石英激光器 的英文怎麼說
中文拼音 [dànyīngjīguāngqì]
石英激光器
英文
quartz laser- 石 : 石量詞(容量單位, 十斗為一石) dan, a unit of dry measure for grain (= l00 sheng)
- 英 : 名詞1 [書面語] (花) flower 2 (才能或智慧過人的人) hero; outstanding person 3 (英國) britain...
- 激 : Ⅰ動詞1 (水因受到阻礙或震蕩而向上涌) swash; surge; dash 2 (冷水突然刺激身體使得病) fall ill fr...
- 光 : Ⅰ名詞1 (照耀在物體上、使人能看見物體的一種物質) light; ray 2 (景物) scenery 3 (光彩; 榮譽) ...
- 器 : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
- 石英 : quartz; silici-; 石英電子手錶 crystal-oscillator watch; [鐘] quartzcrystal watch
- 激光器 : [光學] (光激射器) laser (縮自 light amplification by stimulated emission of radiation); optic...
- 激光 : [物理學] laser 激光靶 laser target; 激光報警器 laser avoidance device; 激光玻璃纖維 laser fibre; ...
-
The stability output second harmonic generation ( shg ) experiment results of single - longitudinal mode and multi - longitudinal mode with long cavity were explained reasonably with these rate equations. the high polarization of fundamental wave in the isotropic laser media nd : yag with type - i critical phase - matching lbo was studied with the rate equations including polarization of fundamental light. using the polarization function of lbo, a quartz full - wave plate was introduced into the cavity, a kind of birefringent filter by considering the combination of the polarization function of the type - i critical phase - matching doubling frequency crystal lbo and the quartz whole - wave plate was constructed
將腔內多縱模倍頻速率方程推廣應用到準三能級藍光激光器中,分析了一個縱模、兩個縱模、多個縱模時的噪聲情況,合理地解釋了實驗中激光器單縱模運轉以及長腔多縱模運轉時穩定輸出的實驗現象,同時利用該速率方程分析了以各向同性激光晶體nd : yag為工作物質,類臨界相位匹配lbo為倍頻晶體的藍光激光器中基頻光偏振特性,合理利用類臨界相位匹配lbo倍頻晶體的偏振特性與引入的石英晶體全波片構成雙折射濾光片,通過選單頻來抑制噪聲,獲得了藍光低噪聲的穩定輸出。3. because traditional coupling system composed with cylinder lens and focus lens has the disadvantages of difficult to encapsulation and modulate, a new practical method brings forward : the output light from laser diode is collimated using a section of optical fiber with the diameter of 600 m instead of cylinder lens, and a sphere ? end lens
3 .針對由柱透鏡和聚焦透鏡組成的組合透鏡耦合系統中存在的封裝和調試困難等問題,提出了:用一段直徑為600 m的裸石英光纖代替柱透鏡,對半導體激光器輸出光束進行準直整形;用球透鏡光纖對準直后的光束進行聚焦,直接實現和光纖耦合,來代替聚焦透鏡和光纖耦合的環節。A laser diode with 976nm center wavelength and 2. 03w maximum cw output power is pumping unidirectionally through the couple - imaging system on a double - clad yb - doped silica fiber with a yb - concentration 0. 65 mol % circular inner core, a d - shaped inner clad, and 15m length by f - b cavity. the center wavelength of the fiber laser is 1130nm, and the maximum cw output power is 130. 7mw. an optical - to - optical conversion efficiency of 42 % and a slope efficiency of 63. 4 % are obtained
用中心波長976nm 、最大連續輸出功率為2 . 03w的ld泵浦源,通過成像耦合系統,單端直腔式泵浦纖芯摻雜濃度為0 . 65mol % 、內包層截面形狀為d形、長度為15米的雙包層摻鐿石英光纖,實現了中心波長1130nm 、最大功率為130 . 7mw的連續激光輸出,光纖激光器的光光效率為42 . 0 % ,斜效率達到63 . 4 % 。
分享友人