真空加料系統 的英文怎麼說

中文拼音 [zhēnkōngjiāliàoxìtǒng]
真空加料系統 英文
vacuum loading systems
  • 真 : Ⅰ形容詞（真實） true; genuine; real Ⅱ副詞1 （的確; 實在） really; truly; indeed 2 （清楚確實） cl...
  • 空 : 空Ⅰ形容詞（不包含什麼; 裏面沒有東西或沒有內容; 不切實際的） empty; hollow; void Ⅱ名詞1 （天空） s...
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 統 : Ⅰ名詞1 （事物間連續的關系） interconnected system 2 （衣服等的筒狀部分） any tube shaped part of ...
  • 真空 : [物理學] vacuum; empty space; vacuo
  • 系統 : 1. （按一定關系組成的同類事物） system 2. （有條理的;有系統的） systematic
  1. The system of vpi equipment mainly includes vacuum chamber, heating unit, worktable with its drive unit, vacuum pumping unit, gas - charge unit and control unit, etc. this equipment would meet the need of al or cu matrix composites prepared by pressureless infiltration or vacuum infiltration in a high vacuum or special atmosphere

    該設備主要出密封罐、加熱系統、升降工作臺、真空系統、充氣系統、控制系統及密封罐水冷系統等組成。可以實現常見金屬基復合材料在較高真空或特定氣氛下的無壓浸滲或真空浸滲制備工藝，並可實現試樣的不同冷卻方式凝固。
  2. The influence of microstructure on the flashover performance of alumina ceramics has been studied systematically through investigating the flashover performance of different alumina ceramic samples. experimental results reveal that the flashover performance is affected by the grain sizes and its dispersiveness. the smaller grain size is, the higher flashover performance ; the less dispersiveness of grain sizes is, the higher flashover performance

    3 .通過研究用不同工藝制備的氧化鋁陶瓷絕緣子（同一材料配方不同燒成工藝、同樣氧化鋁含量不同添加劑）在沖擊電壓作用下在真空中的沿面閃絡特性和表面帶電特性，首次深入系統地探索了材料微觀結構對陶瓷材料沿面閃絡性能的影響規律。
  3. The dried material is put into the middle of shell, mixing by the rake teeth and the material shaft works back and forth. the indirect heating, equal agitation of rake teeth and grinding of breaking stick makes water in material evaporation. under the effect of vacuum system, the water in the dried material and apparent water are discharged and the vapor water is discharged from outlet of vacuum pump passing dry dust collector, wet dust collector and condenser

    被乾燥物料從殼體上方正中間加入，在不斷正反轉動的耙的攪拌下，物料軸向來回走動，與殼體內壁接觸的表面不斷更新，受到蒸汽的間接加熱，耙的均勻攪拌，粉碎棒的粉碎，使物料內的水份氣化，在真空系統的作用下，使被乾燥物料內部水份和表面水份更有利的排出，氣化的水份經乾式除塵器濕式除塵器冷凝器，從真空泵出口處放空。
  4. The results indicate that drying thickness, radiant temperature and pressure of drying chamber are the most three significant factors. there ' s hardly any relationship between freezing rate and drying time, the sublimation drying time of slow freezing material is shorter than quick freezing one, but its desorption drying time is relatively longer, so the total drying time is approximately the same. the initial freezing temperature and freezing manner has little influence on vacuum freeze drying process

    試驗表明：凍干厚度、加熱板溫度、系統的真空度是最重要的三個過程參數；凍結速率對總凍干時間沒有影響，慢凍物料的升華乾燥時間要比快凍物料短，但慢凍的解析時間相對較長，兩者的總凍干時間相差很小；初始凍結溫度對凍干過程的影響可以忽略。
  5. Vacuum loading systems

    真空加料系統
分享友人
分享到 Line

分享到臉書