碳塊 的英文怎麼說

中文拼音 [tànkuāi]
碳塊 英文
carbon block
  • 碳 : 名詞[化學] （非金屬元素） carbon （c）
  • 塊 : 名詞（古時佩帶的玉器） penannular jade ring （worn as an ornament in ancient china）
  1. Arguments and evidence cited against a miraculous origin of the shroud images include a letter from a medieval bishop to the avignon pope claiming personal knowledge that the image was cleverly painted to gain money from pilgrims ; radiocarbon tests in 1988 that yielded a medieval timeframe for the cloth ' s fabrication ; and analysis of the image by microscopist walter mccrone, who concluded ordinary pigments were used

    爭論和證據卻與裹屍布的神奇起源相反，包括一封中世紀的主教寫給教宗阿維尼翁的信，聲稱肖像是有人運用容貌知識聰明地印上去，為了從朝聖者身上獲得金錢； 1988年，碳的放射性同位元素測試得出這是一塊中世紀時期製造的偽造物；分析肖像的顯射鏡技術人員沃爾特指出，這只是使用了一種平常的顏料。
  2. This sandstone unit is commonly thick-bedded and massive, with silty and carbonaceous laminations.

    該砂層單元通常為厚層或塊狀，具粉砂質和碳質紋層。
  3. In places on crationic edges, giant carbonate platforms may develop.

    在克拉通（穩定地塊）邊緣的某些地區，可發現巨大的碳酸鹽臺地。
  4. The particles distributed hi the matrix of grey cast iron, but some contact each other. the composite layer extend gradually into the substrate. when volume fraction of wc is 36 wt % and 27 wt %, the matrix of the composite is high chromium cast iron, consist of white carbide bars and the austenite. wc particles distributed uniformly, retaining approximately quondam granular form in the composite layer which has an evident interface area with the substrate, with good bonding strength

    對不同碳化鎢體積分數的灰鐵和低鉻鑄鐵基復合材料的微觀組織結構分析表明：碳化鎢體積分數為52時，復合層內基體為灰口鑄鐵組織，顆粒直接分佈在灰鐵基體上，部分碳化鎢顆粒有相互接觸的現象，基材與復合層之間沒有明顯的過渡；碳化鎢體積分數為36 、 27時，復合層內基體為高鉻鑄鐵，由面塊狀的奧氏體和白條狀碳化物組成，碳化鎢顆粒表面固溶於基體組織中，粒形基本保持完整，分佈均勻，與基體構成冶金結合，基材與復合層之間存在一個明顯的平緩過渡區。
  5. Improvement of masonry techniques of cell sidewall carbon brick

    電解槽側部碳塊砌築工藝的改進
  6. If business - as - usual trends did lead to the widespread adoption of synfuel, then capturing co2 at synfuels plants might well produce a wedge

    假使現行政策與產業體系的趨勢真的使合成燃料普遍使用，那麼在合成燃料廠捕集二氧化碳，也可能達成一塊楔形。
  7. Aim of this study was to meet the need for development of tribological parts in pumps. at room temperature tribological properties of different sliding pairs of silicon carbide and alumina - based ceramics were tested using a laboratory tribometer in the ring - on - plate geometry under reciprocating sliding linear contact in different media, such as distilled water, aggressive media and air

    本文針對目前泵用摩擦零部件材料發展的需要，在實驗室摩擦磨損試驗機上研究了按環/塊線接觸方式作往復運動條件下的碳化硅和氧化鋁基陶瓷材料摩擦副在水、化學腐蝕性介質作潤滑劑和無潤滑時室溫下的摩擦磨損特性。
  8. Methods of sampling and test for carbonaceous materials used in aluminium manufacture - cold ramming pastes - determination of water content of unbaked pastes

    制鋁工業用碳素材料取樣和試驗方法.第4部分:冷搗糊塊.第5節:未烘焙糊塊含水量測定
  9. Methods of sampling and test for carbonaceous materials used in aluminium manufacture - cold ramming pastes - determination of maximum rammed apparent density of unbaked paste

    制鋁工業用碳素材料取樣和試驗方法.第4部分:冷搗糊塊.第6節:未烘焙糊塊最大表觀搗實密度測定
  10. Uranium dioxide pellet - determinaiton of carbon

    二氧化鈾芯塊中碳的測定
  11. Tectonic movement in interaction with the ocean, atmosphere and living things form the carbon cycle, adjusting the carbon dioxide content in the atmosphere and stabilizing the surface temperature on earth

    板塊運動在與海洋大氣及生物互動下形成碳循環，調節大氣中二氧化碳的含量，從而穩定地球的氣溫。
  12. Carbonaceous materials used in the production of aluminium - prebaked anodes and cathode blocks - determination of flexural strength by the four - point method

    鋁生產用碳素材料.預焙陽極和陰極碳塊.用四點法測定抗彎強度
  13. Carbon ramming material is used on the spacer, the bottom of blast furnace and some other parts of the blast furnace

    高爐爐底墊層、爐底和爐缸環行碳塊與爐殼間的間隙，爐底水冷管以上到爐底鋼板。
  14. Contracted with rual trade limited, the third largest aluminum company in the wor ld, we exported 3000tons ' bottom cathode blocks and 10000tons ' coal tar pitch in 20 04, which amounted near 300million us dollars

    2004年，公司與世界上第三大鋁業公司?俄羅斯鋁業集團出口成交約3000噸陰極碳塊、 10000多噸高溫改質瀝青，出口創匯近300萬美元。
  15. Method for dimensions and aspect for the carbon block of blast furnaces

    高爐碳塊尺寸及外觀檢查方法
  16. Compared with carbon, silicon nitride bonded silicon carbide has better oxidation resistance and bigger resistance ratio, which make it be a perfect line material of al electrolysis cell

    在鋁電解方面，氮化硅結合碳化硅遠較陰極碳塊耐腐蝕、抗氧化、電阻率高，是理想的電解槽側壁內襯材料。
  17. Testing methods for carbon blocks

    碳塊的測試方法
  18. Carbon block for blast furnaces

    普通高爐碳塊
  19. Methods of sampling and test for carbonaceous materials used in aluminium manufacture - electrodes - determination of electrical resistivity of cathode blocks and prebaked anodes at ambient temperature - section 3. 6 determination of electrical resistivity of cathode blocks and prebaked anodes at ambient temperature

    制鋁工業用碳素材料的取樣與試驗方法.電極.室溫下陰極碳塊和預焙陽極電阻率的測定
  20. Methods of sampling and test for carbonaceous materials used in aluminium manufacture - electrodes - determination of the bulk density apparent density of cathode blocks and prebaked anodes using a dimensions method - section 3. 3 determination of the bulk density apparent density of cathode blocks and prebaked anodes using a dimensions method

    制鋁工業用碳素材料的取樣與試驗方法.電極.用尺寸法測定陰極碳塊和預焙陽極的體密度
分享友人
分享到 Line

分享到臉書