矢量制圖法 的英文怎麼說

中文拼音 [shǐliángzhìtúfǎ]
矢量制圖法 英文
vector graphics
  • 矢 : Ⅰ名詞1. （箭） arrow 2. （尿） excrement; dung; feces 3. （姓氏） a surname Ⅱ動詞（發誓） vow; swear
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 圖 : Ⅰ名詞1 （繪畫表現出的形象; 圖畫） picture; chart; drawing; map 2 （計劃） plan; scheme; attempt 3...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  1. The procedure functions in the compare between partial image of dynamic collection and corresponding image of the airscape. in chapter 5, basing on the analysis of correlative theory of digital image, we introduce the improved fasted - down algorithm and simulative anneal algorithm, which applies to nn calculation, an d bring forward the unique and effective means, correlative original value evaluation. basing on the combination of correlative arithmetic, a stable, high - speed and exact correlative arithmetic is formed, which makes it possible to apply computer vision detection of single - needle quilting in industrial production

    本文展開研究並取得一定成效：構建了基於pci總線的微機實時圖像採集系統；在採集的布料總圖（鳥瞰圖）的基礎上，通過數字圖像的數字濾波、圖像增強、邊緣檢測等處理，提取布料圖像的邊緣，對輪廓的矢量化的象素點進行搜索，得到相應的圖案矢量圖，從而確定絎縫的加工軌跡，生成加工指令；在進給加工過程中，主計算機對動態局部圖像與總圖（鳥瞰圖）的對應部分進行圖像相關的匹配計算，應用數字圖像理論，結合神經網路計算的改進最速下降法和模擬退火演算法，提出獨特而有效的相關迭代初始值賦值方法，形成穩定、高速和準確的相關運算，實現單針絎縫視覺測量和自動控制。
  2. In the electronic component drawing system, i use " vectorgraph " to magnify and minify the diagram without any distortion

    電路板元器件繪制系統採用「矢量圖」的方法實現了不失真的圖形放大和縮小。
  3. The paper presents several aspects in partition rectification and visualization of raster image. adopt technology of visualization for scientific calculation, vector diagram of deformation 、 contour chart of deformation and drawing of three - dimensional are realized. delaunay tin in view of deformation feature is constructed on base of selected grid control points and methods and mathematical models for partition rectification are realized based on the delaunay tin. software of geometric rectification for large scales are realized and applied in project

    本論文針對柵格影像的變形可視化及分塊糾正展開研究，取得了以下幾方面的研究成果：一、採用科學計算可視化技術，繪制變形矢量圖、變形等值線圖和三維效果圖，實現了柵格影像變形特徵的可視化；二、提出了在格網控制點（ gcp ）數據基礎上選擇性構造顧及變形特徵的delaunay三角網，並基於構造的三角網實現了分塊糾正的方法和數學模型；三、採用vc編制了影像幾何糾正軟體，實現大比例尺掃描地形圖的糾正，並在工程中得到應用。
  4. First we introduce theory and merits of graphic wavelet transform, then mallat algorithm, multi - scale characteristic, quadratic b - alpine wavelet and the coefficients of this filters, and etc. later we calculate the gradient matrix based on the result of wavelet transform, thin the contour and get spatical information

    先介紹圖像小波分解方法的原理、 mallat快速演算法、多尺度特性、 3階b -樣條小波基函數的選取及其濾波器系數的推導等，然後根據小波變換結果計算梯度矢量矩陣，進行非極大值抑制和雙閾值化，提取目標輪廓。
  5. Taking gis software ( arc / info and arcview ) and visual foxpro as basic plat, protracted the system maps of land resource, those basic subject maps included land use status map, land types map, soil types map, grade map and soil organic substance map, combing with former summarizing research results, built the spatial basic database of land resource ; based the spatial database, by the means of attribute table manipulation and take the map plot as basic unit to get the subject attributes of basic information, combined with social economy attribute information, built the attribute database ; take the spatial basic database as basic work, by the means of vector piles to get the land resource dynamic movement system maps, included land use status, land types and soil organic substance dynamic movement map

    以gis軟體（ arc info 、 arcview ）與visualfoxpro為基礎平臺，繪制完成土地資源的系列圖，包括土地利用圖、土地類型圖、土壤類型圖、坡度圖、土壤有機質圖等基礎專題圖件，結合以前的工作成果，構築土地資源的空間本底數據庫；通過空間疊加分析，得到基礎單元圖斑，採用屬性表操作的方法獲取基礎單元圖斑的專題屬性信息，結合社會經濟屬性信息，建立屬性數據庫；以空間本底數據庫為基礎，採用矢量疊加對比分析的方法，得到土地資源動態變化系列圖，包括土地利用、土地類型、土壤有機質等動態變化圖。
  6. Chapter five include the content of the software flow chart of with - sensor vector - controlled induction motor driver system, the characteristic of data processing, and a novel debug method with modularization and incremental system build method

    第五章給出了帶速度傳感器矢量控制系統軟體實現的流程圖、數據處理的特點和一種新穎的模塊化的編程思路和分級遞增的調試方法。
  7. By simulating mathematically on frequency and on space, we can find the average speed of space field and the average speed of frequency field that is weighted by amplitude, and analyse their relation, and analyse the meaning of space speed variance x and frequency speed variance v. in the fourth part, how to ensure the height of cloud is introduced, and basing on the theory of wind field continuity, the height updating quality controlling is introduced. in the fifth part, the system of cloud wind is introduced, we tracked cloud - motion of consecutive satellite images with one - minute interval by the 1 - d fourier analysis technique and the two - dim fourier analysis technique and the fft analysis technique, and dispose them with quality controlling. in the sixth part, we summarized our research and put up with shortages of this article

