相同條件 的英文怎麼說

中文拼音 [xiāngtóngtiáojiàn]
相同條件 英文
identical conditions
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 條 : Ⅰ名詞1 （細長的樹枝） twig 2 （條子） slip; strip 3 （分項目的） item; article 4 （層次; 秩序; 條...
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  • 相同 : identical; the same; alike; equal
  • 條件 : 1. （客觀的因素） condition; term; factor 2. （提出的要求） requirement; prerequisite; qualification
  1. In this paper, the time property of its anode and dynode outputs has been studied and compared by using weak cherenkov light, the results show that their time resolution is dependent on the number of the electrons collected at the same conditions

    為了獲得多個倍增極的輸出信號，對其進行了相應的改進，利用弱契倫科夫光，研究了其陽極和倍增極的時間特性，並作了比較，結果表明相同條件下它們的時間分辨與所收集的電子數有很大關系。
  2. Experiment results indicated that this method had relatively high fault - partition concentration and faultfinding probability, and its effectiveness was better than random testing in the same conditions

    實驗結果表明，該方法分割錯誤元素的集中度以及命中錯誤的概率較高，相同條件下其效果要優于隨機測試。
  3. Under the same controlled parameters conditions, the paper study out five possible projects for the magnetic levitation guideway girder

    在軌道梁基本參數相同條件下，擬定了五種可能的磁懸浮軌道梁結構方案。
  4. Fourth, the electrorheoldgical fluids composed of pan / batio3 nanocomposite and chlorated paraffin oil are prepared and the relationship between dielectric performance and electrorheological effect are discussed. fifth, the advantage and disadvantage of electrorheological fluids composed of different structure pan - batio3 nanocomposite are compared, which put a favorable basis for farther design and prepare electrorheological fluid with high performance

    研究結果表明：鈦酸鋇納米粉末在900處理時為最佳，隨熱處理溫度的升高，粒徑長大，而其介電常數隨著粒徑長大，逐漸降低，在相同條件下，隨溫度的升高，鈦酸鋇納米粉末的介電常數在120出現最大值。
  5. At the same temperature, the as - cast lead brass has the finer prolongation at the higher velocity

    在溫度相同條件下，在較高的拉伸速度下獲得了大伸長率。
  6. From the measurements of cyclic voltammetry and galvanostatic charge / discharge, the composite electrode had higher specific capacitance ( 0. 84f / cm2 ) than pure mwnt array electrode ( 0. 38f / cm2 ) in the same experimental conditions. a kind of linear elementary carbon with the similar structure to carbyne was prepared by a new method. the sample appeared to be winding lines with the diameter of around 0. 2 run in the magnified image of the high resolution transmission electron microscope ( hrtem )

    掃描電子顯微鏡表徵結果顯示，聚吡咯比較均勻地附於碳納米管的表面；通過比較復合電極和純mwnts陣列電極在相同條件下的循環伏安和恆電流充放電實驗結果得知，前者的比電容（ 0 . 84f / cm ~ 2 ）明顯高於後者（ 0 . 38f / em ~ 2 ） 。
  7. On the other hand, a set of if - then conditional rules is induced to examine the relationships among attributes values. the non - stationary model also applies to the association analysis, which means the anomaly value of an attribute a ssumes a novel value under certain conditions depends on the last occurrence of novel value of the same attribute under same conditions

    本文還採用if - then形式的規則對所考察的多個屬性進行關聯分析，並對規則運用上述動態模型，即某一條件下某屬性取得新值的異常值與相同條件下該屬性上次取得新值以來的時間長度有關。
  8. In this paper, the program ls - dyna was used. the model was validated by simulating the tibia three - point bending test and lower extremity sheering and bending tests

    模型的有效性通過模擬脛骨的彎曲實驗和下肢的剪切與彎曲實驗，並比照相同條件下的生物試驗結果驗證。
  9. The fundamental mode beam has been gotten. the power output of u - folded laser without catalyzer, 3. 5w has been gotten, while the corresponding unfolded laser, 4. 5 w. this result indicates the availability of the forementioned design

    在無催化劑的情況下，獲得u型腔激光器輸出功率3 . 5w和相同條件下的直線型激光器輸出功率4 . 5w ，證實了該u型腔設計的可行性。
  10. The results show that the printing press assuring best printing ink absorbency of paper is dissimilar at different printing speed conditions, the glazed printing paper ' s printing ink absorbency is more sensitive than the coated art paper to printing press, and at the same condition, the coated art paper press ' s demand is lower than the glazed printing paper

    結果表明，在不同印刷速度下保證紙張最佳吸墨性的壓力值是不同的，膠版紙的吸墨性對印刷壓力比較敏感；在相同條件下，銅版紙對印刷壓力的要求低於膠版紙。
  11. In the end, the situations of work done by aerodynamic forces on blade surfaces when flow - structure is coupled and is n ' t coupled under the same conditions are compared, the result indicates that the work done by aerodynamic forces after the coupling restraint is unloaded has a distinct change

    本文最後比較了相同條件下氣固耦合與非耦合時葉表氣動力的做功情況，其結果表明解除耦合約束后氣動力做功有顯著變化，為深入研究振動葉柵流場，必須考慮葉片結構動力因素。
  12. The reaction of ethyl allylacetoacetate with polyfluoroalkyl iodides under similar conditions gave the corresponding adducts, which were sequentially treated with base to the cycization products

