碳氟劑 的英文怎麼說

中文拼音 [tànfújì]
碳氟劑 英文
fluorocarbon agent
  • 碳 : 名詞[化學] （非金屬元素） carbon （c）
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  1. This product had strong property of separation and recovery of organic dissolvent and vapour, such as ether, ketone, alcohol, thf, dichlorotetra, chlorolform, narkosid, carbon disulfide disulphide, carbon, benzol, gasoline oil, etc

    對醚類、酮類、醇類、四氫呋喃、二氯四烷、三氯甲烷、三氯乙烯、二硫化碳、苯、甲苯、甲酰、汽油及含汞、含氟烴類有機溶劑和有機蒸氣有很強的分離、回收性能。
  2. The modified expoxy resins, i. e. those with plasticizers added to improve workability, were found to be incompatible with the fluoro carbon flotation fluids.

    改性的環氧樹脂，即加入了可塑劑已改善操作性能的樹脂，與氟碳化合物的浮液是不相容的。
  3. Fluorocarbon emulsion used as blood substitute

    6氟碳乳劑人工血。
  4. Panipenem and imipenem exhibited comparable in vitro antimicrobial activity, and their activity against gram - negative bacteria such as k. pneumoniae and enterobacter spp was slightly inferior to meropenem, superior to that of ceftazidime, fluroquinolones and - lactam and - lactamase inhibitor combinations

    三種碳青黴烯類抗生素體外抗菌作用優于頭孢他啶、 -內酰胺類抗生素與-內酰胺酶抑制劑合劑、氟喹諾酮類等其它受試藥物。
  5. The analysis of fluorocarbon resin content in fluorocarbon lacquer by using oxygen bomb burning method with fluorin ion electrode are discussed in detail

    摘要採用氧彈燃燒法配合氟離子電極對有機濃劑型和水溶性氟碳漆中氟碳樹脂含量的分析方法進行了研究。
  6. The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine

    用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌：用xrd進行原料物相分析，及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度；用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性；用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化；用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試；採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定；用萊次偏光顯微鏡（ pm ）測試固體潤滑劑的硬度；用材料試驗機測試固體潤滑劑的抗壓強度等。
  7. After looking up a large amount of native and foreign information, the materials used in the experiment were as follows : ptfe base, graphite filler, molybdenum disulfide filler, copper powder filler, carbon fiber and so on. the experimental method is that the formula was designed according to uniform experimental method, the relationship between formula and frictional property was found with spline function and then the representative test points were chosen from fitting curve to make verification test for optimization. the preparative technique of solid lubricant is cold - press sintering method

    經過查閱大量國內外文獻資料后確定原料為：聚四氟乙烯樹脂為基體，加入石墨、二硫化鉬、銅粉、碳纖維等填料；試驗方法為：根據均勻試驗方法設計配方，用樣條函數找出配方與摩擦性能的關系，然後在擬合曲線上選取具有代表性的試驗點進行驗證試驗，達到優化的目的；制備工藝：冷壓燒結法制備固體潤滑劑。
  8. The results indicated that the dimension, shape and purity of base material could meet the functional demand of solid lubricant ; the thermal decomposition temperature of ptfe resin exceeds 400 c, but organic and inorganic packing filler added in ptfe made the water absorption rate of composite material increased, melting temperature and decomposition temperature decreased, in the meanwhile oxidative decomposition reaction was accompanied ; polar groups such as c = o, c - o - c and so on in the carbon fiber surface is advantageous to increase compatibility with other components and interlayer shearing strength ; uniform design experimental method could help to find the relationship between formula and frictional property by relatively small tests. the developing trend of each formula ' s friction coefficient could be showed by fitting curve ; the friction coefficient with no copper powder or graphite in formula was relatively big. this fact showed that copper powder and graphite should be used cooperatively ; it was found that when the ratio of copper powder to graphite by weight is 15 : 60, 30 : 30 - 40 and 60 : 15 - 30 respectively, the friction coefficient was relatively small. the degree of crystallinity of pure ptfe reached maximum by air cooling and the abrasion loss also reached maximum among three ones ; at the same time, the abrasion loss of solid lubricant sample was also the biggest among three ones ; when solid lubricant matched with 45 # steel axle or gcrl5 steel axle, lubricant transfer film could be formed on metal surface, thus direct contact between the surface of metal friction pair rings was reduced. their working life was elongated extremely ; there was mainly much graphite, a little ptff, moo3, feso4, cus and so on in lubricant transfer film

