研磨混合機 的英文怎麼說

中文拼音 [yánmóhúngějī]
研磨混合機 英文
putty chaser type mixer
  • 研 : 研同 「硯」
  • 磨 : 磨動詞1 （摩擦） rub; wear 2 （研磨） grind; mull; polish 3 （折磨） grind down; wear down [out]:...
  • 混 : 混形容詞1. （渾濁） muddy; turbid2. （糊塗; 不明事理） foolish; stupid
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 機 : machineengine
  • 研磨 : 1. （用工具研成粉末） grind; pestle2. （用磨料摩擦器物使變得光潔） abrade; polish
  • 混合 : （攙雜在一起） mix; blend; mingle; admix; mixture; mix up; interfusion; commixture; blending; cre...
  1. The two constituents were compatibilized in - situ by mechanochemical reactions induced by pan - milling and the microstructure of the blend can be controlled conveniently by adjusting processing conditions. polyamide 6 / ground limestone powder ( pa6 / caco3 ) and polyamide 6 / silicon dioxide ( pa6 / sio2 ) composites were also prepared through this method. those pa6 blends and composites exhibit improved microstructure and superior mechanical properties to the systems mixed by conventional mixing methods

    研究了磨盤碾磨對尼龍6的粉碎機理，制備了就地增容、微相結構可調的聚丙烯/尼龍6 （ pp / pa6 ）及尼龍6 /碳酸鈣（ pa6 / caco _ 3 ） 、尼龍6 /納米級二氧化硅（ pa6 / nano - sio _ 2 ）共混復合材料，各體系混合效果、微相結構及力學性能均明顯優于採用傳統混合設備制備的試樣。
  2. This paper unfolds engineering disposition and theoretical research of negative temperature high performance concrete ( nthpc ) with the damage of many factors motivation, the project background based on qing - zang railway engineering, which is one of four - emphasized engineering during the tenth five - plan. due to the difference of environment of construction and service between nthpc and ordinary concrete, and therefore durability of nthpc is required to higher level. at a first, nthpc must avoid frozen damage at early age and possess anti - freezing property at later period, in order to meet engineering practicable application need, and this are two emphasized and difficult problems, as for nthpc ; by means of mechanism analysis about deicing - agent ingredient and anti - freezing at early period, adopting composite technique routine of mineral addition + anti - freezing element + water - reducer4 - air - entraining + anti - erosion of steel component etc, based on orthogonal experimental approach, fd - 1 composite functional admixtu re was manufactured, which has more property and orientation on qing - zang railway

    負溫混凝土由於和普通混凝土在施工環境及服役環境上存在的差異，因此表現為比普通混凝土更為較高的耐久性要求；負溫混凝土首先要避免早期的凍害以及具備長期抗凍性能，才能夠滿足工程實際應用的要求，這也是負溫混凝土必須解決的兩大技術關鍵；通過對目前常用防凍劑組分作用機理的分析研究及混凝土早期防凍機理探討，採用礦物外加劑+防凍組分+高效減水劑+引氣+阻銹組分功能復合的技術路線，通過正交試驗設計復配了適應青藏鐵路工程要求的專用多功能復合型外加劑fd - 1 ；並在此基礎上配製不同等級負溫高性能混凝土，開展一系列包括硫酸鹽侵蝕、氯離子滲透、抗凍融循環、收縮及耐磨性等耐久性能研究；通過對fd - 1組分和摻量的調整，優化負溫混凝土在施工特性、力學指標和耐久性三個方面的兼容、協調性。
  3. Polymer mixing effect in a series disc extruder

    串聯式磨盤擠出機提高聚合物復合材料混煉質量的研究
  4. Using the solubility of castor oil and other solvents, mixed with oil, fat and wax and grinded in the three rollers machine, stirred and removed the air bubbles in the vacuum deaeration pot, the exquisite compact paste was made by intensively mixing

    摘要利用蓖麻油等溶劑的溶解性，混合於油、脂、蠟，經三輥機研磨及真空脫泡鍋中攪拌、脫除空氣泡，得以充分混合製成細膩緻密的膏體。
  5. Turning the grinding machine round, driven the barrel body to rotate by the transmission, the work piece that makes in the barrel, grinding stones and adding and grinding pharmaceutical and water in right amount, mix in barrel, is it is it flow layer to produce through action of gravity to make use of, flow friction on layer grind cutting, reach the work piece and process the surface quality taken

    ?轉研磨機，是由傳動帶動桶身旋轉，使桶內的工件、研磨石與添加適量研磨劑和水，在桶內混合，藉由重力作用而產生流動層，進而流動層的磨擦進行研磨切削，達到工件加工所要的表面品質。
  6. The research of high performance pavement concrete ( hppc ) is done in two sides. one is mixture design, the other is pavement performance. the mixture design and design flowchart of hppc is given on the base of nc with the consideration of characteristic of both hppc and nc. the grow law, influencing factor and formation mechanism of hppc strength is analisised by perpendicular experiment. in the same, the fatigue equations are set up for hppc and hppc i on the base of fatigue experiment. the fatigue mechanism of hppc is analysised by damage mechanics and fracture mechanics. brittleness, frost resistance and abrasion resistance of hppc is researched with the camparition to nc i. at last, the economic analysis of hppc is done by two kinds of way

