真空吻 的英文怎麼說

中文拼音 [zhēnkōngwěn]
真空吻 英文
vacuum kiss
  • : Ⅰ形容詞(真實) true; genuine; real Ⅱ副詞1 (的確; 實在) really; truly; indeed 2 (清楚確實) cl...
  • : 空Ⅰ形容詞(不包含什麼; 裏面沒有東西或沒有內容; 不切實際的) empty; hollow; void Ⅱ名詞1 (天空) s...
  • : Ⅰ名詞1. (嘴唇) lips 2. (動物的嘴) an animal's mouthⅡ動詞(用嘴唇接觸人或物) kiss
  • 真空 : [物理學] vacuum; empty space; vacuo
  1. This paper emphasize study the seepage of vacuum - heaped load combining precompression., deduce the drainage quantity computation formula for stage loading in soft soil. an example show that the results of calculation are in good agreement with the measured value, this explain that the formula is rational

    本文重點對堆載聯合預壓法的滲流進行了研究,得出了在分級加荷下軟土地基滲流量的計算公式,算例表明其計算值與實測值較合,說明所建模型是比較合理的。
  2. The sample composition was analyzed by means of tg and x - ray diffraction. the following conclusions can be drawn from the experiments : given conditions, the sample powder that has the same xrd data as the standard fetioa can be gotten when use any method mentioned above ; the key in synthesis is to avoid the oxidation of fe2 +, so the whole process should performed under vacuum or neutral atmosphere, samples used by this study were prepared under nitrogen atmosphere ; the heat - treated time and temperature have some influence on the sample powder, results show that the proper time and temperature is 120 minutes and 1100 respectively

    研究結果表明:在合適的反應條件下,用上述三種合成方法都能得到xrd數據與標準fetio _ 3物相基本合的粉體;合成反應需要克服的主要問題是防止體系中fe ~ ( 2 + )的氧化,因此,整個反應必須在或者非氧化性氣體保護下進行,本研究需要的樣品是在高純從保護下合成的;煅燒的時間和溫度對最終的產物也有一定的影響,研究發現:合理的煅燒時間和溫度分別為120分鐘和1100 。
  3. In the same time, this paper applied the plane strain fem based on biot theory to analyzed calculated result and observation information hi scene. finally, this paper put forward a settlement forecast model based on the modified gaomujunjie method, using by inversion analysis theory to compare and analyze the settlement process of vhlcp. result indicated that the model inosculated with the fact data and the consolidation degree have finished 86 %, back - work settlement was 87mm

    最後,根據實測沉降資料,採用一維反演分析法,推導最終沉降量計算公式,結合改進后的高木俊介固結度計算方法,建立堆載聯合預壓的沉降預測模型,並根據計算結果,對比實際沉降過程,對比表明:所建沉降預測模型與實測數據合,由此所得現場試驗的地基平均固結度達86 ,剩餘沉降為87mm ,滿足高速公路質量要求。
  4. Build the compute model of all - glass evacuated solar collector tube in fluent according to the physical model and the interface of fluent, set the boundary conditions on the basis of the fact of three different states of air stagnation, water stagnation and heat loss. the calculation results have a good match with the test results. 2

    根據太陽能集熱管的物理模型和fluent的建模要求,建立了太陽能集熱管的fluent計算模型,根據太陽能集熱管在悶曬、曬和散熱狀態下的工作條件,設置fluent計算的邊界條件,對三種工況下的流場和溫度場進行計算,計算結果與實驗測試結果非常合; 2
分享友人