疲勞圖 的英文怎麼說

中文拼音 [láo]
疲勞圖 英文
palmograph
  • : 形容詞(疲乏; 勞累) tired; weary; exhausted
  • : Ⅰ動詞1 (勞動) work; labour 2 (煩勞) put sb to the trouble of; trouble sb with sth : 勞您費心...
  • : Ⅰ名詞1 (繪畫表現出的形象; 圖畫) picture; chart; drawing; map 2 (計劃) plan; scheme; attempt 3...
  • 疲勞 : 1. (疲乏勞累) tired; fatigued; weary; become fagged 2. (機能或反應能力減弱) fatigue; strain 3. [物理學] fatigue
  1. Attempting to improve power while fatigued is counterproductive

    時做功率訓練只會適得其反。
  2. In second part, a complete design and implement platform was constructed for sonic fatigue life analysis with the oriented - object programming design technique, as a replacement of nomograph method

    在本文的後半部分,為了代替目前常用的列線求解聲響應方法,著重運用面向對象程序設計技術,完成聲壽命預測及分析平臺的設計和實現。
  3. Being deficient in sonic fatigue testing and owing to the limitations of nomograph method application to the sonic fatigue life prediction, an analysis software program was designed and worked out in present thesis, based on the research achievement in prediction of sonic fatigue life, which strong function, easy use and great extensive capabilities

    本文針對現階段聲試驗的不足,以及工程中常用的諾謨方法的局限,整理了目前比較成熟的典型蒙皮壁板聲壽命研究成果,提出設計並編制了一套功能強、易於使用,可擴展性好的聲壽命預測及分析平臺。
  4. On the basis of the study of traffic features of heavy - load vehicles, the vehicle weight data and the axle - load spectrum of different vehicles were collected for some typical heavy - duty roads in china, and according to the features of heavy - loading pavement, deficiency of the former load - figure are analyzed and new figures which are suitable for heavy - load pavements are put forward. meanwhile, based on the research of the cement concrete fatigue equation and the damage mechanism of asphalt pavement under heavy - load vehicles, axle load conversion equations fitting for heavy - load cement concrete pavement and asphalt pavement are established respectively by further analysis. in addition, design indices, traffic and material parameters and structural combination for heavy - load pavements are discussed in this paper as well

    本課題針對重載道路路面設計中所存在的問題,從重載交通特性出發,收集分析了國內幾條重載道路的交通及軸載組成情況,根據重載交通的特點,分析原有荷載式的不足,提出了適合於重載瀝青、重載水泥混凝土路面的荷載式;同時,在重載水泥混凝土路面方程及重載瀝青路面破壞機理研究的基礎上,通過對重載路面軸載換算公式的進一步研究,分別提出了適合於重載水泥及重載瀝青路面的軸載換算公式;此外,本文還對重載水泥、重載瀝青路面的設計指標、交通參數、材料參數及結構組合等方面進行探討,系統地提出了重載路面的設計方法,並使之有效地運用到工程實踐中。
  5. Methods impedance pneumoplethysmogram ( ipg ) and impedance respirogram ( irg ) were detected in 64 cases of patients with phd, and investigate dmf rheogram positive rate, also analysed various parameters of ipg in positive and negative groups

    方法對64例肺心病患者進行呼吸阻抗和肺阻抗檢測,分組統計膈肌疲勞圖形陽性率;並對陽性組和陰性組進行肺阻抗各參數比較。
  6. Results ( 1 ) the positive rate of dmf. rheogram in phd with and without respiratory failure are 75 and 21. 9 respectively. ( 2 ) the positve rate in phd with and without heart failue are 80 and 46. 3 respectively. ( 3 ) the mean values of various parameters of ipg in positive and negative dmf rheogram have no significant difference. conclusion respiratory failure and heart falure in phd are closely correlated with dmf

    結果( 1 )肺心病伴與不伴呼衰組膈肌疲勞圖形陽性率分別為75與21 . 9 ; ( 2 )肺心病伴與不伴心衰組膈肌疲勞圖形陽性率分別為80與46 . 3 ; ( 3 )膈肌陽性組與陰性組肺阻抗各參數均值無顯著性差異。
  7. Analysis results of histogram statistics and section electron microscopic scan technique, are that fracture feature of the cracks of the hbbb is similar and the crack is multi - source strain fatigue one. internal defects of the cast, such as impurities, gas holes, etc, are the main causes for early cracks. the contrast analysis of static strength, model and transient respond on three structures with fem proves that geometrical stress concentration in partial area has influence on early crack, also

    利用直方等統計方法和電鏡掃描技術對該抱軸箱體裂紋分析的結果是:抱軸箱體的裂紋斷口特徵相近,裂紋性質屬于多源性低周裂紋,鑄件中的夾雜、氣孔等內部缺陷是導致過早裂損的主要原因;利用有限元法對該抱軸箱體三種結構的靜強度、模態和動態響應對比分析,證實了局部幾何性應力集中對過早裂損也有一定影響。
  8. The drawback of the system is the flicker problem which makes the eyes strain and affects stereoscopic perception

