環流反應器 的英文怎麼說

中文拼音 [huánliúfǎnyīng]
環流反應器 英文
circulation flow reactor
  • : Ⅰ名詞1 (環子) ring; hoop 2 (環節) link 3 (姓氏) a surname Ⅱ動詞(圍繞) surround; encircle;...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : Ⅰ名詞1 (方向相背) reverse side 2 (造反) rebellion 3 (指反革命、反動派) counterrevolutionari...
  • : 應動詞1 (回答) answer; respond to; echo 2 (滿足要求) comply with; grant 3 (順應; 適應) suit...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 環流 : [氣象學] circulation; circulating current; circumferential motion; circular current; ring current...
  1. The effluent product in the reactor goes to the main fractionator, where the heat is removed in its various pump - around loops and initial product separation is accomplished

    堆的出物會進入到主分餾,在那裡,熱量會被四周圍各種各樣的循泵帶走,從而形成最初的產物。
  2. Hydrodynamics in an air - lift loop reactor

    氣升式環流反應器體動力學模型
  3. Nitrogen loss in internal - loop granular sludge bed nitrifying reactor

    顆粒污泥床硝化的氮損失
  4. Biodegradation of terephthalic acid wastewater in an airlift bioreactor

    環流反應器中對苯二甲酸廢水的生物降解
  5. The hydrodynamic parameters and mass transfer coefficient are studied in the internal loop airlift bioreactor used in treating wastewater. the hydrodynamic parameters consist of gas holdup, liquid velocity and axial dispersion coefficient

    本文從體動力學和傳質動力學兩個方面考察了用氣升式內生物用於廢水處理的性能。
  6. Influences of structure and operational parameters on gas hold - up in an external - loop reactor

    環流反應器結構與操作參數對氣含率的影響
  7. From the viewpoint of safety technology of chemical reaction with heat release. the technical causes of getting out of control of these reactors are analyzed. hazardous effects of the leakage of chemical reactants both on human and environment, and the existing problems in current safety technological measures are also discussed. the cooling method of jet vaporization based on the jet principle and the direct cooling by non - vaporized liquid are introduced. the development trends of the safety technology for chemical reactors are analyzed

    從放熱化學的安全技術觀點出發,分析了放熱化學失控的技術原因、化學物泄漏對人員和境造成的危害、現有安全技術措施存在的問題;介紹了基於射原理的噴射汽化和非汽化冷卻液體的直接冷卻方法;還展望了化學安全技術的發展方向。
  8. Abstract : from the viewpoint of safety technology of chemical reaction with heat release. the technical causes of getting out of control of these reactors are analyzed. hazardous effects of the leakage of chemical reactants both on human and environment, and the existing problems in current safety technological measures are also discussed. the cooling method of jet vaporization based on the jet principle and the direct cooling by non - vaporized liquid are introduced. the development trends of the safety technology for chemical reactors are analyzed

    文摘:從放熱化學的安全技術觀點出發,分析了放熱化學失控的技術原因、化學物泄漏對人員和境造成的危害、現有安全技術措施存在的問題;介紹了基於射原理的噴射汽化和非汽化冷卻液體的直接冷卻方法;還展望了化學安全技術的發展方向。
  9. Simulations of 2d and two - phase flow in a bubble column and an internal airlift loop reactor

    鼓泡塔與氣內循內兩相模擬
  10. The research progress of four kinds of continuous emulsion polymerization reactors : continuous stirred tank reactor, continuous loop tubular reactor, pulsed packed column and couette - taylor vortex flow reactor were reviewed with 14 references

    摘要介紹了4種主要連續乳液聚合的研究新進展,包括連續攪拌釜式、連續管式、脈沖填料塔式及庫愛特泰勒旋
  11. In this paper. flow properties of multistage fluidized - bed bioreactor with external circulation at a pilot scale is studied. according to characteristic analysis, the model of completely mixing reactor in series is introduced to characterize real reactor as a theoretical model. on the basis of analog computing analysis and discussion of theoretical model. by means of pulse tracer method, experiments on residence time distribution ( rtd ) have been done in different conditions including the change of tracer level, feeding flow rate and circulation flow rate. the result shows when the ratio of circulation flow rate and feeding flow rate amounts to at least 4, the flow properties of multistage fluidized - bed bioreactor with external circulation at a pilot scale is very close to the model of completely mixing reactor in series. an amendatory model has been established by the regression method

    作者首先在對進行特徵分析的基礎上,建立了描述中試規模多級外循化床生物動特性的串級全混模型,並對理論模型進行了模擬計算分析和討論,在此基礎上,作者分別在無循和有循(改變示蹤劑用量、量和循量)的條件下,利用脈沖示蹤法對一到五級串聯外循化床進行了停留時間分佈實驗,結果表明,在循量與量的比值達到大於等於4時,中試規模多級外循化床動特性接近串級全混模型,通過數據回歸擬合的方法,建立了中試規模一到五級串聯外循化床動模型。
  12. Local flow characteristics in the riser of an external - loop airlift reactor

    氣升式外環流反應器上升管中局部動特徵
  13. Axial dispersion and mixing behavior of a multi - compartment airlift loop reactor

    多室氣升式環流反應器的軸向分散及混合特性
  14. Local mass transfer coefficients and hydrodynamics in the airlift external loop reactor

    環流反應器動與局部傳質特性研究
  15. It was found that loop reactor could narrow the molecular weight distribution, increase the content of carbonate in product molecules and improve catalyst efficiency

    研究發現,環流反應器能夠使產品分子量分佈變窄,提高產品中碳酸酯基團含量及催化劑的催化效率。
  16. Poly ( propylene carbonate ) polyols was synthesized by the copolymerization of carbon dioxide with propylene oxide in the presence of double metallic catalyst in loop reactor

    摘要以二氧化碳3氧丙烷為原材料,在雙金屬氰化物催化劑催化下,利用環流反應器合成聚碳酸亞丙酯多元醇。
  17. Study on flow and heat transfer of double - loop anaerobic reactor

    雙循厭氧動及傳熱研究
  18. Hydrodynamics and mass transfer performance of high efficient inner loop bioreactor

    高效內循生物體力學與傳質特性
  19. Multistage fluidized - bed bioreactor with external circulation has been in use in the production of fuel alcohol by immobilized yeast cells technique. as a new - style reactor. it has the advantage of high conversion, complete reaction and little damage to immobilized yeast cells. flow properties is the foundation of reactor ' s physical transmission process. and it is the key factor of deciding whether the auxiliary material conversion is high or low. at present, the study on flow properties of multistage fluidized - bed bioreactor with external circulation at a pilot scale is rarely reported

    多級外循化床生物作為一種新型生物,由於具有轉化率高、徹底、對顆粒損傷少等優點在固定化細胞制取燃料酒精技術上得到用。但是,國內關于中試規模多級外循化床動特性的研究還很少,而動特性是物理傳遞過程的基礎,是研究物料在中轉化率高低的重要因素,因此,弄清楚外循化床動特性是非常重要的。
  20. The circulation of solids between two fluidized beds makes it possible to transport the vast quantities of heat produced or needed in large reactors.

    固體顆粒在兩個化床層之間循,使得大型中產生的或需供給的大量熱量有傳遞的可能。
分享友人