    結合高性能混凝土與普通路面混凝土的特點，提出了建立在普通路面混凝土基礎上的高性能路面混凝土配合比設計方法，給出了設計流程；通過正交試驗（強度試驗） ，分析了高性能路面混凝土的強度發展規律、影響因素與形成機理；同時，根據疲勞試驗結果採用雙參數weibull分佈模型分別建立了高性能路面混凝土和高性能路面混凝土（沒有摻加硅粉）疲勞方程，應用損傷力學和斷裂力學，分析了高性能路面混凝土的疲勞機理；並採用了對比分析方法，研究了高性能路面混凝土的脆性、抗凍性和耐磨性等。
  7. The process of in situ synthesis in salt activated by ma is discussed, and the separation of activation and reaction during ma is investigated. the ti - c mixtures with elevated system energy from mechanical activation occur due to thermal activation from in salt bath

    在「機械激活鹽浴合成」工藝中，將高放熱體系在普通反應研磨工藝中所存在的孕育期與反應期分離，利用初始ti - c混粉在孕育期中所積累的儲存能和高溫熔鹽反應介質所提供的熱激活作用來促發粉體中的合成反應。
  8. 1 resin with bad wetness systems such as epoxy resin, polyester, alkyd, acrylic resin, use compound with the surface active agent, and the thixotropic grind materials can be acceptable. operate as following process : add paint material all kind of resin and the solvent - add the organic bentonite pre - gel, stir enough - add the pigment, stir and disperse enough - dilute

    1潤濕性比較差的環氧，聚酯，短油酸樹脂，丙烯酸樹脂等與表面活化劑合用，且觸變性研磨料科被接受的情況下，按照以下步驟操作：加油漆和溶劑混合加入有機預凝膠充分攪拌分散加入顏料充分攪拌分散稀釋。
  9. A kind of polishing wheel installed in the equipments imported from germany or czechoslovakia and in the polishing machine for crystal glass decoration, which is made from high flexible macromolecule, aluminum oxide and cerium oxide

    一種安裝在德國、捷克進口設備以及國內自主研發的水晶玻璃飾品研磨機上的拋光盤（輪） ，它是由高彈性和高強度的高分子材料與很鋒利的拋光性能極佳的氧化鋁、氧化鈰等軟質磨料進行混合反應而製作。
  10. The planet type ball mill is the laboratory, produce in batches by grinding, mixing the equipment high - efficient and ultraly and thinly small

    行星式研磨機是實驗室、小批量生產用高效超細研磨、混合設備。
  11. The essay researched the compressive strength, bending strength, impact resistance and abrasion resistance of high strength polypropylene fibermesh concrete the mechanism of enhancing the properties of high strengh poloypropylence fibemesh road concrete composite was discussed and analyzed the regression on tensile strengh with portland cement mixed with fiber was derived using experiment the tensile strength of fiber soil stablization with porland cement was increased with dosage and length of fiber while the former was more effective than the latter test and analysis results indicate that polypropylene fiber can not only reinforce the strength of concrete, but also obviously promote the flexural fatigue life by the great stress the application of polypropylence fiber reinforced concrete in pavement construcion are also introduced

    文章研究了不同摻量有機纖維混凝土的抗壓、抗折強度、抗沖及性能、疲勞性能及耐磨性等各種路用性能，綜合論述了有機纖維對水泥混凝土路用性能的影響。通過試驗闡述了纖維水泥混凝土各種路用性能與纖維摻量、長度間的關系。分析表明纖維水泥混凝土隨著纖維摻量和長度增加而增加，且纖維摻量對纖維混凝土抗拉強度的影響比纖維長度的影響更大。
  12. The evolution on particle morphology, microstructure, grain size and microstrain of the mixture of ti and al elemental powders during mm has been investigated. it was found that the nanocrystalline composite powders with extremely fine ti / al alternative lamellar structure ( lamella spacing about 0. 1 ~ 0. 5 m ) could be prepared by mm using proper processing parameters

    研究了ti 、 al單質元素混合粉在機械球磨過程中的顆粒形貌特徵、組織結構、晶粒尺寸以及微觀應變的變化規律，表明在適當的球磨工藝條件下可獲得具有極細層片間距（ 0 . 1 ~ 0 . 5 m ）的納米晶ti / al機械復合粉。
  13. The microstructures hardness grinding performances and mechanical properties of the composites have been analyzed. this paper also discusses the influences of quality ratio and mixture of different oxides to the composites " properties. at the same time, the thermodynamic principles and principles of dynamics have been studied

    本文研究了四種原位反應體系： cuo al 、 cuo + sio _ 2 al 、 cuo + tio _ 2 al 、 cuo + sio + _ 2 + tio _ 2 al ，並對由這四種原位反應體系所制備的鋁基復合材料的微觀組織、布氏硬度、耐磨性能以及拉伸力學性能作了分析與檢測，討論了不同氧化物配比以及不同氧化物的混合對復合材料性能的影響，研究了氧化物與al發生置換反應的熱力學與動力學機理。
分享友人
分享到 Line

分享到臉書