直流電動機 的英文怎麼說

中文拼音 [zhíliúdiàndòngjī]
直流電動機 英文
continuous current electromotor
  • 直 : Ⅰ形容詞1 （成直線的; 硬挺的） straight; stiff 2 （跟地面垂直的; 從上到下的; 從前到后的） erect; v...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 機 : machineengine
  • 直流 : direct current （dc）; constant current; steady current; continuous current; zero frequency curre...
  • 電動機 : electric motor; motor （俗稱「馬達; 電滾子」）電動機並聯法 parallel connection of the motors; 電...
  • 電動 : motor driven; power driven; power operated電動擺 motor pendulum; 電動扳手 electric wrench; 電動泵...
  1. Depend on the comprehensive analysis and study of the structure, principle, and exterior characteristic of the motor, through the methods of system modeling and digital simulation analysis, two kind of control device that work for the low voltage ( lvdc ) and the high voltage ( hvdc ) in avigation are researched respectively. point to the control technique of close - loop speed stabilization at a limited adjustment speed range, we bring out the close - loop speed control method that using the rotor position sensor indirectly measure the speed of the motor

    在全面分析了稀土永磁無刷直流電動機的結構特點、工作原理、運行方式以及外部特性的基礎上，通過系統建模和數字模擬分析，分別針對航空低壓直流（ lvdc ）和高壓直流（ hvdc ）兩種電動機構用永磁無刷電動機，在小范圍轉速連續調節下的閉環穩速控制技術進行了詳細理論研究，提出了利用轉子位置傳感器信號間接測量電機轉速進行電機轉速閉環穩速控制的策略。
  2. A several of rubber bar magnet for dc micro - motor is discussed in this paper. and engineering tests is introduced which are needed in production of rubber bar magnets and micro - motors

    摘要論述微型直流電動機中使用的橡塑磁條的特性，以及在磁條生產廠和電機製造過程需要進行的工程檢驗。
  3. Analysis of the equivalent capacitive property about dc motor

    直流電動機等效電容特性分析
  4. Development of control technology of brushless direct current motor

    無刷直流電動機控制技術研究
  5. Technical requirements for the z series of medium size direct current motor

    Z系列中型直流電動機.技術條件
  6. Using the color sensor as the navigation sensor, with mcu for control centre, the robot is drived and change direction by the differ direct current motor

    用顏色傳感器作為導航傳感器，以單片機為控制器，直流電動機實現驅動和差動轉向。
  7. This paper presents the method of design and parameter optimizing in a phase - locked controller, which is used in high - speed brushless direct current motor ( bldcm ) speed control

    摘要提出一種用於高速無刷直流電動機鎖相速度控制器設計和參數優化方法。
  8. The experiment results indicate that this method is more effective in the brushless direct current motor ' s low speed torque ripple attenuation, and its more effective in improving system dynamic performance

    運行結果表明，此方案能有效地抑制無刷直流電動機低速時的轉矩脈動，更好地改善系統的動態性能。
  9. Realizing method of magnetization curve on dc electromotor

    直流電動機磁化曲線的實現方法
  10. Ssr - dd series of dc solid relay is vastly applied to output joggle of computer and external equipments, it is also applied to control or switch dc load : dc relay 、 contactor 、 dc electrical motor 、 kinds of electric - heating apparatus 、 dc electromagnetic valve 、 electromagnetic iron 、 solenoid 、 filament lamp 、 indication lamp 、 plc logical electrical appliance and dc solid relay

    Dd系列直流固態繼電器廣泛應用於計算機與外部設備的輸出介面，適用與控制或開關直流負載：直流繼電，接觸器、直流電動機、各類電熱器具；直流電磁閥，電磁鐵、螺線管、白熾燈、指示燈； plc邏輯電器。
  11. Research of non - linearity in brushless dc motor system

    無刷直流電動機系統非線性研究
  12. Research on the vibration and noise of the minitype brushless dc motor

    小型無刷直流電動機振動與噪聲的研究
  13. The thesis roots in the item supported by " fifteen " aviation funds, - new type aeronautic linear dc motor ( ldcm ), study its classes characteristics and work principle, mainly researches the drive and control technique of aeronautic linear dc step motor ( ldcsm ) using in emergency discharging oil valve on airplane

