真空穩定度 的英文怎麼說

中文拼音 [zhēnkōngwěndìngdù]
真空穩定度 英文
vacustat
  • 真 : Ⅰ形容詞（真實） true; genuine; real Ⅱ副詞1 （的確; 實在） really; truly; indeed 2 （清楚確實） cl...
  • 空 : 空Ⅰ形容詞（不包含什麼; 裏面沒有東西或沒有內容; 不切實際的） empty; hollow; void Ⅱ名詞1 （天空） s...
  • 穩 : 形容詞1 （穩定; 穩當） steady; stable; firm 2 （穩重） steady; staid; sedate 3 （穩妥） sure; rel...
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 真空 : [物理學] vacuum; empty space; vacuo
  • 穩定度 : degree of fixation
  • 穩定 : 1 （使穩定） stabilize; steady 2 （穩固安定） stable; steady 3 （物質的性能不易改變的作用） stabi...
  1. Discussion on the factors affecting oil suction pump vacuum of model wby210 stabilized soil mixer

    210型穩定土拌和機吸油泵真空度大小的因素
  2. The axial magnetic field distribution on center surface of contact gap and contact piece are calculated when the current is at peak. it can be found that the intensity of axial magnetic field and radial magnetic field uniformity are strengthened after the iron core is put into, this helps to improve the stability of the vacuum arc

    計算了電流峰值時觸頭間隙中心平面和觸頭片上的縱向磁場分佈，可以看出加入鐵芯后縱向磁場強度和徑向磁場均勻性增強，這有利於提高真空電弧的穩定性。
  3. At the initial stage of planar technique, b was employed as ideal diffusion impurity in base - region of npn si planar devices because of the match of its solid - solubility and diffusion coefficient in si with those of p in emission - region, and the good shield effect of sio2 film to b. but because of the relatively large solubility ( 5 1020 / cm3 at 1000 ) and the small diffusion coefficient, the linear slowly - changed distribution of acceptor b in pn junction can not be formed, which could not cater to the requirement of high - reversal - voltage devics. thereafter b - a1 paste - layer diffusion technology and close - tube ga - diffusion technology had been developed, while the former can lead to relatively large the base - region deviation and abruptly varied region in si, which caused severe decentralization of current amplification parameter, bad thermal stability and high tr ; the latter needed the relatively difficult pack technique, with poor repeatability, high rejection ratio, and poor diffusion quality and productio n efficiency

    在平面工藝初期，由於b在硅中的固溶度、擴散系數與n型發射區的磷相匹配， sio _ 2對其又有良好的掩蔽作用，早被選為npn硅平面器件的理想基區擴散源，但b在硅中的固溶度大（ 1000時達到5 10 ~ （ 20 ） ，擴散系數小， b在硅中的雜質分佈不易形成pn結中雜質的線性緩變分佈，導致器件不能滿足高反壓的要求，隨之又出現了硼鋁塗層擴散工藝和閉管擴鎵工藝，前者會引起較大的基區偏差，雜質在硅內存在突變區域，導致放大系數分散嚴重，下降時間t _ f值較高，熱穩定性差；後者需要難度較大的真空封管技術，工藝重復性差，報廢率高，在擴散質量、生產效率諸方面均不能令人滿意。
  4. According to the experimental parameters of mpt, the main performance parameters of different propellants have been given by engineering performance computation under designed and working states, which has great importance for the experimental research and the future work. 2. for helium and argon, the factors which influence on mpt ' s vacuum steady work have been discussed such as the material of microwave tie - in, the distance between the probe and inner - conductor, the position of the inner - conductor, the input power of microwave, the mass flowrate of propellant and the vacuum pressure of environment, and the influence has been discussed of the microwave power and the mass flowrate of propellant on the pressure of the resonance cavity, thrust, reflected power and the temperature of the resonance cavity

