矩陣板 的英文怎麼說

中文拼音 [zhènbǎn]
矩陣板 英文
matrix plate
  • : 名詞1. (畫直角或正方形、矩形用的曲尺) carpenter's square; square2. (法度; 規則) rules; regulations 3. [物理學] moment
  • : Ⅰ名詞1 (作戰隊伍的行列或組合方式) battle array [formation]: 布陣 deploy the troops in battle fo...
  • : Ⅰ名詞1 (片狀硬物體) board; plank; plate 2 (專指店鋪的門板) shutter 3 [音樂] (打拍子的樂器) ...
  • 矩陣 : [數學] matrix; array
  1. The projector and beam of light represent the elohim creator beings consciousness, the celluloid and focusing device on the projector represent the template and its synchronization function, the screen represents the magnetic receptacle or matrix which will receive the higher image, and the image ( projection ) is the creation itself

    投影機和光束表徵了耶洛因創造者的存在意識,投影機上的賽璐珞和聚焦裝置表徵了生命模和它的同步功能,銀幕表徵了磁場容器或能量,能量可以接受到更高級的圖像,而圖像(投射)就是創造物本身。
  2. Interconnection of programming function is carried out on a matrix board.

    各種編程功能之間相互銜接在矩陣板上進行。
  3. As for it also has low working voltage and small power dissipation, it has became the ideal succedaneum of crt. furthermore, fed doesn ’ t need negative photo, large visual angle, wide working temperature extent

    另外, fed不需背光、視角大、工作溫度范圍寬等優點也對目前平顯示器的主流產品有源液晶顯示器提出了嚴峻的挑戰。
  4. First, binary texture matrixes of horizontal and vertical direction were constructed in the template and target image, and then the prime matching result of the two directions was calculated according to the alogical xor logical operation in bytes and the final target correlation credibility was obtained by proportion sum at last

    在模與目標圖像中分別提取水平、垂直方向上的二值化紋理特徵,然後根據位元組同或邏輯運算分別計算兩個方向上的最佳匹配值,最後,通過加權求和得到最終的目標相關置信度。
  5. The static analysis of the long span plate - truss composite cable - stayed bridges. first, the cr formation on the geometric non - linear structural analysis is introduced. next, the structural discretization of cable - stayed bridge, the stiffness matrix the formation of nodal force and the simulated construction system are introduced

    首先介紹了本文採用的桿系結構幾何非線性問題的分析方法? cr列式法,其次介紹了桁結合斜拉橋的結構離散及桿單元、梁單元的剛度以及節點力的形成方法,然後介紹了斜拉橋施工模擬體系的形成。
  6. Users start with report layout templates containing pre - defined data regions to build combinations of tables, matrices and charts

    用戶從包含預定義數據區域的報表布局模開始,生成表、與圖表的組合。
  7. To build a table, matrix, or chart report, use a report layout template that contains predefined data regions and select a predefined report model, which contains report items such as data fields, then drag and drop the report items onto the data regions within the template

    若要生成表、或圖表報表,請使用包含預定義數據區域的報表布局模,並選擇包含如數據欄位等報表項的報表模型,然後將不同報表項拖放到模內的相應數據區域中。
  8. It ' s an ideal structural system and has multi - earthquake resistance ability because of a great deal of slabs removed in floors above the transfer - story amended the lateral stiffness of the stories near the transfer - story. based on the available references, the five - spring line element, the three - spring line element and the multiple vertical - line - element model are introduced to model special column, beam and shear - wall, the relevant stiffness matrixes are deduced and the restoring - force models are gaven to deep into the elasto - plastic seismic characteristics of the structure. acording to the results of shaking table test and elastic finite element analysis, a new making model melhod is presented in which uses the linear and the nonlinear element and the assumption that the floor is infinitely rigid in different areas

    為進一步研究這種復雜高層建築結構的彈塑性性能,本文在國內外現有研究的基礎上,提出利用五彈簧桿元、三彈簧桿元及多豎線單元模型分別模擬空間柱、梁和剪力墻,推導了相應的剛度並給出了恢復力模型;結合試驗研究和精細有限元分析的結論,提出線性和非線性單元相結合,剛性樓假定和彈性樓相結合的建模方法,較好地解決了空間結構彈塑性分析中佔用計算機資源較多的問題;接力大型有限元分析程序? ? ansys ,在上述建模思路的指導下建立了結構的空間非線性分析模型,進行了空間三維彈塑性時程分析。
  9. This paper analyzed from theory on the rigidity matrix transformation problems of the combination unit of plate unit and entity unit

    摘要從理論上分析了單元實體單元相結合的單元剛度轉化問題。
  10. But there is only one argument in each pile node or soil node in piles - soil system. therefore, an effective, simple and feasible coupling method is proposed in this thesis. that is to couple the three different rigidity matrixes of superstructure, raft and piles - soil system