    試驗結果表明：所選原料的尺寸、形狀及純度可滿足固體潤滑劑的性能要求；聚四氟乙烯樹脂熱分解溫度超過400 ，但在ptfe中加入無機填料會使復合材料吸水率提高，熔融溫度及分解溫度降低，且伴有氧化分解反應；碳纖維表面含有c = o及c - o - c等極性基團，有利於提高其與其它組分的相容性，提高層間剪切強度；均勻設計試驗方法能夠用較少的試驗次數找出配方與摩擦性能間的關系，擬合曲線基本能表示各配方的摩擦系數發展趨勢；配方中不加銅粉或不加石墨，其摩擦系數均較高，說明銅粉和石墨應該配合使用；當銅粉15份、石墨60份時，銅粉30份、石墨30 - 40份時，銅粉60 、石墨15 - 30份時，摩擦系數均具有較低值；純聚四氟乙烯樹脂在空氣冷卻時結晶度最大，磨損量也是三者中最大的；同時，固體潤滑劑試樣在空氣冷卻時的磨損量也是三者中最大的：不論是固體潤滑劑與45 #鋼軸配副或是固體潤滑劑鑲嵌入銅套后與gcr15鋼軸配副，在金屬表面均可形成潤滑轉移膜，從而減少金屬摩擦副表面間的直接接觸，大大延長其使用壽命;轉移膜中主要含有較多的石墨、少量聚四氟乙烯、 moo 。
  9. Xinyu ganfeng lithium co., ltd. is a hi - tech enterprise integrating research, production and trade, specialized in the development and manufacture of lithium, rubidium, cesium series products such as lithium metal for catalysts, lithium metal for batteries, lithium chloride, lithium fluoride, rubidium carbonate, cesium carbonate, etc. fengxin keyuan lithium co., ltd is a subsidiary of ganfeng lithium co., ltd, and keyuan lithium co., ltd, it is located in fengxin county, 60 kilomiles away from nanchang of the capital of jiangxi province

    新余市贛鋒鋰業有限公司是集科、工、貿於一體的高科技術企業，專業從事催化劑專用金屬鋰、電池金屬鋰、氯化鋰、氟化鋰、碳酸銣、碳酸銫等鋰、銣、銫系列產品的生產、開發工作。贛鋒鋰業在離江西省省會南昌60公里的奉新縣設有一子公司?奉新科源鋰業有限公司。
  10. Aerospace series. lubricating dry fluorocarbonated without binding material or filler, maximum thickness of 10 micrometer on metallic substrate. quality of coated parts

    航空航天系列.金屬基體表面最大厚度10千分尺的不帶有粘結材料或填料的乾式氟碳潤滑劑.被塗零件的質量
  11. The results show that for organic solvent typed fluorocarbon lacquer and specially treated water soluable fluorocarbon lacquer, the content of fluorocarbon resin can be determined accurately with the above method

    結果表明，採用氧彈燃燒法配合氟離子電極對有機溶劑型氟碳漆及處理后水溶性氟碳漆的氟碳樹脂含量能夠進行準確測定。
  12. Made of high - speed mixing polytetrafluoethylene resin and a certain volume of filling agent ( such as carbon fiber, graphite, molybdenum disulfide, glass fiber and bronze powder etc. ) shaped by moulding then through high heat sintering

    用聚四氟乙烯樹酯與一定量的填充劑（如：碳纖維、石墨、二硫化組、玻璃纖維、青銅粉等）經高速混合均勻後用模塑成型經高溫燒結製成。
  13. The main properties and applications of supercritical hydrofluorocarbon are reviewed. the industrial utilization of supercritical hydrofluorocarbon as a polar solvent to replace supercritical carbon dioxide is also discussed

    摘要介紹了超臨界氟代烴流體的主要特性及應用，探討了其作為一種極性溶劑取代超臨界二氧化碳溶劑的應用前景。
  14. Fluorosurfactants basically consist of chains of carbon atoms surrounded by fluorine

    含氟界面活性劑的基本結構是碳原子形成的長鏈，周圍環繞許多氟原子。
  15. You should buy ant or cockroach traps instead of fluorocarbon sprays ; they are less polluted and can reduce insect populations effectively. you should also try to minimise your purchases of products such as aerosol sprays that contain ozone depleting substances

    避免使用含碳氟化合物的滅蟲噴霧劑，改用? ?屋等滅蟲蟻裝置，既可有效減少蟲蟻的數目，又可減低污染程度。
  16. Honeywell specialty materials, based in morristown, n. j., is a global leader in providing customers with high - performance specialty materials, including fluorine products ; specialty films and additives ; advanced fibers and composites ; intermediates ; specialty chemicals ; electronic materials and chemicals ; and technologies and materials for petroleum refining

    總部位於新澤西莫里斯鎮的霍尼韋爾特殊材料集團是世界一流的高性能特殊材料供應商，產品包括碳氟化合物、專用薄膜與添加劑、高級纖維與復合材料、中間體、專用化學品、電子材料與化學品、用於石油精煉的技術與材料。
  17. Long - chain fluorosurfactants, based on a lineup of eight carbon atoms ( c8 ), enter the body more readily than shorter analogues, and they can break down to form pfoa

    所謂的長鏈含氟界面活性劑是指八個碳原子排成一列（ c8 ） ，會比碳鏈較短的類似化合物更容易進入生物體內，而且會分解形成pfoa 。
  18. The regulation was introduced on hong kong s own initiative to better protect the ozone layer as well as to conserve hong kong s stock of chloroflurocarbons cfcs for use in existing air conditioning equipment in view of the gradual phasing out of controlled refrigerants

    該條規例由本港自發引入，用以更有效地保護臭氧層鑒于受管制製冷劑正逐步被淘汰，該規例亦可保存氟氯化碳存貨，供現存的空氣調節裝備使用。
分享友人
分享到 Line

分享到臉書