磁處理法 的英文怎麼說

中文拼音 [cíchǔlǐfǎ]
磁處理法 英文
magnetic handling method
  • 磁 : 名詞1. [物理學] （磁性; 能吸引鐵、鎳等的性質） magnetism 2. （瓷） porcelain; china
  • 處 : 處名詞1 （地方） place 2 （方面; 某一點） part; point 3 （機關或機關里一個部門） department; offi...
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  1. Our approach differs from a recent theoretical paper that dealt with the possible conservation of the combined spin and orbital angular momentum in relation to the susceptibility of the down - conversion crystal

    我們的方法與新近一些理論文章提出的方法是不一樣的，他們處理自旋角動量和軌道角動量可能的守恆當中涉及到了下轉換晶體的磁化系數。
  2. The 3d electrons increased with the content of mn doping increasing, and the electrical property increased accordingly as the electron transport path improved. it is confirmed that all the orthorhombic perovskite phase which is formed initially at the heat treatment temperature of about 600c and thoroughly above 850c are observed in the lcmto thin film deposited on si ( 100 ) substrate by rf magneto - controlled sputtering

    確認了採用射頻磁控濺射法于si （ 100 ）基板上生長的薄膜至多在600熱處理已開始形成晶相，形成的晶相全部是正交晶系鈣欽礦相，提高熱處理溫度，薄膜中晶相含量相對增大，高於850后晶相基本形成完畢。
  3. Standard test method for dc magnetic properties of materials using ring and permeameter procedures with dc electronic hysteresigraphs

    使用d - c電磁滯曲線記錄儀的參數處理和環型材料的d - c磁性能的標準試驗方法
  4. We can see the result from actual data : this method are resultful in wiping off the noises of transient electromagnetic signal

    實際資料處理結果表明：該方法對去除瞬變電磁晚期信號的噪聲干擾有很好的效果。
  5. The numerical computing methods of the equations involving the static electric - magnetic field, electronic motion in the static electric - magnetic field, and so on are detailed. the methods of the boundary disposal are introduced. the phenomenon of secondary electron emission has also been studied

    介紹了數值計算方法，包括靜電磁場的數值計算、在靜電靜磁場中電子運動軌跡的數值計算、空間電荷密度的數值計算和空間電位分佈的數值計算;介紹了邊界處理方法。
  6. In the thesis, a signal processing scheme of polarization - insensitive fiber optic michelson interferometric magnetic sensor is described : making the interferometer work near the quadrature with closed loop controlling working point method, the fundamental frequency component of the magnetic field sensing signals can be detected to measure the input direct current ( dc ) magnetic field by phase sensitive demodulation

    本文主要介紹了偏振無關光纖michelson干涉型微弱磁場傳感器信號處理的方案:通過閉環控制工作點演算法使干涉儀工作在正交工作點處，再利用相敏檢波演算法提取傳感器輸出信號的基頻分量，以測量直流磁場的大小。
  7. The processing and graphical representation of aeroelectromagnetic data of over 30000 traverse kilometers demonstrate the effectiveness of the techniques, and the apparent resistivity images obtained reflect characteristics of shallow electric distrbution, thus providing new data for geological mapping

    通過對3萬多測線公里航空電磁數據的處理與圖示，證明了方法的有效性，取得的視電阻率圖像反映了各測區淺層電性分佈特徵，為地質填圖提供了新的數據。
  8. Based on an analysis of the major factors affecting the quality of data obtained in aeroelectromagnetic survey, this paper has put forward zero horizontal drift correction methods such as field value standardization and phase check and correction, studied and developed a suite of techniques suited to data - processing and graphical representation for aeroelectromagnetic method

    摘要在分析探討影響航空電磁測量數據質理主要因素的基礎上，提出了場值標定，相位校驗改正等零水平漂移改正方法，研究開發了一套適合航空電磁法數據處理與圖示的方法技術。
  9. The current radar scout system has some problems for processing multiform signals, confronting the complex electromagnetic environment and various radar characteristic signals. the adaptive front - end in receiver can solve these problems, and this dissertation analyzes it

    面對日趨復雜的電磁環境以及變化繁多的雷達特徵信號，現有的雷達偵察接收系統對多種信息的處理顯得力不從心，本文從接收機前端考慮，對其中的一種解決方法? ?自適應的接收機前端進行分析、研究。
  10. First, in virtual of identification of flaws is a typical of in - verse problems, proceeding from time - harmonic electromagnetic maxwell ' s equa - tion and helmholtz equation, the uniqueness and existence of direct scattering problems including the numerical algorithms of diverse of boundary conditions is given. second, the uniqueness and existence of inverse scattering problems and the theory of ill - posed integral equation are briefly looked back upon. finally, indicator function method for boundary identification is set up under all kinds of boundary conditions for inverse scattering of homogenous and inhomogenous objects, meanwhile, the proof of possibility for near - field measurements and nu - merical simulation are given

    由於缺陷的識別是一類典型的反問題，因而首先從時諧電磁maxwell方程和helmholz方程出發，具體地闡述了求解正散射問題的有關方法，包括各種（夾雜）邊界條件下的數值解法，就解的存在性唯一性給予了肯定的回答；隨后對逆散射問題的理論作了簡短的回顧，包括解的唯一性以及非線性不適定積分方程的處理等；然後對均勻介質和非均勻介質的逆散射問題建立了在各種邊界條件下的邊界識別的指示函數方法，鑒于近場數據獲得的重要性，對近場測試時邊界識別的方法給予了相應的證明，並且實現了數值模擬。
  11. A patch antenna with etched holes on the ground plane is also studied. the performance of the antenna at the resonant frequency is analyzed by using the fdtd method together with the pml boundary treatment. the results show that the surface waves are suppressed greatly, the bandwidth is improved and a 1 odb reduction on the sidelobe level is achieved at the 110 and 260 directions in the e plane

