磁軟的 的英文怎麼說

中文拼音 [ruǎnde]
磁軟的 英文
magnetically soft
  • : 名詞1. [物理學] (磁性; 能吸引鐵、鎳等的性質) magnetism 2. (瓷) porcelain; china
  • : Ⅰ形容詞1 (質地不硬) soft; flexible; supple; pliable 2 (柔和) soft; mild; gentle 3 (軟弱) we...
  • : 4次方是 The fourth power of 2 is direction
  1. The direction of the easy axis of the soft layer has little influence on the magnetic hysteresis and magnetostriction of the ecmm when the magnetic anisotropy of the magnetostrictive layer is much larger than that of the soft layer

    雖然各向異性角對多層膜學及力學性質幾乎沒有影響,但各向異性常數卻會顯著影響多層膜性質。
  2. The softening of magnon of two - dimensional insulating ferromagnets at low temperatures

    低溫下二維絕緣鐵振子
  3. Floppy disks : flat, circular piece of magnetically treated mylar plastic that rotates within a jacket

    盤:包裝在一個塑料裏面,平坦,圓形具有存儲裝備
  4. A small piece that is placed over the write protect notch on a diskette to prevent the recording of data so that prerecorded data will not is erased

    粘貼在盤寫保護槽上薄片,用於阻止對寫入,以保護盤上原有數據不被抹去。
  5. Soft-sectoring refers to the fact that the division of the disk or track into sectors is performed by software.

    分段是指用體來把盤或軌劃分成情況。
  6. The regularities distribution of the electromagnetic field and vortex density had been simulated by the software matlab, the results of simulation not only proved the existence skin effect but also provided theory evidence for designing and researching of the shaft bearing replacer

    通過matlab體對被加熱工件進行了電場和渦流分佈計算機模擬,形象描述了工件內電分佈規律,證明了集膚效應存在,為軸承感應拆卸裝置設計研究提供了理論依據。
  7. Linear induction motor is an important kind of machines which have some merits such as simple structure, low cost, durability, convenience for maintenance etc. the subject of this thesis is to study a big circular ring linear induction motor, and the major works in this thesis are summarized as follows : ( 1 ) considering the effects of the finite length of primary core, one - dimension analytical solution for the air gap field is cited in this paper. based on it, the single layer winding magnetic field is studied. considering whole - pitched and short - pitched winding configuration with odd poles and half - fulled slots in both ends, the double - layer winding magnetic field is analyzed, respectively

    本文對大圓環直線感應電機進行了深入細致研究,內容包括: ( 1 )本文採用有限長行波面電流作用於有限長鐵芯上模型,引用了氣隙場一維解,研究了單層繞組場,奇數極半填槽雙層繞組在採用整距和短距時分析、比較,簡單介紹了二維解; ( 2 )用有限元體ansoft對大圓環直線感應電機空載氣隙場進行了靜態分析,並分析了結果; ( 3 )用體進行了額定電壓下瞬態分析,得到了轉矩,位移,轉速隨時間變化曲線圖,利用單極性霍爾元件測定轉速並與體計算結果進行了比較,採用等效電路法計算了堵轉時最大電力並做實驗進行了驗證,由實驗測得了三相電流波形,並與計算結果進行了比較,對其不對稱性進行了定性分析。
  8. The distribution of magnetic induction in rectangular soft - contact mold during electromagnetic continuous casting ( emcc ) was investigated considering the electric frequency

    摘要研究了在電接觸連鑄過程中,電源輸入頻率變化對矩形電接觸結晶器內感應強度分佈規律和彎月面變化情況影響。
  9. It can match multi - channels transient electromagnetic apparatus if this method comes true, further, connect data collection technology with imaging software system. in conclusion, it will immit new energy for exploration means of transient electromagnetic method, moreover its production will in practically have great significance to tem applying and generalizing

    如果實現瞬變電多孔徑技術,即可配合多通道瞬變電法儀器,將多道數據採集技術和成像體系統結合,將對瞬變電法這一勘探手段實際應用注入新活力,所研究成果將對瞬變電應用和推廣具有很大實際意義。
  10. Design considerations of the high power s - band rka are described, by using electron beams of voltage - 600kv, current - 5000a, and the numerical simulations for three kinds of the rka output structures are given. the three kinds of the output strctures are single - gap standing - wave ( sw ) cavity, traveling - wave ( tw ) output structure, and two output structures ( single - gap + traveling - wave structure ). under conditions of using two output structures, the results show that the instantaneous peak power obtained from sw output cavity and tw output structure is respectively 2. 4gw and 2. 1gw, the both power average of 0. 96gw and 0. 93gw, i. e. the s - band rka of two output structures generates peak output power of 1. 89gw at a frequency of 2. 85ghz

