磨損部件 的英文怎麼說

中文拼音 [sǔnjiàn]
磨損部件 英文
wear parts
  • : 磨動詞1 (摩擦) rub; wear 2 (研磨) grind; mull; polish 3 (折磨) grind down; wear down [out]:...
  • : Ⅰ動詞1 (減少) decrease; lose 2 (損害) harm; damage 3 [方言] (用尖刻的話挖苦人) speak sarcas...
  • : Ⅰ名詞1 (部分; 部位) part; section; division; region 2 (部門; 機關或組織單位的名稱) unit; mini...
  • : Ⅰ量詞(用於個體事物) piece; article; item Ⅱ名詞1. (指可以一一計算的事物) 2. (文件) letter; correspondence; paper; document
  • 磨損 : wear and tear; abrasive wear; abrase; abrade; detrition; wear; scuff; wear out; fray; battering; ...
  • 部件 : component; unit; parts; assembly; subsystem; secundina (pl. secundinae)
  1. Adopt high quality alloy, stainless steel, ti, cr and other metal for driving parts, the wear - resistance, costive - resistance, thermo - resistance and pressure - resistance is highly increased. the service life is long

    主要傳動均採用優質合金材料、不銹鋼材料、鈦材、鉻和其他表面合金製作,大大提高了耐、耐腐蝕、耐高溫及耐壓能力,使該機具有較長的使用壽命。
  2. Abstract : this paper describes reliability trial methods for hydraulic pumps that meet different requirements. the methodology is concerned with part fatigue, part wear, whole element wear and whole element sequential sampling life length

    文摘:描述了適合不同要求下的液壓泵可靠性試驗方法,包括疲勞、、整機序貫壽命和整機四種可靠性試驗方法。
  3. Aim of this study was to meet the need for development of tribological parts in pumps. at room temperature tribological properties of different sliding pairs of silicon carbide and alumina - based ceramics were tested using a laboratory tribometer in the ring - on - plate geometry under reciprocating sliding linear contact in different media, such as distilled water, aggressive media and air

    本文針對目前泵用摩擦零材料發展的需要,在實驗室摩擦試驗機上研究了按環/塊線接觸方式作往復運動條下的碳化硅和氧化鋁基陶瓷材料摩擦副在水、化學腐蝕性介質作潤滑劑和無潤滑時室溫下的摩擦特性。
  4. 7. no parts and components or complete power unit warranty will be delivered if gear shaft seize, cylinder scraping or moving friction pad are seriously worn out, resulting in damaging relevant parts or complete power unit, due to lack of oil insufficient engine oil or failure of engine oil or improper use of engine oil following engine instruction

    因缺油機油量不足機油失效或未按發動機使用說明書規定牌號使用機油,導致咬軸抱軸拉缸或各運動摩擦付嚴重,而壞相關零或導致整機毀壞的,相關零或整機不給予保修。
  5. Some of the parts are scrapped because of worn tooling, bad equipment, or human error.

    由於工具,設備壞或人為錯誤而報廢了一分零
  6. Protective clothing for professional motorcycle riders - jackets, trousers and one - piece or divided suits - part 2 : test method for determination of impact abrasion resistance

    專業摩托車駕駛員用防護服.夾克長褲連體服或雙服.第2分:耐沖擊性測定的試驗方法
  7. Implants for surgery - wear of total knee - joint prostheses - loading and displacement parameters for wear - testing machines with displacement control and corresponding environmental conditions for test

    外科植入物.全膝關節假肢的.帶位移控制和相關試驗環境條試驗機械的負載和位移參數
  8. Implants for surgery - wear of total knee - joint prostheses - part 1 : loading and displacement parameters for wear - testing machines with load control and corresponding environmental conditions for test

    外科植入物.全膝關節假體的.第1分:試驗用有負荷控制和相應環境條試驗機的負荷和位移參數
  9. Study on wear of hydraulic turbine transition parts

    水輪機過流問題
  10. When two metal parts move over each other, they will wear away rapidly.

    當二個金屬互在其上運動時它們將迅速地
  11. Reduced maintenance is assured because the disc is the only moving part and is designed to minimize flutter in the closed position, thus reducing wear on the pivot pin, disc, and seat

    確保節省維護費用,因為閥瓣是唯一的一活動,這種結構將關閉位置的振動減小到最小程度,因此減少了樞軸銷、閥瓣和閥座的程度。
  12. Because ferrous spectrum technology can be used to accurately locate the worn parts, worn form, worn degree of automobile, the working condition of automobile can be foreseen so that faults could be avoided in advance

    利用鐵譜分析技術可以準確地得到轎車系統元位、形式、程度,甚至元完全失效的結論,從而提前預測轎車的工作狀況,提前預防故障的發生。
  13. Implants for surgery - wear of total hip joint prostheses - loading and displacement parameters for wear - testing machines and corresponding environmental conditions for test

    外科植入物.全髖關節假肢的.的負荷和位移參數.試驗機和相應環境條
  14. Implants for surgery - wear of total hip - joint prostheses - part 1 : loading and displacement parameters for wear - testing machines and corresponding environmental conditions for test

    外科植入物.全髖關節假體的.第1分:試驗用試驗機和相應環境條的負荷和位移參數
  15. Implants for surgery - wear of total knee joint prostheses - loading and displacement parameters for wear - testing machines with load control and corresponding environmental conditions for test

    外科植入物.全膝關節假肢的.試驗機的負荷和位移參數.帶有負荷控制和相應控制條的試驗機
  16. Responsible for purchasing all spare and wears parts and services in his / hers responsibility area ensuring quality, pricing and reliability

    負責所有采購的零、易以及服務,確保其質量、價格和可靠性。
  17. The small size of every component can make the user to change the destroyed position in part

    由於單尺寸小,用戶可對局分進行更換。
  18. Remove spring cage, spring and washer. remove bottom plug. grasp upper and lower stem lock nut with wrench and loosen. clean or replace any damaged or worn parts

    拆卸彈簧籠,彈簧和墊圈。拆卸底塞。用扳手抓住上和下閥桿鎖緊螺母並且松開。清洗或更換任何壞或磨損部件
  19. In this paper, ptfe and ptfe composited with sicp, sicw, mos2p and sicp + mos2p with various ratios respectively have been obtained by compression molding. under the condition of dry friction, a systematic study has been done on the weight loss and the friction coefficient of composites and the relations between the properties and content of the filling, the load and the sliding velocity

    在干摩擦滑動下,對ptfe材料及其復合材料的失重、摩擦系數及機理進行了研究,同時對其與(載荷、滑動速度)和材料的內因素(填料的含量、粒徑、種類)的關系進行了較為系統的研究。
  20. Testing of lubricants - determination of wear elements - part 2 : analysis by wavelength dispersive x - ray spectrometry

    潤滑劑的試驗.的測定.第2分:波長彌散x射線
分享友人