碳酰二氧基 的英文怎麼說

中文拼音 [tànèryǎng]
碳酰二氧基 英文
carbonyldioxy
  • : 名詞[化學] (非金屬元素) carbon (c)
  • : 名詞[化學] (酰基) acyl
  • : Ⅰ數詞(一加一后所得) two Ⅱ形容詞(兩樣) different
  • : 名詞[化學] (氣體元素) oxygen (o)
  1. Silica pigment, benzene parazolone, oxalic acid catalyzer, accelerant, catalyst, deposit carbon powder, starch, paraacetaminophenetol - sulfonamide, sodiumpara - aminosalicylate ( pasna ), dalmato, p - thephalic acid, diethylbenzene - amine, titanium dioxide, acticarbon, sodium fluosilicate, fluorite, by - thiamine, silica gel powder, synthetic resin, sulfonic acid, polypropylene resin, aureomycin, pyrosodium silicate, gluchlorine acid coffee grounds, glucose, sodium sulfate, sulfide mineral, guound phosphate rock, bb, p. v. c.,

    M 、觸媒、沉澱炭粉、對乙苯磺氨、對氨水楊酸、哆耳瑪托、對苯酸、乙苯銨、化鈦、活性、氟硅酸鈉、氟石礦、副產硫銨、硅膠粉未、合成樹脂、磷酸鈣、聚丙烯樹脂、金黴素、偏硅酸鈉、糠氯酸咖啡渣、口服葡萄糠、硫酸鈉、硫化礦、磷礦粉、蘭bb 、 p . v
  2. The diphenylcarbazide photometric method for the determination of chromium sesquioxide content

    肼光度法測定三鉻量
  3. Methods for chemical analysis of high - titanium slag and rutile - the diphenylcarbazide photometric method for the determination of chromium sesquioxide content

    高鈦渣,金紅石化學分析方法肼光度法測定三鉻量
  4. Chemical analysis methods and determination of physical performance of alumina determination of chromium sesquioxide content - diphenyl carbazide photometric method

    化鋁化學分析方法和物理性能測定方法肼光度法測定三鉻含量
  5. An excellent adhesive was prepared from bismaleimide ( bmi ), epoxy resin ( e - 51 and tde - 85 ), 4, 4 ' - diaminodiphenyl sulfone ( dds ) in this thesis. the influence of liquid rubber and polymer ether imide ( pei ) on the properties ( especially high - temperature strength and the peeling strength ) were discussed, their different toughening characteristics and mechanisms were discussed. last, the process and effection of heat - resisted structural adhesive were studied by adhesive experiment of synchronizer in automobile. the results of investigation made clear : the adhesive, has good properties, especially heat - resisted properity

    根據材料分子設計的原理,研究了苯甲烷雙馬來亞胺( bmi ) 4 , 4 』 ?碸( dds ) e ? 51 tde ? 85組成的環膠粘劑體系,研究該體系在作為高溫結構膠粘劑使用時的粘接性能;然後研究了用無規羧液體丁腈橡膠( ctbn ? x )和聚醚亞胺( pei )分別來增韌該體系的增韌效果;最後通過纖維耐磨材料與同步器圓錐環的粘接實驗,研究了耐高溫結構膠粘劑的粘接工藝和使用效果。
  6. Dimethylformamide as carbon monoxide source in photoassisted hydroesterification of olefins

    胺作為一源的烯烴氫酯化反應
分享友人