    從數值模擬中得到雙輸出結構微波功率輸出結果為:駐波輸出瞬時功率為2 . 4gw (周期平均為0 . 96gw ) ;行波輸出結構輸出瞬時功率為2 . 1gw (周期平均0 . 93gw ) ,就獲得了頻率為2 . 85ghz微波輸出。本文簡要描述了電體( magic )對速調管輸出腔體進行了模擬,並對相應模擬方法進行了評述。
  11. Track format for 200 mm flexible disk cartridges

    200mm盒式軌格式
  12. Track format for 90 mm flexible disk cartridges - 7958 ftprad

    90mm盒式軌格式. 7958 ftprad
  13. Track format of 130 mm flexible disk cartridges - 7958 ftprad

    130mm盒式軌格式. 7958 ftprad
  14. Track format for 90 mm flexible disk cartridges - 15 916 ftprad

    90mm盒式軌格式. 15916 ftprad
  15. Track format for 90 mm flexible disk cartridges - 13 262 ftprad

    90mm盒式軌格式. 13262 ftprad
  16. B ) equivalent circuit method and finite element analysis ( fea ) to compute the static force are presented, the results obtained by each method are compared one with the other. c ) the results of dynamic simulation by means of the software, ansoft show the hlfm " s characteristics when the motor works in the special frequency and single stroke and the conditions used for position control. d ) the measured static thrust - displacement characteristics and the dynamic characteristics during starting show good correlation with the calculated results

    在設計並製作了實驗樣機基礎上所做研究內容包括; ( 1 )分別用能量法和麥克斯韋張量法推導電計算公式,並討論他們不同應用范圍; ( 2 )分別用等效路法和有限元法作直線力電機靜特性分析,並比較分析它們計算結果; ( 3 )用有限元模擬體做直線力電機動態特性模擬,分別分析直線力電機頻率特性、動子開合閘特性和開環位置控制工作特性; ( 4 )做直線力電機靜推力?位移特性實驗和動子開合閘動態實驗,並將實驗結果與計算結果進行對比,實驗驗證了計算模型及計算方法正確性。
  17. Based on the analytic analysis of the linear synchronous motor ’ s layered model, the paper deducted the composing of air gap magnetic fields and the analytic expression of levitating and advancing force. these results provide theoretic guidance not only for the analysis and measurement of the vehicle ’ s air - gap magnetic fields but also for the eatablishment of the

    採用各向異性介質近似模擬齒槽區域,並引入定子和轉子等效電流層概念,建立了直線同步電機場分層模型,在此基礎上得到了氣隙組成以及懸浮力和推力解析表達式,為氣隙分析和測量以及列車運動情況下電測量模型建立提供了理論指導。
  18. The research result shows that the motor ' s torque will improved in lower voltage, when tooth width are not equal, and magnet conductivity of material is high

    研究結果表明,當專用電機採用不等齒寬結構,或採用高材料時,均有利於提高電機在低電壓下輸出轉矩。
  19. Based on the analysis about the test requirements and the saturated magnetization of the armor plate, the excitation magnetic circuit satisfying the testing condition and a validation system are designed. because the geometric, of the magnetic leakage at the direction of the normal of the roundness fault has the feature of two peaks : a positive and a negative, using the linear regression and the software matlab, two regression equation are proposed : one is about the peak value of the magnetic leakage and the diameter and depth of the roundness fault ; the other is the distance between the two peaks and the diameter of the roundness fault. the result of the validation system proves that the two equations are valid, and an applied method using for quantificationally inspecting the roundness faults is proposed according to the two equations

    根據實驗要求,通過對鋼板達到飽和必要性進行分析,設計了符合試驗條件路,並設計了一套實驗驗證系統;根據圓形缺陷法線分量漏場幾何圖形正負雙峰值特點,採用線性回歸擬合原理和matlab體及其統計工具箱中相關函數,給出了圓形缺陷漏場幾何圖形峰峰值與圓形缺陷直徑和深度以及峰峰值間距與圓形缺陷直徑兩個回歸擬合方程,並通過實驗驗證系統驗證了擬合方程正確性,利用這兩個簡單實用擬合方程,提出了一種工程定量檢測圓形缺陷應用方案。
  20. ( 2 ) analysis magnet field is realized by maxwell 2d on finite - element of electromagnetic field analysis. inductance of coil as well as electromagnetic force was calculated by means of it

    ( 2 )利用ansoft體中maxwell2d場有限元分析體進行電機場分析、靜態電模擬計算以及電機線圈自感計算。
分享友人