硅氧聚合物 的英文怎麼說

中文拼音 [guīyǎngjùgěwù]
硅氧聚合物 英文
silicone polymer
  • 硅 : 名詞[化學] silicon （14號元素符號 si）
  • 氧 : 名詞[化學] （氣體元素） oxygen （o）
  • 聚 : 動詞（聚集; 聚積） assemble; gather; get together
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 物 : 名詞1 （東西） thing; matter; object 2 （指自己以外的人或與己相對的環境） other people; the outsi...
  • 聚合物 : [化學] polymer; polymerizate; polymeric compound; polymeric substance; polymeride; polymerized su...
  • 聚合 : 1 （聚集到一起） get together2 [化學] （單體結合成高分子化合物） polymerization; polymerize 3 [生...
  1. In this thesis, the development of emulsion polymerization theory and related new technologies are comprehensively reviewed, and the synthetic technologies of acrylate latex modified by organosilicon both at home and abroad are also reviewed. based on the current development and research in this field, attentions of this study are focused on three ways for preparing novel acrylate latexes modified by organosilicons, that is, 1 ) the acrylate monomers are copolymerized with unsaturated silicons by emulsion copolymerization ; 2 ) a new latex with microphase separation morphology is synthesized, which shows a core - shell structure character ; 3 ) soap - free polymerization is explored for preparing a higher - performance latex using an unsaturated silicon monomer, different acrylates and a reactive emulsifier. by using techniques of delaying addition of organosilicon monomer and a hydrolysis inhibitor, the hydrolysis and condensation of 3 - ( trimethoxysilyl ) propyl methacrylate during polymerization can be effectively prevented, as a result, organosilicon content in the macromolecular chain is increased

    同時採用有機硅單體延遲滴加及添加水解抑制劑等技術，有效防止了-甲基丙烯酰氧基丙基三甲氧基硅烷在乳液聚合過程中的過渡水解及縮合反應，提高了聚合物大分子鏈中有機硅鏈節的含量；利用紅外光譜與差示掃描量熱儀對產物分子結構進行了表徵，並通過對共聚產物力學和吸水率的測試，證實了本研究所制備的有機硅改性丙烯酸酯共聚物具有比純丙烯酸酯聚合物更優良的力學及耐水性能；從分子設計角度出發，利用醇解反應合成出水解、縮合反應速率較慢的兩種新型不飽和有機硅單體： ?甲基丙烯酰氧基丙基三乙氧基硅烷和?甲基丙烯酰氧基丙基三異丙氧基硅烷；利用核磁共振對新型硅烷單體結構進行了證實；研究表明利用新型硅烷單體可以制備出高硅烷含量的有機硅改性丙烯酸酯乳液，且其聚合產物具有較高的力學及耐水性能。
  2. Mechanistic study of the hydrolytic oligomerization of - aminopropyltriethyoxysilane and characterization of the products

    氨丙基倍半硅氧烷的水解聚合機理研究及產物結構表徵
  3. Abstract : researches on unformaldehyde unironing finishing are summarized in this paper. functions and deficiencies of glyoralamido, water soluble heat reactive polyure thane, bishydroxyethyl - sulfoue, natural high precision chitosan, reactive organosilicon, amyloidosis epoxide, multiple carboxyl acid compound are also analyzed and compared

    文摘:綜述了無甲醛免燙整理方面的研究，分析比較了乙二醛-酰胺類整理劑、水溶熱反應性聚氨酯、雙羥乙基碸、天然高聚物殼聚糖、反應性的有機硅、澱粉改性物、環氧類整理劑、多羧酸化合物等無甲醛抗皺整理劑的功能以及各種整理劑存在的不足
  4. Abstract : the synthesis, molecular structure and modification of amino modified polysiloxane, a softening agent for textile, are summarized, and softening agent of different structure are also describe briefly

    文摘:綜述了以氨基改性聚硅氧烷為主的織物用柔軟劑的合成、分子結構及進一步的改性。
  5. In this paper, interpenetrating polymer networks ( ipn ) based on polysiloxane ( pdms ) and poly ( methyl acrylate ) ( pma ) were prepared by using ma monomer and two types of pdms, which viscosities were 3300pa s and 7000pa s respectively. pdms was crosslmked by tetraethyl orthosilicate