    針對該情況,本文提出了一種簡單可行的耦合方法,將上部結構剛度、樁土支撐體系剛度和筏剛度進行耦合,形成共同作用方程並編制共同作用分析程序。
  11. When using multiple matrix cards, check the specifications to determine if the rows can be connected through the backplane or if they must be wired externally

    在使用多個開關卡時,請確認技術指標,檢查開關卡的行是否可通過背連接,或者是否必須通過外部進行連接。
  12. This paper presents the element stiffness matrix and equivalent node force of the variable cross - section bar. so the approximation in structural analysis is avoided, and the calculation capacity of equivalent frame method is also developed. this helped the engineers avoid the fem, which consume much time and is difficult to master

    本文對帶寬度變化的柱結構推導了變截面直桿單元的單元剛度和等效結點荷載列,避免了在結構分析時所作的近似,也擴大了等代框架法的計算范圍,使工程技術人員免於使用佔用機時、難于掌握的有限元分析法。
  13. The matrix inversion by matrix class template

    類模求逆的演算法
  14. The results of the limited element analysis and experiment study confirms that both the resisting ended batten and using angle batten in place of plate one could make the laterally stiffness of such member more strong. that maybe provides somewhat practical benefits for designing the twin - wall truss

    本文還通過分析法和模擬試驗研究,證實了端綴的存在對抵抗側向屈曲有明顯提高;而選用角鋼代替綴材料相對于,有助於提高構件的側移剛度和翹扭轉剛度,這對于單軸對稱綴柱的設計也具有一定的實用價值。
  15. With the principle of technical cooperation and self - innovation, the company implemented technology development strategy of high starting point, high investment and high quality, researched and developed a series of new products with self knowledge property right. the company also owns one stop production capacity from raw materials to finished products ; for example, annual production capacity of diode can reach to 3. 6 billion pieces

    健隆達秉承「品質第一客戶至上」的理念,不斷拓展led產品市,公司主要產品有:全系列發光二極體數碼管時鐘全系列點圖元管背光
  16. To provide a method that can be used to predict single or multi - layered microperforated panel ( mpp ) performance precisely, especially when the mpp has holes of different diameter and irregular shape

    摘要提出用實驗測得含不同孔徑孔的微孔聲阻抗率來預測由其形成的單層或多層微孔的吸聲特性,並用傳遞法來預測該微孔的各種組合結構的整體吸聲性能。
  17. ( 2 ) based on the wave equation in the acoustic fluid space and the theory of thin - wall structure, the non - symmetrical coupled structure - acoustic dynamic equation without damping is studied. the non - symmetric system of the finite element model for coupled structure - acoustic response is solved by the conjugate subspace iteration method

    由聲空間波動方程和薄理論出發,對聲場?結構耦合系統的模態分析提出了有限元數值方法,採用共扼子空間迭代法對非對稱特徵方程進行處理,採用靜凝聚法消除質量的奇異性。
  18. The fundamental vibration theory about bridge structure and the formation about the property matrix are introduced. according to the linear theory and the finite element method about space system of bars, the corresponding vibration analysis program is compiled. using this program, the natural frequencies about the wuhu changjiang river bridge are analyzed

    首先介紹了橋梁結構的振動基本理論,然後介紹了對桁結合斜拉橋的固有振動進行分析時所需用到的特性的計算方法,最後依據線性理論,採用空間桿系有限元法,編制了相應的斜拉橋結構的空間動力分析程序。
  19. The 16 - node degenerated iso - parametric element is proposed for the analysis of raft foundation with mid - thick plate. the stiffness matrix of single pile among the pile group can be founded assuming the total contact between the plate and the foundation. and the results of stress and deformation of plate, the force on pile and the settlement of pile bottom can be solved after the finite element disperse for the plate and the establishment of balance equation of pile - raft interaction

    在引入16節點退化等參元的中厚分析模型的基礎了,假定筏與地基間完全接觸,建立了群樁中單樁樁身剛度,繼而對筏進行有限元離散得到樁筏共同作用的平衡方程,從而求解筏內力、撓度、樁頂反力、樁端沉降等一系列結果。
  20. To the complete character use the image which representation by matrix, making the subtraction between the matrix of capture image and the matrix of template, the result matrix which absolute sum of its all elements is the smallest is the recognition result. to the incomplete character, using two lines of 0 ~ 9 as template, then carry on the recognition using the template matching. to the scale division recognition, using the central position of it, distinguishes the long scale division expression is merely 0 perhaps 5

    對完整字元,採用將圖像用表示,利用獲取圖像的與識別模做減法,結果的所有元素絕對值和最小的即為識別結果;對不完整字元,針對電度表讀數的具體特點,採用將兩行0 ~ 9的字元圖像排列起來作為模,利用模匹配法進行識別;對于刻度的識別,利用刻度的中心坐標位置,僅僅識別長刻度表示的是0或是5即可。
分享友人