直控制 的英文怎麼說

中文拼音 [zhíkòngzhì]
直控制 英文
sight control
  • 直 : Ⅰ形容詞1 （成直線的; 硬挺的） straight; stiff 2 （跟地面垂直的; 從上到下的; 從前到后的） erect; v...
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. The winners were given one minute to deliver their acceptance speech, with the time limit strictly policed by an outspoken eight - year - old girl

    獲獎者均擁有一分鐘的時間發表獲獎感言，時間由一位心直口快的8歲女孩嚴格控制。
  2. This paper integrates direct lateral force control with aerodynamic control, taking the anti - aircraft missile which has the anti - guided ability in the aerosphere as research subject

    本文的研究對象為大氣層內具有反導能力的防空導彈。主要研究內容為把直接側向力控制與氣動力控制結合。
  3. The high precise straight - moving work - bench with the active controlled air bearings

    主動控制空氣靜壓精密直移工作臺系統的研究
  4. On the basis of that, this article refine upon the storage ' s organizational construct and put forward the means of quality improvement that include inner auditing of quality management system, reject control, amendatory and precautionary measures ; and so on

    本文運用iso9000族標準、質量管理控制工具、統計過程式控制制方法和系統工程相關理論對西安大明宮直屬庫質量管理體系進行了系統分析和優化設計。
  5. Ankylosing spondylitis and current disease - controlling agents : do they work

    當前的控制藥物對強直脊柱炎有效嗎？
  6. The landing of a helicopter in autorotation is formulated as a nonlinear optimal control problem

    本文將直升機的自轉著陸過程定義為一個非線性的最優控制問題。
  7. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子，並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測；並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除；動態數據讀取和波形測試和故障模擬等。此外，本論文還分析了傳感器和執行器典型故障波形。
  8. Depend on the comprehensive analysis and study of the structure, principle, and exterior characteristic of the motor, through the methods of system modeling and digital simulation analysis, two kind of control device that work for the low voltage ( lvdc ) and the high voltage ( hvdc ) in avigation are researched respectively. point to the control technique of close - loop speed stabilization at a limited adjustment speed range, we bring out the close - loop speed control method that using the rotor position sensor indirectly measure the speed of the motor

    在全面分析了稀土永磁無刷直流電動機的結構特點、工作原理、運行方式以及外部特性的基礎上，通過系統建模和數字模擬分析，分別針對航空低壓直流（ lvdc ）和高壓直流（ hvdc ）兩種電動機構用永磁無刷電動機，在小范圍轉速連續調節下的閉環穩速控制技術進行了詳細理論研究，提出了利用轉子位置傳感器信號間接測量電機轉速進行電機轉速閉環穩速控制的策略。
  9. This paper is based on " the remodeled item of the 122mm automatic barbette servo system ". it introduced the controlled project of brushless direct current motor realized by dsp at first. on the base of analyzing and studying the driving wave of the brushless direct current motor thoroughly and fully, it carried on the servo system ' s simulink and presented the concrete software and hardware ' s devise of the whole system in the end

    本論文的撰寫是以「 122mm自行迫榴炮伺服控制系統的改型項目」為基礎，首先介紹了dsp實現無刷直流電機的控制方案，在深入、系統的分析和研究了無刷直流電機驅動波形的基礎上，然後進行了伺服控制系統的模擬，最後給出了伺服控制系統具體的軟硬體設計。
  10. In proc. acm symposium on solid and physical modeling spm 05, boston, usa, 2005, pp. 27 - 38. 5 c de boor

    主要原因在於1使用者必須處理大量的非規則分佈的控制點和節點，這種操作異常繁瑣並且很不直觀。
  11. Mason was fairly beside himself with rage.

    梅森火冒三丈，簡直控制不住了。
  12. At the sight of the unutterable passion of that look i could hardly control myself.

    看見那種說不出的苦悶的神情，我簡直控制不住自己了。
  13. I had a fit of rage -- i could hardly control myself.

    我勃然大怒，簡直控制不住自己。
  14. Ever since the birth control policy introduction, little emperors have started to reign over three - generation families

    自從實行計劃生育政策以來， 「小皇帝」就一直控制著一家三代。
  15. “ we started out well, controlling the game, but then we conceded too many spaces, ” said paro in a press conference on tuesday

    "我們開局很好，一直控制著比賽節奏，然而當我們讓出太多控制權的時候， "帕羅在星期二的新聞發布會上說道
  16. Tick marks are located on the top of a horizontal control or on the left of a vertical control

    刻度線位於水平控制項的頂部或垂直控制項的左側。
  17. Tick marks are located on the bottom of a horizontal control or on the right side of a vertical control

    刻度線位於水平控制項的底部或垂直控制項的右側。
  18. In many years, automobile industry of our province always is at the low - end position of value chain of the international labor division in joint investment with foreign enterprises, general development profit level is not high, competitiveness in production cost and product price are left behind in the world, so we always obtain processing profit instead of excess profit ; design and production technology of entire cars and component products are left far behind with international advanced level, development of components is severely lagging from the development of the entire cars, especially transnational companies always control procurement of components with high technical content and added value, so we have to import components with key technology

    多年來我省汽車產業在與國外企業合資中一直處于國際分工價值鏈的低端位置，總體發展利潤水平不高，生產成本與產品價格遠未達到與國際接軌的競爭實力，我們獲得的一直是加工利潤，而不是超額利潤；整車和零部件產品設計和製造工藝上同國際先進水平尚有較為明顯的差距，零部件的發展嚴重滯後於整車的發展，尤其是跨國公司一直控制著高技術含量、高附加值零部件的采購，使具有核心技術的零部件一直從國外進口。
  19. Method, your component will continue to hold its resources during this interval

    方法，則在這段間隔期內，組件將一直控制其資源。
  20. Vertical controls operate independently from other controls and have their own set of events, properties, and methods

    （垂直）控制項的操作與其他控制項無關，它們有自己的一組事件、屬性和方法。
分享友人
分享到 Line

分享到臉書