    在相同條件下，烯丙基乙酰乙酸乙酯與多氟烷基碘代烷反應得到相應的加成物，加成物隨後用堿處理也得到環合的產物。
  13. It is evident from above two expressions when the btl circuit and the ocl circuit operate under same power supply voltage and same load, the output power of the former is four times of that for the latter

    對比以上二式不難看出：橋式電路和單端電路在電源電壓和負載相同條件下，前者的輸出功率為後者的四倍。
  14. After designing oil ditches on the surface of its arc - block, increase friction factor and make sure self - lock which solves above problem. do qualitative analysis to lower pair and one - way overrunning clutch and inner star - wheel - roller overrunning clutch by using self - made lever loader. the experiment shows : on the same condition, the deformation of new overrunning clutch ’ s surface contact with lower pair is smaller than the deformation of roller overrunning clutch ’ s line contact with higher pair and new overrunning clutch ’ s skid angle is smaller

    對低副單向超越離合器的部件進行了加工製造，在超越離合器弧塊表面創新設計加工排油溝，增大摩擦系數，保證實現自鎖，解決了很多離合器工作過程中容易出現無法自鎖的問題;對低副單向超越離合器和內星輪滾柱超越離合器用自製杠桿加載器做了定性分析，實驗表明:相同條件下，新型離合器低副面接觸比滾柱離合器高副線接觸變形小、溜滑角小。
  15. The coefficients of friction reduced 24 %, 5. 0 %, 10 % than these of ti6a14v under dry sliding and lubrication of hank ' s solution and 0. 9 % nacl solution respectively, and its wear rate were about half of that of t16a14v under the same condition

    在干摩擦、 hank ' s溶液和生理鹽水潤滑條件下，摩擦系數分別降低24 、 5 . 0和10 ，體積磨損率約為相同條件下ti6a14v合金磨損率的50 。
  16. Based on koji making and fermentation with multi - strain or single - strain, the result showed that multi - strain was not suitable to and had negative effect on soy sauce production

    摘要通過一系列的多菌種和單菌種在相同條件下制曲發酵對比實驗，證明多菌種制曲發酵不但沒有益處，而且有明顯的負作用。
  17. 6 the parties acknowledge that if the parties decide to proceed with the establishment of the company, then it is intended that party a will supply certain site services and utilities to the company of the same quality and on the same terms that party a currently enjoys on the site and in the building

    6雙方承認，如果雙方決定繼續進行建立合營公司的項目，則雙方計劃甲方將向合營公司提供某些場地服務和公用事業並且以甲方當時在場地上和大樓中享有的相同條件和相同質量提供。
  18. At the same time we obtained that the shg conversion efficiency of the flattened gaussian beam is higher than that of the gaussian beam under the same condition ; in section 3, we have computed the theoretical conversion efficiency of the thg on the flattened gaussian beam, where we also have worked out the type - i and type - 11 ( 1 ) thg conversion efficiency curves versus the same effectors, and found the flattened gaussian beams thg conversion efficiency is higher than that of the gaussian beam too ; in the section 4, we have simulated the field distribution of the shg and thg wave on the flattened gaussian beam

    在相同條件下，得出了平頂高斯光束的倍頻轉換效率高於高斯光束的倍頻轉換效率；第三章對平頂高斯光束在clbo晶體上的類和類混頻轉換效率與其影響因素的關系進行了數值模擬和計算，並同高斯光束進行比較，同樣得到混頻時，平頂高斯光束的轉換效率高於高斯光束的混頻轉換效率的結論；第四章模擬計算了平頂高斯光束的倍頻、混頻波橫向光場的分佈形式，得到了諧波場仍為均勻平頂高斯光束的結果。
  19. Interestingly, it was found that the er properties of this ternary composite depended on the content of formide. when the weight ration between mmt and formide was closed to 1 : 0. 08, the yield stress of er fluid could reach its maxium and the typical yield stress was over 8. 3 kpa at only 2 kv / mm electric field, which was 3. 2 times than that of mmt / cms er fluid. when the electric field was 3 kv / mm, the yield stress was over 12. 0 kpa, which was 2. 4 times than that of mmt / cms er fluid

    當蒙脫土/甲酞胺/梭甲基澱粉的質量比為1 : 0一0 . 08 : 0 . 2時，復合顆粒電流變液的力學值隨甲酞胺含量的增加而升高;當甲酞胺與蒙脫土的質量比為0 . 08時，在2kv / ~的電場作用下，其電流變液的屈服應力值達8 . 3kpa ，是相同條件下的蒙脫土/梭甲基澱粉電流變液力學值的3 . 2倍，而當電場強度為3kv / mm時，其電流變液的屈服應力值達12 . 0kpa ，是相同條件下蒙脫土/梭甲基澱粉電流變液力學值的2 . 4倍。
  20. Under same conditions the deposition rate increased with the tube length and decreased with the flow velocity

    結果發現，在相同條件下，沈積率隨管長增加而增大；隨流體速度增加而減小。
分享友人
分享到 Line

分享到臉書