短路傳送 的英文怎麼說

中文拼音 [duǎnlùzhuànsòng]
短路傳送 英文
short-circuiting transfer
  • 短 : Ⅰ形容詞（空間、時間兩端之間的距離小） short; brief Ⅱ動詞（缺少; 欠） lack; owe Ⅲ名詞1 （缺點） we...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 傳 : 傳名詞1 （解釋經文的著作） commentaries on classics 2 （傳記） biography 3 （敘述歷史故事的作品）...
  • 送 : 動詞1 （運送; 傳送） deliver; carry 2 （贈送） give as a present; give 3 （伴送; 送別） see sb of...
  • 短路 : [電學] short; short circuit; cutting out; direct short; short out; short pass短路保護（裝置） sho...
  1. The dijkstra algorithm of the least of hops is used for path calculated in olsr. but the protocol only tries its best to transmit data, not considering the state of wireless link

    它採用dijkstra演算法計算跳數最短路徑，並盡力而為地傳送數據包，沒有考慮無線鏈路時延、帶寬等狀態和節點擁塞程度，這樣的路徑計算方式已經不能滿足用戶對網路提供服務質量的要求。
  2. In this design, the protection in short circuit failure and the measurement in normal condition are both fulfilled. it can also communicate with the computer through the communicating interface, sending the parameter of the system current and accepting the instruction

    該傳感器具有正常電流的測量和短路故障時的保護功能，並且預留了與上位機的通訊介面，接受上位機的指令並向上傳送電網的電流參數。
  3. According to the actuality of the present research on ct, we bring forward a new design scheme based on the rogowski coil, in this design, the protection in short circuit failure and the measurement in normal condition are both fulfilled. it can also communicate with the computer through the communicating interface, sending the parameter of the system current and accepting the instruction

    本文在考察了國內外電流互感器發展現狀的基礎上，提出了一種基於rogowski線圈的電流互感器，該互感器具有正常電流的測量和短路故障時的保護功能，並且預留了與上位機的通訊介面，接受上位機的指令並向上傳送電網的電流參數。
  4. A source routing framework is proposed to route traffic flows proactively over multiple paths, which tries to optimize routes for long - lived flows based on dispersity routing ; based on mathematical analysis, our approach disperses incoming traffic flows onto multiple paths according to path qualities. long - lived flows are detected and migrated to the shortest path if their qos could be guaranteed there. suggesting non - disjoint path set, four types of dispersion policies are analyzed, and flow classification policy which relates flow trigger with link state update period is investigated

    提出一種以業務量內在特性為基礎的前攝式多路路由演算法：以對業務量的內在特性分析為基礎，該方法在多路發送數據流的同時檢測非最短路徑上的長流，而後在保證服務質量的前提下將長流遷移到最短路徑上傳輸；前攝式多路路由使用以路徑質量評價為基礎的業務流分佈方法有效提高網路吞吐量，通過周期性的路徑質量評價適應時變網路狀況；模擬實驗表明，該方法可以有效提高「盡力而為」方式下的網路服務質量和資源利用率；浙江大學博士學位論文3
  5. 1 ) realization of software packet embedded in m - es and md - is respectively to accomplish main function of mdlp, including assignment of tei ( temporary equipment identifier ), establishment of multiple frame operation, framing, flow control and error - free transmission of packets, is detailed. 2 ) a test model is established to evaluate the robustness and stability of mdlp and verify the validity of software packets. 3 ) according to the design of radio modem construction used in m - es, the modules of interface between data terminal equipment and radio modem are achieved to enable transmission of short message and continuous pseudo - random bit stream via rs232 uart

    本文首先概述了蜂窩數字分組數據網的結構和空中協議，詳細分析了移動數據鏈路協議，並在此基礎上，重點敘述了以下方面的工作： 1 ）設計並完成了分別應用於m - es和md - is端無線控制器的兩套程序實現數據鏈路層的主要功能，包括分配臨時設備號、建立鏈路、組幀和面向連接的服務保證分組正確無誤地傳輸，並進行適當的流控； 2 ）建立測試模型測試移動數據鏈路協議的可靠性和穩定性，證明了程序包的效用； 3 ）根據cdpd系統無線數據機的軟硬體總體設計方案，完成了介面模塊，實現了rs232異步串口通信，使用戶可以根據需要發送短消息或連續的偽隨機比特流； 4 ）在tms320c54x的軟體、硬體模擬平臺上，建立了cdpd試驗模型，實現了cdpd系統的mdlp基本功能。
  6. In this thesis, an arc sensor based on fuzzy control is designed. through the change of welding current in waving, the arc sensor judges the excursion and provides the adjusting output, meanwhile, it transmits the data acquired to a personal computer to be displayed and analyzed

    本文介紹了短路過渡的co _ 2氣體保護焊電弧傳感器，通過對擺動過程中焊接電流的變化來判別焊縫偏移情況，採用模糊控制得到控制輸出，並將數據經串口通信傳送到pc機上加以顯示和分析。
  7. In this thesis, routing protocol and wireless resource management are combined for the voice service in the communication network. session triggers the source node to build the bandwidth reserved routing to the destination. for the data service, aodv protocol is used to find the shortest route between source and destination, and the data is transmitted hop by hop

    本文將路由協議與無線資源管理相結合，對于通信網路中的話音業務，每次會話觸發源節點發起建立預留帶寬的路由;對于數據業務，採用aodv路由演算法按需尋找從源節點到目的節點的最短路徑，然後逐跳進行預約傳送數據。
分享友人
分享到 Line

分享到臉書