    全面地研究了地面腐蝕周期圓孔結構的電磁晶體貼片天線在基波頻率處的性能，用fdtd方法並結合pml邊界處理技術對該天線所取得的研究結果顯示，本文設計的地面腐蝕型電磁晶體結構抑制了貼片天線中的表面波，增加了天線的帶寬，並有效地削弱了旁瓣，使天線的e面方向圖上110和260方向的兩個旁瓣被削弱了10db 。
  12. Through analysising the characteristics of the power system with floating neutral point deeply, the paper puts forward a new plan of single - phase to ground fault line selection on the base of s ' s signal injecton method and gives the hardware and software design. in this design, the high speed sampling and data processing is carried out through using dsp processor ; the large electrice current is drived through the application of a high - performance audio power amplifier and transformer ; the communication between host computer and detectors is realized through rs485 bus technology ; the difference multilevel frequency - selected amplifier is designed and the feeble signal of space is sampled on the base of the theory of magnetic induction ; the interface between dsp and exterior chip and rs485 interface logical is designed through using fpga ; the using of lcd module and keyboard interfacing chip makes the interface between human and machine ; the programme of host computer and detectors is designed through using blocking design method

    在本設計中，採用高速的dsp處理器，實現了對故障特徵信息的高速採集與處理;採用大功率的功放晶元與變壓器配合的方法，實現了大電流信號的驅動輸出;採用485總線技術，組建了裝置主機與多探測器之間的主從式通訊網路，實現了多干擾條件下裝置主機與多探測器的可靠通訊;設計了差分式多級選頻放大電路，採用磁感應的方法實現了對空間微弱信號的接收;利用fpga技術，實現了控制器與多外設的介面及數字信號的串並轉換;採用了先進的lcd液晶顯示模塊及鍵盤介面晶元，設計了人機信息交互的介面;採用了模塊化的軟體設計方法，開發了裝置主機及探測器的軟體程序。
  13. The properties of low carbon steel can be greatly enhanced when its grain size becomes ultrafine. approaches to obtain ultrafine grain size for low carbon steel, such as microalloying, electromagnetic field treatment and thermo - mechanical treatment after rolling, are given in this paper. in addition, the mechanism and technologies of ultrafine granulation are also discussed

    低碳鋼的性能可通過晶粒超細化得到改善，討論了低碳鋼生產過程中利用微合金化、電磁場處理和軋后加工處理等方法進行的晶粒超細化，討論了晶粒超細化的作用機理和生產工藝。
  14. The devices for detecting phase - to - ground fault in ineffectively grounded systems are seldom functionary at present. based on thousands of experiments in high - voltage laboratory in north china electric power university, the reasons for misjudgment and the effective measures to avoid it are presented in this paper : to change pt connection form to prevent from ill - effects of ferro - resonant overvoltage ; to increase soft measures to resist against interference ; to adopt neural network method to obtain the virtual value of the detect way

    依據上千次實驗，我們找到了一些導致選線誤判的影響因素，並提出幾點防止誤判的措施，包括改變pt接線方式，避免鐵磁諧振對選線的影響；通過對故障檢測方式的處理和使用連續判斷技術增強裝置的軟體抗干擾能力；嘗試採用神經網路演算法設定選線方法的有效域等。
  15. The achievement of the thesis can be described as follow : 1. principle and algorithm of previous magnetic data processing methods have been presented in detail and every algorithm has been programmed

    本文主要取得了如下的成果： 1對空間域和波數域的磁異常處理方法進行了研究並編程實現。
  16. The topic of this paper originates from the national nature science fund " fdtd analysis and design of microwave active integrated circuits ". an analysis of microwave active circuits using fdtd method with the emphasis on the several methods with which to simulate the active devices in the microwave circuits is studied in details in this paper. and some practical electromagnetic problems are analyzed with these methods

    本論文題目來源於自然科學基金「微波有源集成電路的fdtd模擬與設計」 ，研究了時域有限差分法對微波有源電路的分析，主要研究了微波電路中各種微波器件進行fdtd模擬時的幾種處理方法，並採用這幾種方法分析了幾個實際的電磁問題。
  17. Methods water sample was treated by electromagnetic fields, and the turbidity value and fluoride in water sample before and after treatment were detected

    方法利用復合電磁場對實驗室模擬水樣和現場水樣進行處理，檢測處理前後水中的渾濁度、氟化物濃度，並計算去除率。
  18. Using the method of compare experiment, the samples of liquid al alloy with and without treatment by electromagnetic pump were studied respectively

    摘要通過對比實驗的方法，研究了不經過和經過電磁泵處理的鋁合金液澆注流動性試樣。
  19. Many new methods, such as reduction of gravity data to a horizontal plane, wavelet analysis, higher order statistics, joint inversion and interactive inversion of gravity, magnetic, electric and seismic data, 3 - d visualized inversion, as well as bp artificial network method have been widely used in the integrated data processing

    山區重力資料曲化平，小波分析及高階統計量等現代信號處理方法，重震、重磁、電震的聯合反演與交互反演，三維可視化反演， bp人工神經網路方法等在綜合地球物理處理解釋中得到廣泛應用。
  20. From survey through data processing to interpretation of achievements, it probes step by step into the working method, technological features, anomaly regularity and means for inference and interpretation of magnetic archaeology

    從野外測量、資料處理到成果解釋循序漸進地探索了磁法考古的工作方法、技術特點、異常規律和推斷解釋方法等。
分享友人
分享到 Line

分享到臉書