直通電流偏置 的英文怎麼說

中文拼音 [zhítōngdiànliúpiānzhì]
直通電流偏置 英文
through current bias
  • 直 : Ⅰ形容詞1 （成直線的; 硬挺的） straight; stiff 2 （跟地面垂直的; 從上到下的; 從前到后的） erect; v...
  • 通 : 通量詞（用於動作）
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 偏 : Ⅰ形容詞1 （不正; 歪斜） inclined to one side; slanting; leaning 2 （只側重一面） partial; prejudi...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 直通 : direct connection; straight in
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. First, passive resistance network was selected as direct current biasing network, which offered direct voltage for base through the resistance voltage divider composed of two resistances, among them the upper resistance connected from the dc to base, the lower resistance connected from the base to ground. the collector connected with dc directly

    直流偏置網路採用無源電阻網路，通過由兩個電阻組成的電阻分壓器為基極提供直流電壓，上偏電阻從電源串聯到基極，下偏電阻從基極到地，集電極直接加電。
  2. While simulating the resonant circuits, we finished a microstrip resonance, which has high q - factor and fits to design w - band low phase noise oscillators. select beam lead hyperabrupt junction varactor and gunn die made in china as vco ’ s frequency turning component and minus resistance

    此外，文中還對w頻段微帶結構直流偏置網路、微帶波導過渡等外圍電路進行了模擬優化，設計方法和結論對毫米波微帶電路設計具有通用的參考價值。
  3. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流，兩者產生的偏置磁場在控制線圈產生感應信號，檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號，該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號，再由pid控制器轉換為轉子位移的控制信號，最後控制信號輸入功放電路產生控制電流，實現閉環控制。
  4. The low insertion loss is achieved by optimizing the transistor widths and bias voltages, by minimizing the substrate resistances, and by dc biasing the transmit and receive nodes, which decreases the capacitances while increasing the p1db

    通過優化mosfet的柵寬及偏置電壓可以降低插入損耗。在版圖設計中通過增加襯底接觸降低襯底電阻，從而減小插入損耗。另外，為接收和發送端提供直流偏置可以降低p1db 。
  5. In charter iii, the author designed a set of direct current bias and a schematics for measuring signal, by which the character of conduction of the laser plasma in electrical field caused by bias was studied

    第三章中本文作者自己設計了一套直流偏壓裝置及信號測量裝置及方案，從激光等離子體在偏壓電場作用下的導通特性測量，研究了偏壓對激光等離子體空間膨脹過程的影響機理。
  6. The open - looped driving circuit is based on the idealization of the vibration. the square wave voltage and the direct current voltage are combined to drive the gyroscope. influences of square wave voltage are analyzed though simulation. as for the real situation of the vibration, the closed - looped driving circuit is given

    開環電路採用方波加直流偏置的等效交流電壓驅動陀螺振動，通過模擬分析了方波驅動形式對陀螺振動的影響；結合開環驅動電路，提出了閉環驅動電路方案。
分享友人
分享到 Line

分享到臉書