the change of crack and pore parameters. therefore, it offers reliable experiment foundation for detecting crack and pore by seismic wave kinematical characteristics ( such as amplitude, attenuation and main frequency etc. )
通過對人工裂縫和孔洞模型的超聲波實驗研究，可以認為：裂縫密度、方位、張開度和孔洞密度的變化對縱橫波的速度、振幅、衰減（或品質因子q ）和主頻率等參數均有明顯的影響，但裂隙參數的變化對地震波動力學特徵參數（振幅、衰減、主頻率等）的影響遠遠大於對運動學特徵參數（速度等）的影響，這為利用地震波的振幅、衰減和主頻率等屬性參數進行裂縫和孔洞特徵的檢測提供了可靠的實驗基礎。Presents the simple but highly reliable on - line detection of ultrasonic transducer clamping capacitance based on the impedance circuit model constructed through the impedance characteristics of the ultrasonic transducer under triple harmonics, and concludes from experimental results that this method can be used to effectively detect the variation of clamping capacitance while the transducer is operating, and the matching inductance can be dynamically regulated according to the results of detection, and dynamic matching can therefore be achieved in the real sense at the end of the transducer to improve the overall performance of the whole system
為了解決大功率超聲應用的換能器電端匹配問題，分析了超聲波換能器在諧振頻率三次諧波下的阻抗特性，給出了超聲換能器三次諧波下的阻抗電路模型.並根據阻抗電路模型建立了對超聲換能器的夾持電容實現在線檢測簡單、可靠性高的方法，實驗證明該方法有效的.該方法可以在換能器工作過程中隨時檢測夾持電容的變化，根據檢測結果對匹配電感進行動態調整，實現真正意義上的換能器電端的動態匹配，從而大大改善匹配質量，提高系統的工作性能Three characteristic features, such as average velocity of sound, deviation coefficient of sound velocity, and deviation coefficient of amplitude are extracted from four kinds of testing data which are sound velocity, amplitude, frequency and waveform in this paper. fuzzy analysis and artificial neural network are combined to form an intelligent system with similar functions to human brain to classify grc, aerated concrete, hollow brick, solid brick and concrete block. the accuracy of this system is up to 95 % in field tests
由超聲脈沖法獲得4種檢測信息聲速、波幅、頻率和波形，從中提取3個特徵量：平均聲速、聲速的離差系數和波幅的離差系數，利用模糊分析方法和人工神經網路相結合對grc 、加氣混凝土、空心磚、實心磚、砌塊5種墻體材料進行種類識別，形成一個智能化的、具有類似人腦功能的系統.經現場實測證明，判別的準確率達95 %以上。Because of the good sensibility, ultrasonic narrow band signal analysis technique with 1mhz central frequency was chosen to differentiate the heat treatment samples above - mentioned. there are obvious differences among heat treatment products in principal frequency, spectral peak ' s quantity, amplitude and distribution. that is to say, the technique of ultrasonic narrow band power spectral can be applied to characterize the microstructures of multi - phased alloy steels
利用窄帶信號頻譜分析技術靈敏度高的突出優點，選取中心頻率為1mhz的窄帶超聲信號，對上述不同熱處理試樣進行超聲功率譜分析，發現不同熱處理產物在功率譜主頻率、譜峰特徵（幅度、數量、分佈）等方面，都存在不同程度的差異。Methods of measuring the frequency of medical diagnostic and monitoring ultrasonic equipment
醫用超聲診斷和監護設備.頻率特性的測試方法分享友人