短路制動器 的英文怎麼說

中文拼音 [duǎnlùzhìdòngqì]
短路制動器 英文
short circuit brake
  • 短 : Ⅰ形容詞（空間、時間兩端之間的距離小） short; brief Ⅱ動詞（缺少; 欠） lack; owe Ⅲ名詞1 （缺點） we...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 短路 : [電學] short; short circuit; cutting out; direct short; short out; short pass短路保護（裝置） sho...
  1. Analyze and compare pid and vague, single neuron etc. control strategy, and combine with single neuron self adaptive gain, self adaptive right value and preventive integral saturation etc. control strategy. have improved single neuron control algorithm, may restrain efficiently to disturb, reduce broken arc and short circuit etc. phenomenon, make systematic control effect and robustness get to strengthen, also have certain application reference value for the design of the dc arc furnace

    通過對pid 、模糊、單神經元等控制策略的分析比較，將單神經元增益與權值的自適應調節、抗積分飽和等控制策略相結合，改進了單神經元控制器演算法，可以有效抑制擾動，減少斷弧、短路等現象的發生，使系統的控制效果和魯棒性都得到增強，對電弧爐控制系統的設計也具有一定的應用參考價值。
  2. Abstract : this article touches on the changes on auto - control lines to start electrical motors using compensators, which reduces losses due to short - circuit during start - up and improves economic benefits

    文摘:本文介紹用補償器起動電機的自動控制線路的改造，減少電機因起動短路造成損失，提高經濟效益。
  3. So the paper combined the fuzzy logic control and recurrent neural network, and the recurrent fuzzy neural network ( rfnn ) controller is introduced into the speedsensorless vector control system. moreover, an online parameter training methodology, which is derived from the lyapunov stability theorem and gradient descent method is proposed to increase the learning capability of the rfnn. the rfnn controller has a better performance than the pi controller system ; the effectiveness of the proposed control scheme is verified by simulation results

    因此論文將模糊控制和具有優越動態性能的遞歸神經網路結合起來，取長補短，提出了一種遞歸模糊神經網路控制方法，利用神經網路來實現模糊推理，可動態的調整隸屬函數的形狀、位置以及神經網路遞歸權值，並對其與pi控制器的交流調速控制系統進行了模擬比較，模擬結果表明與普通的pi控制器相比較，遞歸模糊神經網路控制器有較好的動態性能，控制器的收斂速度快、靜差小，系統在遇到參數發生變化和外部不確定性問題時魯棒性、抗擾動性有明顯的提高。
  4. The abs ’ mainframe can get train ’ s velocity and acceleration from the velocity sensors, and then accomplishes some certain braking actions in term of them. but velocity sensors are easier damaged because of its special installing position and working environment. the mainframe of abs only can diagnose some simple faults, for example, the short circuit and open circuit

    其中速度傳感器是防滑器正常制動的關鍵部件，但是轉速傳感器在工作時安裝位置比較特殊，工作環境惡劣，容易受到腐蝕、碰撞等損傷，而防滑器主機通常僅能對轉速傳感器的短路或斷路故障做出診斷，對轉速傳感器發生的其他故障難以識別，這樣就容易在列車運行時引發防滑器誤動作，甚至導致事故發生。
  5. With its smaller volume, lower price and better anti - jamming, singlechip have been widely applied in modern control system operating scene which have been put in collecting data in order to achieve shop floor control. the pic singlechip which is made by microchip co. in the u. s. a, with its risc architecture, high price verse performance ration, high speed, has been working in low voltage, lower power depletion, higer driving power, lower price otp technology and smaller volume, has been represents a new trend in the microprocessors ; as a transmission media, sms ( short message service ) which is a basic service in the gsm network, with its lower price and high reliability, has become important media in people ’ s daily life and trade communication ; led ’ s panel which has been applied in publishing the news and advertising in the enterprise is a control technic, a photoelectricity technic, communications technic, digital - image processing technic all rolled into one

    單片機以其體積小、價格低、抗干擾性好等特點，在現代控制系統中常用在操作現場進行數據採集，以及實現現場控制。 pic單片機系列是美國microchip公司推出的，採用risc結構的高性價比嵌入式控制器，其高速度、低電壓工作，低功耗，強大驅動能力，低價otp技術，體積小巧等都體現了單片微控制器工業的新趨勢;作為信息的傳輸媒體， sms短消息服務是gsm網路的一種基本業務，以其低成本、高可靠性的方便快捷通信方式成為人們日常生活和商業交流的重要載體;集控制技術、光電技術、通信技術、數字圖像處理技術於一體的led電子顯示屏為企事業的信息發布和廣告宣傳提供了廣闊的便利。
  6. 1 ) realization of software packet embedded in m - es and md - is respectively to accomplish main function of mdlp, including assignment of tei ( temporary equipment identifier ), establishment of multiple frame operation, framing, flow control and error - free transmission of packets, is detailed. 2 ) a test model is established to evaluate the robustness and stability of mdlp and verify the validity of software packets. 3 ) according to the design of radio modem construction used in m - es, the modules of interface between data terminal equipment and radio modem are achieved to enable transmission of short message and continuous pseudo - random bit stream via rs232 uart