    論文的工作和新見解主要包括： 1在設計狀態和工作狀態下，根據mpt的實驗參數，對mpt使用不同工質時的性能進行了工程估算，這對mpt現階段的實驗研究和今後的研究有重要的指導意義； 2對于he 、 ar推進工質，討論微波的接頭材料、探針與內導體的間隙、內導體的位置、微波的輸入功率、工質的質量流量以及環境真空度對mpt真空啟動和穩定工作的影響，並探討微波的輸入功率、工質的質量流量對諧振腔壓強、推力、反射功率以及諧振腔溫度的影響； 3對于n _ 2 、 h _ 2 、 nh _ 3 、 h _ 2o推進工質，主要討論與he 、 ar工質不同的特性，並從長遠的眼光和工程應用的角度，認為其可行性不容置疑，潛在優勢不可忽略，是未來mpt應用的主流推進工質。
  5. To make pic ( particl - in - cell ) simulations. to set up models of guns and magnetic field and simulate them in the vacuum and plasma, respectively. we found that plasma held back part of space charge effects and improved trajectory of electrons. but beam would oscillate and became instable as accretion of plasma density. by simulating again and again, we draw a conclusion magic could n ' t work when plasma density was more by far than beam electron density. at last a four - stage depressed collector was simulated

    建立電子槍和聚焦系統模擬模型，分別在真空和填充等離子體條件下進行模擬。發現填充等離子體能補償部分空間電荷效應，改善電子束包絡軌跡，提高電子的流通率，但是隨著等離子體密度的增大，束電子會出現振蕩不穩定性，遺憾的是通過反復多次模擬發現本文所用粒子模擬的代表性軟體magic無法用於模擬等離子體密度遠高於束電子密度的情況。
  6. In the paper, we put forward the combination of micro electronic technology, mems technology and vacuum micro electronic technology to develop a micro electronic pressure sensor with overload protection. the pressure sensor consists. of elastic anode membrane, isolation layer, vacuum micro cavity and field emission catelectrode tip array with overload protection. such pressure sensor has many advantages, such as high temperature stability, radiation resistance, fast response, high sensitivity, small volume, simple secondary instruments and bulk production

    本文在重慶市科技「十五」項目的資助下，提出利用微電子技術、 mems技術和真空電子技術相結合的方法，研究一種帶過保護功能的真空微電子壓力傳感器，該壓力傳感器由帶過保護的場致發射陰極錐尖陣列、彈性陽極膜、絕緣層、真空微腔所構成，具有溫度穩定性好、抗輻射、快響應、高靈敏、體積小、二次儀表簡單、可批量生產等優點，具有廣泛的應用市場。
  7. The acceleration sensor has been developed using mems technique, microelectronic technique, and vacuum electronic technique. it can be widely used in navigation and aerospace, industry automation and car airbag control and so on. the research of such kind of acceleration sensor is of great scientific significance

    該傳感器集固體器件和真空電子器件的優點於一身:具有抗輻射、溫度穩定性好、快響應、高靈敏、高解析度、低電壓、低功耗、信號處理電路簡單、體積很小等優點。
  8. The two - dimensional axisymmetric subsonic - transonic - supersonic flow in an experimental arcjet thruster is simulated numerically using flux vector splitting method. the profiles of density, velocity, temperature, pressure and mach number can be obtained by the computation. the computation grid and some computed results are given here. the test equipment such as power supply system, ignition system, propellant supply system, arcjet thruster, thrust measuring device and vacuum system are introduced briefly. some working phenomena of the arcjet are observed and discussed. three different kinds of instability appeared in the process of the experiments. except some important parameters are measured, it is found that the operating stability of argon is better than that of nitrogen

    對一實驗電弧加熱式發動機二維軸對稱亞跨超音速流動進行了數值模擬，所採用的方法是矢通量分裂演算法.通過計算可以得出密度、速度、溫度、壓力和馬赫數的分佈.給出了計算所使用的網格和一些計算結果.簡要介紹了實驗所使用的設備，如電源系統、點火系統、推進劑供給系統、電弧加熱式發動機、推力測量裝置和真空系統.對所觀察到的一些工作現象進行了討論.有三種不同的不穩定性出現于實驗過程.除了所測量的一些重要參數，通過實驗發現氬比氮工作更穩定
  9. Stabilizing vacuum of nbi system quickly is the key issue that many countries are concerning and researching actively

    快速穩定中性束注入系統動態真空度是目前各國仍在積極探索的重要課題。
  10. The system can steadily and reliably work, whose working pressure is froml. opa to lo. opa. the automatization, communication, and digital of vacuum experiment have basically been realized, which provide well guarantee for investigation of mpt under the vacuum condition

    真空實驗系統工作穩定，工作真空度為1 . 0pa 10 . 0pa ，基本實現了mpt真空實驗的自動化、信息化和數字化，為mpt真空實驗研究提供了基礎。
分享友人
分享到 Line

分享到臉書