磁動子 的英文怎麼說

中文拼音 [dòngzi]
磁動子 英文
magnettor
  • : 名詞1. [物理學] (磁性; 能吸引鐵、鎳等的性質) magnetism 2. (瓷) porcelain; china
  • : 子Ⅰ名詞1 (兒子) son 2 (人的通稱) person 3 (古代特指有學問的男人) ancient title of respect f...
  1. The press is ingenious in design, hign quality in materials, with features as fine workmanship, handsome appearance, compact structure, higher work pressure, lower work noise, and equipped with single skip. controlled temperature, electric autotimer, so that it will be reliable is operation and easy to repair

    本機設計精巧,用材講究、製造精良、造型美觀、結構緊湊,傳部分採用大功率雙向電離合器,可連續工作,也可單獨工作,且有壓力大、噪音小、單級跳位、溫度自控、電式時間繼電器延時,操作安全可靠、維護保養方便等優點。
  2. Depend on the comprehensive analysis and study of the structure, principle, and exterior characteristic of the motor, through the methods of system modeling and digital simulation analysis, two kind of control device that work for the low voltage ( lvdc ) and the high voltage ( hvdc ) in avigation are researched respectively. point to the control technique of close - loop speed stabilization at a limited adjustment speed range, we bring out the close - loop speed control method that using the rotor position sensor indirectly measure the speed of the motor

    在全面分析了稀土永無刷直流電機的結構特點、工作原理、運行方式以及外部特性的基礎上,通過系統建模和數字模擬分析,分別針對航空低壓直流( lvdc )和高壓直流( hvdc )兩種電機構用永無刷電機,在小范圍轉速連續調節下的閉環穩速控制技術進行了詳細理論研究,提出了利用轉位置傳感器信號間接測量電機轉速進行電機轉速閉環穩速控制的策略。
  3. Driveequipment use active magnet connected - implement to firsthand fix at the axletree of electrical engine, pumproom close completely, via magnetic force coincidence to drive impeller on rotor - assembled to circumgyrate indirectly

    裝置採用主鐵聯軸器直接裝在電機軸上,泵室完全封閉,通過力偶合間接驅組合上的葉輪旋轉。
  4. This effect occurs because the magnetism in the material is generated by innumerable magnetic atoms, like a host of tiny bar magnets, all roughly aligned but randomly fluctuating like compass needles being jiggled about

    這是因為材料的性是由無數個性原所產生的,就像一群微小的塊狀鐵,它們雖大致排齊但仍不規則,就像羅盤的指針一樣不停晃
  5. ( 4 ) the global bifurcations and chaotic dynamics are investigated when the rotor - ambs system has the time - varying stiffness

    ( 4 )研究了電軸承-轉系統在變剛度情況下的全局分叉和混沌力學。
  6. The performance of the controller affects the dynamic performance of the amb system and the circumgyration precision of the rotor, which is very important to the application of the amb

    軸承控制器的研究是其中至關重要的一環,控制器性能好壞影響到軸承的態性能和轉的回轉精度,直接關繫到軸承能否應用。
  7. A strong magnetic field can constrain electrons to move only along the field lines.

    場可約束電使之只能沿著場力線運
  8. Electromagnet fluid damping galvanometer

    液體阻尼振
  9. The synchronous hysteresis motor consists of a polyphase-wound stator and a magnetically hard rotor.

