直流電橋 的英文怎麼說

中文拼音 [zhíliúdiànqiáo]
直流電橋 英文
dc bridge
  • 直 : Ⅰ形容詞1 （成直線的; 硬挺的） straight; stiff 2 （跟地面垂直的; 從上到下的; 從前到后的） erect; v...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 橋 : 名詞1. （橋梁） bridge 2. （姓氏） a surname
  • 直流 : direct current （dc）; constant current; steady current; continuous current; zero frequency curre...
  1. A circuit topology of the inverter with duty cycle extended active clamp forward style high frequency pulse dc link is adopted by each independent inverter. each inverter is cascaded by a circuit with duty cycle extended active clamp forward style high frequency pulse dc link and a dc / ac inverting bridge. the control strategy of voltage mode pwm forwardback is adopted by the former, and the control strategy of three - state discrete pulse modulation ( dpm ) hystersis current is adopted by the later

    每個獨立的航空靜止變流器採用占空比擴展有源箝位正激式高頻脈沖直流環節電路拓撲，由占空比擴展有源箝位正激式高頻脈沖直流環節電路與dc ac逆變橋級聯而成，前級採用電壓型pwm前饋控制技術，后級採用三態dpm電流滯環控制技術。
  2. This paper selects dc double - arm bridge, uses the four - port connection to remove the contact and connection resistances and reduce the electromagnetism interfere. grounding grid conductors fault levels are established during a lot of emulational computations, simulative experiments

    使用直流雙臂電橋，採用四端鈕連接法，可大大降低現場中電磁干擾及引線電阻和接觸電阻的誤差影響。
  3. Output voltage and current is often distorted in half bridge converter because voltage unbalance of input capacitors though its application is very abroad

    摘要半橋逆變器應用廣泛，但存在直流分壓電容不均壓，使分壓電容中點電壓漂移，導致輸出電壓和電流畸變的缺點。
  4. Verification regulation of dc comparator bridge

    直流比較儀式電橋檢定規程
  5. Second, the results of theory analysis and simulation research show that the output of one cycle controlled bridge switching power amplifier have dc offset because of the nonideal characteristic of reset signal. the magnitude of output dc offset voltage is proportional to width of reset pulse. a voltage compensation technique is used to solve this question, and the computation formula of compensation voltage is gived. the circuit compensated and not are researched through simulation and experiment, which results show that compensated circuit solve the output dc offset effectively

    其次，理論分析和模擬研究結果表明，由於復位脈沖的非理想特性，單周控制的全橋開關功率放大器輸出端存在直流偏置問題，其大小與復位脈沖的寬度成正比。針對輸出直流偏置問題，提出了電壓補償的改進方案，給出了補償電壓的具體計算公式。對補償前和補償后的方案進行了對比模擬研究和實驗研究。
  6. At last, control circuit of one cycle controlled bridge switching power amplifier is improved with the basic idea of one cycle control. the simulation results show that the amplifier of improved control circuit not only solve the question of output dc offset, but also keep the voltage gain lowered by voltage compensation technique

    最後，根據單周控制的基本思路，改進了單周控制的全橋開關功率放大器的控制電路。模擬結果表明，改進控制電路后的系統不但解決了輸出直流偏置問題，而且解決了電壓補償方法所造成的放大器增益下降問題。
  7. During the circuit design, the author analyzed the basic principle of the direct current motor, pwm control, h - bridge power driver, and two control techniques of h - bridge power drive circuit, designed its general structure, so the feasibility of the design is confirmed. then, reference, oscillator, power dmos gate drive circuit ( charge pump, bootstrap ), and dead time generation circuit are designed and analyzed in the sub - circuits. a current - controlled oscillator is presented in this thesis

    在電路設計中，作者介紹了直流電機的工作原理和數學模型、脈寬調制（ pwm ）控制原理、 h橋電路基本原理和h橋功率驅動電路的兩種控制模式，設計了驅動電路的總體結構，給出了電路的功能模塊，確定了設計的可行性，然後在子電路模塊中，重點分析設計了基準源電路、振蕩器電路、高端功率管柵驅動電路（電荷泵及自舉電路） 、低端功率管柵驅動電路和死區時間產生電路。
  8. Resistance thermometer bridges may be excited from either a-c or d-c sources.