    模擬模塊內各點的速度線性變化時，得到空間域平均速度以及頻率域以振幅為權重的平均速度，分析了空間域平均速度和頻率域以振幅為權重的平均速度的關系，並揭示空間域的平均速度的標準差_ x和頻率域的振幅為權重的平均速度的標準差_ v的意義，以及它們之間的關系；第四章介紹了雲跡風系統的高度指定以及風矢高度的劃分，並根據風場連續性原理，介紹了高度調整法的質量控制；第五章介紹導風系統的流程，選擇了三個時刻的ir雲圖，分別用一維傅立葉相位法、二維傅立葉相位法和快速傅立葉演算法計算一個風場個例，並對所得風場進行質量控制，並給出風場圖；第六章進行研究總結，指出不足和有待于進一步研究之處。
  8. And the converter will work on the strategy of vector control with the definitive direction of the stators magnetic field. also, the thesis develops the algorithm to corroborate the magnetic field ' s direction by the state ' s current and voltage. to validate the theory analysis of bdfg

    根據理論分析和模擬的結果，本文提出級聯式無刷雙饋發電機的控制策略是基於定子磁鏈定向的矢量控制方法，並推導了用定子側電壓電流量來確定定子磁鏈方向的演算法，繪制了相應的閉環控制框圖。
  9. Based on the analyses of the map data quality standards, data model characteristics, feature coding, various specifications and rules, the paper researches and discusses thoroughly the technology and method for vector map data quality check, evaluation and control both in theory and in practice

    本文在分析地圖數據質量標準、數據模型特點、要素編碼、各種規范、細則的基礎上，研究和探討了矢量地圖數據質量檢查、評價和控制的技術、手段和方法，從理論到實踐進行了較為全面系統的研究和探討。
  10. In this paper, the backward simulation was summarizd at home andabroad, the characteristics of shell nosing were introduced, the theory and scheme of backward simul - ation of shell nosing was constructed, the determined methods of the boundary conditions were put forward in backward simulation for the processes of shell nosing

    論述了推力矢量控制技術是提高空空導彈性能的核心技術，介紹了常用的三類推力矢量裝置，著重討論了燃氣舵式和擾流片式推矢裝置的特點、設計方法、性能及其優缺點.在此基礎上，研究了適用於氣動力/推力矢量復合控制的變結構控制系統及其開關函數的切換條件和飛行控制系統框圖.最後綜述了推力矢量裝置在第四代空空導彈上的應用情況
  11. In the first part of this thesis, the method of data collection for building a 3d scene based on a planar vector map is studied. to the most difficult problem in data collection : the evaluation of contour line, a suit of effective automatic assisting method is advanced, which can remarkably shorten the process period and improve the efficiency of spatial data collection. the main idea of this method is " control point congregating automatically and close control point cooperating "

    本文主要研究了基於二維矢量圖如何獲取構建三維場景所需的空間數據，包括地形、地物的二維數據採集與三維建模方法，並針對數據獲取中的主要難題，即等高線高程賦值問題，提出了一種基於高程式控制制點自動聚集、相近控制點協作的自動處理方法，顯著縮短空間數據獲取的處理周期。
  12. Class to draw and position vector images and raster images

    方法繪制和定位矢量圖像和光柵圖像。
  13. This paper studies the architectures and key algorithms of the transcoding from hdtv to sdtv in the dct domain. the key algorithms includes : motion vector mapping, picture downsizing in dct domain, motion compensation in dct domain and rate control

    本文研究了dct域hdtv至sdtv轉碼的架構和關鍵演算法。其中，關鍵演算法包括:運動矢量映射演算法、 dct域圖像下采樣演算法、 dct域運動補償演算法、碼率控制演算法。
  14. First, the dsp board calculates optical flows ( the velocity field of an image ) based on the gradient method. next, the region of the moving object on the image is extracted from the optical flows using knowledge about the region of the object, such as region - merge arithmetic, region - connection arithmetic or clustering arithmetic. finally, the camera is controlled to keep the object in its field of view

    我們建立了一個基於tms320c6701的dsps系統，首先求解出基於梯度方法的光流場（原始圖像的速度場） ，然後根據區域合併、區域連通或聚類演算法等方法從光流場中抽取出運動目標區域，並計算出運動目標的速度矢量，進而通過雲臺裝置控制攝像頭的轉動，使得運動目標始終位於攝像機的視野中，從而完成對復雜背景中單個運動目標的實時跟蹤。
  15. The quality control of vector map data

    矢量數字地圖生產的質量控制方法
  16. To the primary contradiction of rtdivs, limited bandwidth of network and real time transmitting parameter of relative to move sight, the modeling theory, and the method of development and encoding theory are researched deeply. interactive platform of automation vectorization of 2 - d image and remarking is set up in this way. the control mechanism of 3 - d visual object of agent is discussed, and vf - sdm, visual federation synthetic development method is presented

    論文以作者建立的信息模型反映理論為指導，針對rtdivs的主要矛盾，即網路有限帶寬與視景運動交互參數實時傳輸矛盾，對模擬建模理論、軟體開發方法、信息編碼理論進行了深入研究，建立了二維圖像自動矢量化標注交互軟體平臺，深入探討了三維視體自主運動控制機理，提出了視景聯邦綜合開發方法（ vf - sdm - visualfederationsyntheticdevdopmentmethod ） 。
分享友人
分享到 Line

分享到臉書