    同步遲滯電機由一個多相纏繞的定和一個硬所組成。
  10. Variable wiggler magnet

    可變扭
  11. Because that complex phenomena in pegs involve kinetic effects of plasma and cathode emitted electrons, and evolution of electromagnetic fields, particle - in - cell ( pic ) code is chosen as study tool, and a two and half dimensional cylindrical fully electromagnetic pic code cylinder2 - 1 / 2d, which is suitable for simulating the operation of the pegs, has been established

    考慮到peos物理現象涉及到等離體和陰極發射電力學行為以及空間電場的復雜變化,我們採用粒模擬方法作為研究工具,研製了適用於peos物理問題模擬研究的二維柱坐標全電模擬程序cylinder2 - 1 2d 。
  12. It is a new - style method of the drive control fed by static transducer in the control of the microcomputer, which makes the stator flux movement discrete. and position and speed outputs can be achieved on the motor axes

    它是在微機的控制下由靜止變頻器供電,使同步電機定勢離散運,在電機軸上得到位置和速度輸出的一種新型傳控制方式。
  13. Shorted rotor winding is a usual electric fault of synchronous machines. based on the analysis of fault mechanism especially the magnetic characteristics of tum - to - turn short circuit of rotor windings in turbo generator, the paper studies the diagnose method, which combines the traditional method with the intelligent method, to identify the fault and the severity

    繞組匝間短路是一種常見的發電機電氣故障,本文對其故障機理和勢進行了分析,將傳統的方法和智能化方法相結合,對轉繞組匝間短路的存在性和故障嚴重性進行了診斷。
  14. B ) equivalent circuit method and finite element analysis ( fea ) to compute the static force are presented, the results obtained by each method are compared one with the other. c ) the results of dynamic simulation by means of the software, ansoft show the hlfm " s characteristics when the motor works in the special frequency and single stroke and the conditions used for position control. d ) the measured static thrust - displacement characteristics and the dynamic characteristics during starting show good correlation with the calculated results

    在設計並製作了實驗樣機的基礎上所做的研究內容包括; ( 1 )分別用能量法和麥克斯韋張量法推導電力的計算公式,並討論他們的不同應用范圍; ( 2 )分別用等效路法和有限元法作直線力電機的靜特性分析,並比較分析它們的計算結果; ( 3 )用有限元模擬軟體做直線力電機態特性的模擬,分別分析直線力電機的頻率特性、開合閘特性和開環位置控制的工作特性; ( 4 )做直線力電機的靜推力?位移特性實驗和開合閘的態實驗,並將實驗結果與計算結果進行對比,實驗驗證了計算模型及計算方法的正確性。
  15. Single magnet galvanometer

    式振
  16. Common magnet galvanometer

    式振
  17. Moving - megnet galvanometer

    系振
  18. Standard specification for magnetic particle examination of continuous grain flow crankshaft forgings

    連續晶粒流曲軸鍛件的檢驗標準規范
  19. The controllers have considered all sorts of imperceptible factors affecting the servo performances in a lpmsm servo system, which include the parametric uncertainties brought by the changes of the mobile mass, frictional coefficient, the thrust fluctuations aroused by the varieties of the magnetic density distributions and the time harmonic. the h state feedback controller restrains disturbances and uncertainties to keep the robust and stable performance. the ip controller, which has the ability of rapid response, is applied to satisfy the rapid performance

    在分析雙環控制問題時,針對直線永同步電機,仔細考慮了能使伺服系統性能變壞的各種細微因素,如:永同步直線電機質量變化、摩擦系數變化等造成的模型參數不確定性,電機運行期間存在密分佈變化、時間諧波等產生的推力擾等,採用了ip速度控制器和h _狀態反饋控制器相結合構成直線伺服的內環控制器,並輔助設計了外環的pi位置控制器。
  20. Magnetic force pump magnet couplings " universal energy equation is educed by analyzing of demagnetization curve, ways of reverting force calculating are introduced according to the equation when inside magnet rotor have axial direction and radial displacement, circumferential moment of magnetic force has been given, magnetic force pump alnico ' s axial direction length, circumferential length, radial thickness amounts are summarized with the analyses of experiment results

    利用退曲線法,推導力泵聯軸器能量通用公式,導出內在軸向偏移和徑向偏置下產生的回復力計算方法,周向傳轉矩計算方法,結合試驗結果,總結推薦力泵鋼軸向長度、周向長度、徑向厚度、極數設計方法。
分享友人