    電阻溫度計電橋的供電可以是交流電源，也可以是直流電源。
  9. The high frequency inverter power can invert 75 - 130 volt vibrating dc voltage which come from battery charge into 110 volt, 20khz ac voltage. the control of high frequency inverter power consists of two parts : chopper control and inverter control

    給出了直流斬波電路及全橋逆變電路的工作原理，此高頻逆變電源可將75 130v的蓄電池直流電壓逆變為110v ， 20khz的交流電壓。
  10. Dc bridges for measuring resistance ; amendment 2

    電阻測量用直流電橋.第2次修訂
  11. D. c. bridges for measuring resistance

    電阻測量用直流電橋
  12. Discuss the dc adjust voltage and timing system simulator process and way of the container crane, which containing the dc motor drive and drivers " select, drivers connection and control

    ?集裝箱裝卸橋直流調壓調速系統模擬過程及方法，其中包括直流電機傳動及驅動器選擇、驅動器接線與控制。
  13. In this paper phase shift full bridge sreies - parallel resonant converter is expatiated witch is good project for design of high - voltage high - power power at present. besides those we discussed basic process and practical rc load model of sreies - parallel resonant converter

    論文闡述了移相控制的全橋串並聯諧振變換器，目前它是滿足高效、高功率密度、高壓大功率直流電源設計的一種很好技術方案；本文闡述了運用基波分析方法建立的串並聯諧振變換器的等效電路模型。
  14. In the design, the four mechanisms use dc speed adjustment, and select the advanced rtv - 84 series dc motor speed controller of french te company and the series 90 - 30 programmable controller of american ge company. the perfect unites of these two forms the nucleus of the whole control system

    設計中，四大機構的驅動方案採用全數字直流調速，並且選用了法國te公司先進的rtv - 84系列直流電機速度控制器以及美國ge公司的系列90 - 30plc可編程序控制器，這二者的完美結合，構成了集裝箱裝卸橋的全數字控制系統的核心。
  15. In this thesis, an h - bridge power drive integrated circuit has been analyzed, designed and taped - out. it is a typical spic, which could be widely used in stepper motor drive, position and velocity servomechanism, industrial automaton, various numerical controlled equipments, printers and plotters control and other applications

    本文分析、設計了一種廣泛應用於直流電機和步進馬達驅動、位置與速度伺服系統、工業機器人、各種數控設備和印表機和繪圖儀等中的spic電路? ?單片h橋功率驅動集成電路，並對此電路進行了流片。
  16. In the design of real - time control system, the paper takes three - phase full - bridge mosfet inverter as the real - time control main circuit, and adopts a control scheme with 120 ? switching mode combined with half - bridge pulse width modulation ( pwm ), which would avoid straightthrough short of a certain bridge. phase current is detected by single current sensor ; three - phase position signals generated by position sensors could not only supply commutation information for inverter, but also be used for speed detecting based on signals " period measurement, which makes the speed sensor unnecessary. the whole control system adopts speed and current dual closed - loop control strategy in order to construct a high performance rare - earth permanent magnetic brushless dc motor ( repm bldcm ) full - digital real - time control system

    在實時控制系統的設計中，本文以三相全橋mosfet逆變電路作為實時控制主電路，採用120導通方式結合半橋pwm調制的控制方案，從而有效地避免了橋臂的直通短路；本文用單電流傳感器實現對相電流的檢測，來自位置傳感器的三相位置信號不僅為逆變電路提供換相信息，而且也用於基於信號周期測量的轉速檢測，這樣就省去了速度傳感器；系統採用的是速度、電流雙閉環控制策略，力求構建高性能的稀土永磁無刷直流電動機全數字實時控制系統。
  17. The portable dc bridge is a device for measuring resistance that be applied widely to field - testing of electric power system

    摘要攜帶式直流電橋是一種電隊測量儀器，在電力系統現場測試中應用極廣。
  18. D. c. bridge for measuring resistance

    測量電阻用的直流電橋
  19. Firstly, the thesis introduced a eoct scheme that supplied on a special coil. it utilized saturation of special coil to transform form 10a ~ 720a current of busbar to 8v ~ 40v voltage of inductions. after switched to direct current, it supplied the loads of sensor by dc - dc transformations, which is included two + 5v voltages with respective ground and a group of 12v voltage

    該供能方案利用特製線圈的飽和特性，將母線電流大致在10a ~ 720a的電流感應約為8v ~ 40v的電壓能量，利用整流橋將交流電變為直流電后，由dc - dc變換器件將其轉換為兩路不共地的+ 5v和一組12v電壓供給後端傳感頭。
  20. Abstract : the multifunctional inverter power sourcethe handy inverter welding, plating & charging manchine, developed with advanced inverter and micro - electronics control techniques, adopts “ half - bridge power expansion supply midpoint voltage autocontrol setting ”, and technically and effectively having solved inverter subvision of inverter power expansion circuit for leaning magnetism, reliability of high - power inverter setting, achives combination of constantcurrent and constantvoltage export, and realizes low - voltage dc and high - voltage ac double power supply

    文摘:運用先進的高頻逆變技術和微電子控制技術設計研製的逆變式多功能電源便攜式逆變焊鍍充電多用機，採用「半橋式功放級供電中點電壓自動控制調節裝置」 ，在技術上解決了逆變功放電路因偏磁而造成的逆變顛覆，有效地解決了大功率逆變器的可靠性問題；進行多種外特性的綜合設定，實現了恆流與恆壓輸出的合一；與傳統焊機相比，實現了開環和閉環狀態下都互不影響的低壓直流電瓶和高壓交流雙供電
分享友人
分享到 Line

分享到臉書