    本文首先概述了蜂窩數字分組數據網的結構和空中協議，詳細分析了移動數據鏈路協議，並在此基礎上，重點敘述了以下方面的工作： 1 ）設計並完成了分別應用於m - es和md - is端無線控制器的兩套程序實現數據鏈路層的主要功能，包括分配臨時設備號、建立鏈路、組幀和面向連接的服務保證分組正確無誤地傳輸，並進行適當的流控； 2 ）建立測試模型測試移動數據鏈路協議的可靠性和穩定性，證明了程序包的效用； 3 ）根據cdpd系統無線數據機的軟硬體總體設計方案，完成了介面模塊，實現了rs232異步串口通信，使用戶可以根據需要發送短消息或連續的偽隨機比特流； 4 ）在tms320c54x的軟體、硬體模擬平臺上，建立了cdpd試驗模型，實現了cdpd系統的mdlp基本功能。
  7. Research made in this thesis is the primary but important step in developing the actual controller, but the key point is the bringing forward and the experience on a new methodology, thus can support the future work with theory and software. by doing this, we can understand and master the design steps, preselect and optimize the controller ' s parameters, shorten the developing time, so will absolutely has great positive effects on the diesel engine electronic control engineering

    本文的研究是開發實用的柴油機控制器的前期工作，更重要的是提出和實踐了一種較為先進的設計思路，可為后續的研究提供軟體和理論的支持及方法論的指導，從而進一步認識和掌握發動機控制器的設計步驟，方便地進行控制器參數的優化，縮短其開發周期，也必然對柴油機電控技術的發展起到積極的作用。
  8. A method is given based on the former researcher ’ s research work. the application of artificial control method in the mobile robot is discussed. after that, a second grade fuzzy control rule on the robot rotating angle and velocity is set up, while optimized based on the shortest path, to get the rotating angle and velocity control table

    本文在閱讀了大量有關移動機器人路徑規劃方法的文獻的基礎上，分析了智能控制方法在移動機器人路徑規劃問題上的應用，提出了一種基於模糊邏輯的機器人路徑規劃方法，設計了機器人轉角和速度的二級模糊控制規則，並用基於目標最短路徑對模糊控制規則進行優化，獲得機器人轉角的優化模糊控製表。
  9. However, b ecause t he d isplacement o f v ibration t able u sed i n t he t est i s 1 imited t o 4cm, the results of the testing could prove only partially the damping effect for ground motions with significant short - period contents

    由於振動臺振動位移的限制，振動臺試驗僅能進行短周期成分豐富的地震動試驗，不能全面地評價斷路器的抗震性能和鉛合金減震器的減震效果。
  10. In the design of real - time control system, the paper takes three - phase full - bridge mosfet inverter as the real - time control main circuit, and adopts a control scheme with 120 ? switching mode combined with half - bridge pulse width modulation ( pwm ), which would avoid straightthrough short of a certain bridge. phase current is detected by single current sensor ; three - phase position signals generated by position sensors could not only supply commutation information for inverter, but also be used for speed detecting based on signals " period measurement, which makes the speed sensor unnecessary. the whole control system adopts speed and current dual closed - loop control strategy in order to construct a high performance rare - earth permanent magnetic brushless dc motor ( repm bldcm ) full - digital real - time control system

    在實時控制系統的設計中，本文以三相全橋mosfet逆變電路作為實時控制主電路，採用120導通方式結合半橋pwm調制的控制方案，從而有效地避免了橋臂的直通短路；本文用單電流傳感器實現對相電流的檢測，來自位置傳感器的三相位置信號不僅為逆變電路提供換相信息，而且也用於基於信號周期測量的轉速檢測，這樣就省去了速度傳感器；系統採用的是速度、電流雙閉環控制策略，力求構建高性能的稀土永磁無刷直流電動機全數字實時控制系統。
  11. In this thesis, an arc sensor based on fuzzy control is designed. through the change of welding current in waving, the arc sensor judges the excursion and provides the adjusting output, meanwhile, it transmits the data acquired to a personal computer to be displayed and analyzed

    本文介紹了短路過渡的co _ 2氣體保護焊電弧傳感器，通過對擺動過程中焊接電流的變化來判別焊縫偏移情況，採用模糊控制得到控制輸出，並將數據經串口通信傳送到pc機上加以顯示和分析。
分享友人
分享到 Line

分享到臉書