    本文源於「十五」航空支撐基金項目-新型航空用直線直流電動機。論文研究了直線直流電動機的分類、特點及其工作原理，重點針對飛機應急放油閥用航空直線直流步進電動機驅動控制技術進行了研究。
  14. For the bldcm which has a pseudo - sinusoidal back - emf waveform, this dissertation presents a svpwm control method using six discrete position signals for minimizing the torque ripple. the main aspects for the implementation of this method are analyzed, including the initial orientation of the voltage vector, reasonable choice of the impedance angle and the advance commutation angle, and estimation of the successive rotor positions

    針對反電動勢類似正弦的準正弦波反電動勢無刷直流電動機，本文提出一種基於六個離散位置信號的自同步svpwm （電壓空間矢量法）控制方法，用以削弱電磁轉矩脈動，分析了實現這種方法的主要控制環節，包括起動時電壓空間矢量的初始定位，阻抗角與電流超前角的合理選擇以及連續轉子位置的估計等。
  15. The simulation results prove that this control technique can effectively minimize the torque ripple for the bldcm drives whose back - emf waveform crest width is less than 120

    模擬結果表明這種控制策略能有效地抑制反電動勢平頂寬度小於120電角的無刷直流電動機的換相轉矩脈動。
  16. Furthermore, this dissertation also gives a comprehensive analysis and comparison to the torque ripple factor, torque - current ratio and other aspects for pseudo - sinusoidal emf bldcm drived by 120 conduction mode, 180 conduction mode and self - synchronous svpwm mode respectively. the simulation and the experimental results indicate that self - synchronous svpwm method is more effective for minimizing the torque ripple without any expense of the torque - current ratio when the crest width of the back - emf waveform is less than 107 electrical angles

    對準正弦波反電動勢無刷直流電動機在120導通方式、 180導通方式和自同步svpwm三種控制方式下的轉矩脈動系數、轉矩電流比等方面進行了全面的分析與比較，模擬研究和實驗結果表明，當反電動勢的平頂寬度小於107電角時，採用自同步svpwm控制方法可以在不損失轉矩電流比的基礎上，更有效地抑制電磁轉矩脈動。
  17. Development of electromechanical actuation system for flight control is one of the most important technologies in the path to all - electric airplane

    摘要飛行控制中機電作動系統的發展是全電飛機的重要技術之一，而高速大功率密度的無刷直流電動機是其中的關鍵部件。
  18. Digital signal processor ( dsp ) combined with repm bldcm, which build up a dc adjustable speed system, achieve to control multiple motor speed, positive and negative rotate, protect and fault exemine by a true single chip. design and present a electromagnetism scheme of repm bldcm used in electromotion chair drive system. select electronical components and chips in the drive board by contrast with variant drive mode. design the drive board principle picture, make a drive board pcb and debug it. design a principle picture with dsp core. workout the motor control code introduced popular programme modle. test the programme reliability and control performance by linking tms320lf2407 evm, pc, drive borad and the bldcm. the bldcm swatch is prepare experiment

    本論文闡述了方波驅動稀土永磁無刷直流電動機的原理及數學模型；設計並給出了一種電動座椅用稀土永磁無刷直流電動機的電磁設計方案；對電機採用何種驅動方式進行了對比分析；對驅動電路進行了元器件選型、原理圖設計、制板及調試；有針對性的闡述了dsp在本系統應用中所涉及到的功能模塊；設計了以dsp為核心的控制電路原理圖；以模塊化的軟體編程思想編制了電機控制軟體；通過tms320lf2407目標板、上位機、驅動板及電機的聯調，證明了系統可行。
  19. The method of compond target function variable weighting was adopted for solving compond target optimization problem, and compond target was put into single target

    在計算中，為達到無刷直流電動機全局優化的目的，採用隨機產生離散初始種群及隨機交叉操作和變異操作方法。
  20. 3. with fourier decomposition, the main component of pulsating torque, torque ripple is studied. it can be determined that torque ripple is caused by harmonic order 6n under the usual common conditions

    3 、對造成轉矩脈動的主要成分轉矩紋波進行諧波分析，得出在一般假設情況下，無刷直流電動機系統的轉矩紋波由電磁轉矩的6n次諧波造成的結論。
分享友人
分享到 Line

分享到臉書