硬脹壓 的英文怎麼說

中文拼音 [yìngzhàngyā]
硬脹壓 英文
turgor pressure
  • 硬 : 形容詞1 （堅硬） hard; stiff; tough 2 （剛強; 堅定; 強硬） strong; firm; tough; obstinate 3 （勉...
  • 脹 : 動詞1. （膨脹） expand; dilate; inflate 2. （脹大） swell; distend; bloat
  • 壓 : 壓構詞成分。
  1. Inorganic anti - cracking reinforced chemical additive, called wj, generates some tittle expansive crystals in hydration process in concrete to reduce the porosity and improve the distribution of pore size. the expansive power is process in common to tumefaction that petty crystalloid aft suck water and pressure to concrete pores that aft crystal gather volume. its adding weight was 8 % - - 12 % in cement, its restrained expansive ratio was about 0. 02 % - - 0. 06 %, and relevantil brought self - stress 0. 2mpa ?. 6mpa

    無機增強抗裂材料wj摻入普通混凝土中，在水化硬化過程中生成一定量的微膨脹結晶體，降低空隙率，改善混凝土中孔結構分佈。其膨脹驅動力是凝膠尺寸的晶體鈣礬石吸水腫脹和結晶狀鈣礬石對孔隙產生膨脹壓的共同作用。當wj摻量為8一12兒在鋼筋和鄰位的限制下，使混凝土產生0
  2. The results indicated that, the fabrication process of ultra - fine grain material is mainly determined by the stress, rotate speed and the flux of cooling water. the grain refining and the hardening effect are mostly affected by the rotate speed and the flux of cooling water. compared with commercial ly12, the invalidate strength and the prolongation rate of the ultra - fine grain material are properly improved in the measurement of compression property ; and the abrupt change of the dilatability of the ultra - fine grain material at 500c is found ; also the phenomena of which the grain size of these microstructures is stable when annealed under 300c is observed

    研究表明，採用本文提出的摩擦壓扭強變形區轉移法可以得到棒狀的超細晶材料，軸向壓力、扭轉速度和溫度是採用該方法制備超細晶材料的主控參數；試件的旋轉轉速和冷卻速度對變形區晶粒細化和硬化效果影響顯著；超細晶ly12的壓縮性能與淬火+自然時效狀態的ly12壓縮性能相比，斷裂強度和延伸率均有一定程度的增強；超細晶ly12的熱膨脹系數在550左右發生明顯的變化。
  3. Making sensitive material : made in non - sulfur vulcanization system with the formula : epdm 100kg, dicumylperoxide ( dcp ) 2kg as cross - linking agent, stearic acid 1kg as processing aid, oxidized zinc ( zno ) 3kg as accelerant, wax oil 10kg as lubricant ; and made in vulcanizing condition : vulcanizing temperature 170 c, vulcanizing time 15minutes, vulcanizing pressure 3 mpa, the vulcanized epdm is optimal sensitive material for petrol. the sensing head equipped with the vulcanized rubber possesses two qualities : better swelling response and better anti - interfere against temperature variation

    敏感材料的制備：用無硫硫化體系；配方為：生膠100kg ， dcp2kg ，硬脂酸1kg ， zno3kg ，石蠟油10kg ；硫化條件：硫化溫度170 ，硫化時間15分鐘，硫化壓力3mpa ，制備的硫化橡膠對汽油的監測較理想，用其裝備的傳感頭不僅有較好的溶脹響應性能，而且有很好的抗溫變干擾能力。
  4. Inhibitory pressure of collar size 17 and waistcoat 5 buttons, two articles of clothing superfluous in the costume of mature males and inelastic to alterations of mass by expansion

    硬領十六英寸型和背心有五顆紐扣緊得使他感到壓力。這兩樣東西對成年男子的服裝來說是多餘的，而對人體的膨脹所引起的容積變更卻又缺乏彈性。
  5. In the study, a new kind inorganic anchoring material was developed, which consisted of special binder and aggregate, the former is made from clinker, blast furnace slag and compound admixture, and the later is superfine sand. effects of the factors such as clinker / slag, binder / sand, solution / binder and constituent of solution on the strength, set - time and contraction of the matrix made from the anchoring material were studied

    上述分析研究得出以下結論：新型無機錨固材料具有早強、快硬、高強特點， 10h .抗壓強度可達26 . 5mpa ， 365天強度可達144 . 0mpa ；初凝時間在40min . 3h .之間，且初終凝時間差在15分鐘以內；在保濕條件下具有微膨脹性，膨脹率在0 . 5 %以內。
  6. Standard test method for autoclave expansion of hydraulic cement

    水硬水泥熱壓膨脹的標準試驗方法
  7. Secondly, the producing mechanism of crack in reinforced structure and factors which affect crack have been discussed, in the emphasis, the method is expounded, which applies first releasing then resisting, combination of releasing and resisting. in the method, flexible slit is applied firstly, which can make deformation of structure distributed, and decrease deformation energy, then the tiny expansion concrete and prestressed concrete with unbonded tendons are applied. and in the different phase, the compressive prestress is put on the concrete structure

    其次，分析並論述了鋼筋混凝土結構裂縫產生的機理和影響因素，著重闡述了「利用先放后抗，抗放結合，綜合控制」的方法：即首先利用后澆帶，使混凝土結構分段變形，減小超長變形的影響；並採用微膨脹混凝土技術及無粘結預應力混凝土技術，分階段對混凝土結構施加一定的預壓應力，從而減小或完全抵消混凝土結構因混凝土硬化收縮引起的拉應力；再結合一些其他措施，成功實現鋼筋混凝土結構的超長無縫設計與施工。
  8. The analytic results of the effects on the micromorphological structure of the film by the electrochemical condition ' s showed that the carbon is apt to improve the boundary combination between the scfs and the surface of the cathode and the seperation of the films, and that the micromorphological structure of the mpgcfs is greatly affected by the dring and the power voltage, which remarkably affluence ion move in swelling cathode film, and that higher temperature and concentration of cu2 + in the medium solution are also advanagable to the deposition of cu in scfs. the plot of deformation behavior of mpgcfs showed that the maximum strench ratio decreases and the brittleness increases due to the existence of the metal phase, and that the strengh trend of the composite films is fistly up and down followed with the content of metal phase because of the change of the role of the metal phase from acting as the physical cross - linking to weakening the films due to destroying the whole structure of the polymer

    另外它作為基體的另一個突出的優點是制備的溶脹復合膜（ scf ）中的溶劑與電解液中的溶劑相同都是水，克服了以前膜內外不同溶劑之間擴散的問題，結果使得電流最終趨於一種穩態，因此可以更好實現用電化學條件來控制mpgcf的形態結構；硬質石墨材料的多孔的結構和石墨本身的結構性能特點使得碳作為陰極材料時有利於溶漲復合膜（ scf ）與電極表面的結合以及膜的剝離，因此是作為陰極的理想材料；電化學條件中的乾燥程度和電壓能夠明顯的影響離子在膜內的遷移，從而對mpgcf的形態結構造成較大的影響；而提高反應溫度和增大電解液中銅離子的濃度也有利於銅在膜中的沉積生長。
分享友人
分享到 Line

分享到臉書