    本論文制備了聚二甲基硅氧烷與聚丙烯酸甲酯的序列半互穿聚合物網路，其中聚硅氧烷為交聯結構，採用粘度分別為3300pa ? s和7000pa ? s兩個品種，聚丙烯酸甲酯為線性聚合物。
  6. Synthesis and characteries of side - chain liquid crystalline - polymethylhydrosiloxane containing two mesogenic units

    側鏈含有兩種介晶基元的聚硅氧烷類液晶聚合物的制備與性能
  7. And the value drop to the lowest at ph = 0. 8. as the increase of heat treatment temperature, the pore size distribution peak of sio2 microspheres is very narrow, meanwhile the specific surface area is the smallest before 160 c. the polymer template is removed at 350 c, so the pore structure of sio2 particles has a big change which involve the increase of specific surface area and the broaden of pore size distribution peak. with the continuous raise of temperature the sio2 network will shrink little, as a result the average pore size will decrease, but the specific surface area has no obvious change

    結果發現：二氧化硅膠體顆粒均勻分佈於脲醛聚合物網路中，煅燒去除有機模板后微球表面變粗糙，而粒徑沒有明顯變化； ph值較小時，復合微球中聚合物含量較大，而ph值較大時，得到復合微球結構鬆散，因此熱處理后的二氧化硅微球孔容及平均孔徑都較大，而在ph = 0 . 8時，得到最小值；武漢理工大學碩士學位論文隨著熱處理溫度的變化，小於160時，空分佈較窄，而比表面積較小，在350時，由於有機模板的去除，微球孔結構發生突變，比表面積明顯增大，而孔徑分佈變寬，溫度繼續升高時，二氧化硅網路發生收縮，平均孔徑變小而比表面積由於有機炭化物的完全去除沒有太大變化;微球中的微孔在熱處理過程中處于平衡狀態，分佈沒有太大變化。
  8. In this paper, the synthesis methods about the copolymers of poly ( amino acid ) - polyester, poly ( amino acid ) - chitosan, poly ( amino acid ) - siloxane and poly ( amino acid ) - polyester were introduced

    文中簡單綜述了聚氨基酸聚醚嵌段共聚物、聚氨基酸甲殼素共聚物、聚氨基酸硅氧烷共聚物和聚氨基酸聚酯共聚物的合成方法。
  9. Latterly, it coupled with ultraviolet absorption spectroscopy ( uvas ), capillary electrophoresis ( ce ) and other apparatuses. up to date, many experimental coatings were prepared and investigated for a wide range of applications

    纖維塗層是spme的核心部位，常用的塗層材料多為液相聚合物，如聚二甲基硅氧烷（ pdms ） 、聚丙烯酸酯（ pa ）等。
  10. Discussed conditions and factors of synthesis of the polydimethylsiloxane - phenylsilsesquioxane with pdms and ptms. analyzed the character of the polydimethylsiloxane - phenylsilsesquioxane with ir 、 1h - nmr

    摘要探討了用羥基硅油（ pdms ）和苯基三甲氧基硅烷（ ptms ）合成聚二甲基硅氧烷梯形苯基倍半硅氧烷共聚物的反應條件，通過ir 、 1h - nmr確定了目標產物的結構。
  11. The resulted films were densely packed uniform amorphous films with substantial overlap between adjacent si02 layers, and can serve the function as antireflection coatings. colloidal ti02 particles of 3 ~ 4nm in diameter were prepared using tetra - h - butyl titauate as precursor, and composite multilayer films of pss / tio2 were electrostatically self - assembled

    二氧化硅膠體與聚合物pdda的自組裝多層復合薄膜為均勻、緻密的非晶態膜，復合薄膜內存在層間穿插的現象，薄膜表現出均質單層光學塗層的特性並具有增透作用。
  12. Surface status and formation of ultrafine silicon dioxide after polymer grafting modification

    聚合物接枝改性超細二氧化硅表面狀況及形成機理
  13. Test method for silicon content of silicone polymers and silicon - modified alkyds by atomic absorption

    原子吸收光譜法測定硅氧烷聚合物和硅氧烷改性的醇酸樹脂中硅含量的試驗方法
分享友人
分享到 Line

分享到臉書