    系統的不足是觀看到的像存在著閃爍現象,容易使眼睛,影響立體效果。
  9. A series of static and fatigue experiments which include lots of specimens are performed on bolted composite laminates that include different sizes, different lay orientations and different torques. dye - enhanced x - radiography is used to check the progressive damage process as evaluation techniques, which can be made nondestructively. finally, the ultimate strength and fatigue life of composite bolted joints in static tension and

    層合板接頭的試驗研究考慮了多種幾何尺寸、多種鋪層及不同擰緊力矩對其靜強度及性能的影響,同時使用滲透劑增強的x射線象技術對靜載和損傷擴展及累積過程進行了無損檢測,並對其進行了分析探討。
  10. The damage parameter versus fatigue life figures, which were plotted based on the stress - strain analysis and test results, could be used to predict the fatigue lives of the composite with different winding angles

    根據雙軸載荷條件下管狀試樣的應力-應變分析及雙軸實驗結果,繪制出了基於臨界平面的多軸損傷參量與壽命關系,可對不同纏繞角的復合材料壽命進行預測。
  11. This article introduces gray image processing technology. firstly, in order to eliminate noise, optimize image and get precise edge feature, a series of preparations can be done to fracture image such as histogram equalization, binarization, edge enhancement, and so on

    本文採用灰度像處理技術,首先對斷口像進行直方均衡化、二值化、邊緣增強等預處理來消除噪聲,優化像,以得到精確的邊緣特徵。
  12. During the experiment, the fatigue - loading was paused after fixed fatigue cycle and the white - light speckle patterns were acquired without loading

    加載過程中,按一定的周次在零載荷狀態下停機,並採集試件表面上預先制備的白光散斑
  13. A mean strain or prestrain, as in fig. 83, can under certain conditions reduce the subsequent fatigue life.

    一個如83所示的平均應變或預應變,在某種情況下,能夠縮短以後的壽命。
  14. Aim at the problems of manual measuring of cattle ' s shape parameters : low efficiency, low precision, the results easily effected by the technique level and fatigue level of worker, and the precision of measure tools, the research used computer vision technology to measure the main shape parameters of cattle. and the research setup a information management system to manage image information

    研究針對肉牛體型參數人工測量效率低,而且測量精度不高,測量結果易受測量者技術水平、程度和測量儀器本身精度的制約等問題,應用計算機視覺技術進行肉牛主要體型參數的測量,並基於web對像信息進行管理。
  15. Some hardware are used to construct data acquisition system, virtual instrument are used to compile data processing programs. just as expected, according to standard of iec61400 - 13, some diagram and curve are depicted in the end of dissertation, and program can provide life prediction method of wind turbine from damage theories in the end of dissertation

    載荷測試系統通過一定的硬體系統採集相關數據,在數據分析方面使用虛擬儀器軟體進行數據處理,使用功能強大的labview軟體編程,得到iec61400 - 13標準中所要求的曲線和表,最後根據損傷理論得到機械部件的載荷譜和壽命的估算方法。
  16. Steel, concrete and composite bridges - charts for classification of details for fatigue

    鋼,混凝土和組合材料橋梁.的詳細分類
  17. As we know, manual decision method estimate specific value of stained area, and so in a large quantity of measuring, because of human factor of fatigue and so on, maybe generate misjudgement condition, computer can probably reduce productive probability of the mistake

    人工檢瀏方法是大概的估計染色的面積比。在大量的檢瀏中,由於等因素可能產生人工誤判等情況。計算機像識別和理解是以像素的個數表示區域的面積,保證了檢測精度。
  18. If deemed necessary it will activate the audible and visual alarms to inform the driver that they are starting to show the early signs of fatigue

    如果認為必要,該裝置會激活聲音和像警報,以提醒司機他們已開始表現出的早期跡象。
  19. The four parameters ( spring inclination a, the frequency of excitation force w, the amplitude of excitation force f, the spring stiffness k ) are the major factors that take great influences on the vibration plate. in order to analyzing the influences of four parameters, the virtual prototype of vibration plate is built in ansys to get inherent frequency from modal analysis. thorough transient analysis in ansys, the curves of displacement n velocity and acceleration is presented

    為了分析這四個參數對系統的影響,首先在ansys中建立振動排秧盤的虛擬模型,採用有限元方法對模型進行了模態分析,得到振動排秧機構的固有頻率;同時對模型進行動力學分析,分析排秧盤的振動量、速度及加速度,並得出相應數據的曲線;另外,校核了主要元件彈簧的強度及使用壽命。
  20. Wavelet decomposition : db4 wavelet decomposition and energy norm l1 was employed to extract feature of zr - 4 alloy images. with the selected wavelet db4, features at different frequency channels of life span were gotten. then an energy change at the direction of fracture extension was studied to find the relationship between the feature and life - span. fractal algorithm : feature of image at different channel was extract after wavelet transform

    基於小波分解的斷口像的分析,首先提取鋯- 4合金低周斷口紋理像的特徵,實驗確定了db4小波分解和l1能量的計算方法,求得不同壽命的斷口像在各個頻率通道的特徵值,斷口像的變化反映在特徵值的變化,這為像的壽命分析提供了一種有效的手段。
分享友人