磨耗減量 的英文怎麼說
中文拼音 [móhàojiǎnliáng]
磨耗減量
英文
abrasion loss-
In the course of working, ， the plow will make use of the shuttling method so that it can dig alternately either on the left or on the right. compared to the unilateral plow, it can improve the productivity because it can help leave off the soil 、 take from the consumed energy and reduce the empty journey. to meet the requests above, we will use a remote cylinder with both a small cubage and double functions, approximately designing the plow to be columniform and symmetric. after the experiment for a period in the field, we found that the most frayed areas had happened at the places of both plow shank and share and at the same time the base of the remote cylinder had ruptured suddenly
與單向犁相比，其優點在於：耕地無開、閉壟，地表平整，降低了耕后整地的能量消耗，減少了地頭的空行程，因而大大提高班次生產率。為了滿足犁體梭式作業的要求，我們採用了一隻小容積雙作用的液壓油缸；同時對犁壁曲面的形狀採用了近似圓柱形的對稱設計。但經過一段時間的田間試驗，我們發現：該犁犁胸部分的犁脛和犁鏵上的犁尖在工作中磨損較為嚴重；主犁梁和油缸缸體的連接部分（即油缸底座）突然發生了斷裂，造成整個犁體無法正常工作。An iron - containing material with an iron grade of over 20 % can be recovered from magnetic separation tailings of liuling iron mine by gravity method. this material can be used instead of partial clayey material to produce portland cement so as to reduce the mine tailings discharge amount to 43. 52 %, to raise the iron recovery from 70. 89 % to 84. 62 % and to reduce the iron ore powder consumption in raw cement mixture and the energy consumption of raw material grinding
用重選法從劉嶺鐵礦磁選尾礦中回收鐵礦物，可獲得鐵品位大於20 %的含鐵物料，用此物料代替部分粘土質原料生產硅酸鹽水泥，使礦山尾礦排放量減少至43 . 52 % ，鐵的回收率由70 . 89 %提高到84 . 62 % ，並且減少了水泥生料配料中鐵礦粉的用量，降低了生料粉磨能耗。Model xjq has following features ： （ 1 ） dummy bottom is adopted, making the recycling capacity of the recycling cylinder is 2. 5times of the tand. ( 2 ) the stator is a cylinder in structure with its inner wall being vertically ribbed, and slots are placed, leading to better cutting lffect to the slurry. ( 3 ) due to low immerging depth of the rotator, low rurning speed of the impeller, and wide space between the impeller and stator, wearing is low and power consumption greatly reduced. ( 4 ) it is spontaneously aerated
Xjq型浮選機為仿維姆科型，該機主要有以下幾個特點： （ 1 ）採用了假底，循環簡可使循環量達到槽容積的2 . 5倍; （ 2 ）定子結構為圓筒型，內壁設有立筋條和長孔，對礦漿的前切作用好; （ 3 ）轉子浸沒深度淺，葉輪轉速低，葉輪和定子間隙大，所以其磨損輕，動力消耗大大減少; （ 4 ）可自吸空氣。Using vogel ' s wear index as the rail side wear index, the paper analyzes the side wear variations of rail head when the parameters in the wheel / rail system vary, analyzes the influences of track irregularity on rail uneven wear on gauge corner emphatically. this paper analyzes the rail side wear dates measured by track division of shan hai guan since 1990, then gains the relationship between side wear and traffic volume and sums up the characteristics and regularities in the formation and development of side wear. in the end, some measures for regarding the side wear on curves are put forward
從輪軌摩擦、輪軌接觸幾何關系、輪軌接觸應力和輪軌蠕滑等方面對鋼軌側面磨耗機理進行了探討，從軌道幾何參數、機車車輛運營條件等方面對鋼軌側面磨耗的影響因素進行了重點分析和總結；應用輪軌系統動力學，建立了輪軌空間耦合振動時變模型，採用vogel側磨指數作為鋼軌側磨指標，系統分析了輪軌參數變化的情況下，軌頭側面磨耗的變化規律，重點分析了軌道不平順對鋼軌不均勻側磨的影響；對山海關工務段1990年以後現場測得的曲線鋼軌側磨數據進行了分析，通過擬合得到了鋼軌側磨量與運量的關系曲線，並總結了曲線上股鋼軌側面磨耗的特徵和發生、發展規律；最後提出了一些減緩曲線鋼軌側面磨耗的措施。Abstract : an iron - containing material with an iron grade of over 20 % can be recovered from magnetic separation tailings of liuling iron mine by gravity method. this material can be used instead of partial clayey material to produce portland cement so as to reduce the mine tailings discharge amount to 43. 52 %, to raise the iron recovery from 70. 89 % to 84. 62 % and to reduce the iron ore powder consumption in raw cement mixture and the energy consumption of raw material grinding
文摘:用重選法從劉嶺鐵礦磁選尾礦中回收鐵礦物，可獲得鐵品位大於20 %的含鐵物料，用此物料代替部分粘土質原料生產硅酸鹽水泥，使礦山尾礦排放量減少至43 . 52 % ，鐵的回收率由70 . 89 %提高到84 . 62 % ，並且減少了水泥生料配料中鐵礦粉的用量，降低了生料粉磨能耗。With analyzed the relation between the particles number in the oil and the contamination of t he oil, the relation between oil contamination and the weakening of transmitted light intensity, the oil contamination is monitored based on the particles scattered the light. the minimum peak value of the oil at low - loss transmission area of quartz optical fiber can be selected to monitor the oil contamination
在對油液中磨損顆粒的含量與油液污染度的關系以及油液污染度與通過油液的光通量的減弱進行分析的基礎上，利用油液中懸浮顆粒對光線的散射的特性，對油液的污染度進行監測，選擇光線在石英光纖低損耗傳輸區域和油液對光線最小吸收峰進行測量。Based on the data of curve track abrasion measured in beijing metro, the types of track abrasion of metro are analyzed, and the main reasons of track abrasion, and the basic methods to reduce the track abrasion and their application in beijing metro are presented
摘要準確簡要地描述北京地鐵彎道線路上鋼軌側磨的病害情況，根據現場測量數據統計側磨的類型、分析磨耗的主要原因、提出減緩磨耗的措施，並介紹現場的實際應用效果。The implementation of the systam should not increase the driver ' s operation items, not change driver ' s origina1 operation habit and the vehicle ' s previous moving 1ap at the sajne time cooperate with the engine reasonab1y. according to the real circumstances the automatic contro1 system conands the change and intensity of energy drawing back and re1easing at the right monent. the procedure of contro1 takes the cirivers intention as topic, the real parajneters as basis, in order to raise motive force, reduce oi1 consmption
系統實現不增加駕駛人員的操作項目，不改變原來的操作習慣以及原車輛的運動規律，並根據實際情況適時控制能量回收與釋放的轉換，適度控制能量回收與釋放的強度，控制過程以駕駛人員操作意圖為前題，以實際運行參數為依據，以提高動力性，降低油耗、排放，減少磨損為目標。The measure of wearing out, consumption or other reduction in the useful life of a fixed asset whether arising from use, effluxion of time or obsolescence through technology and market changes is called depreciation
對固定資產在使用期限內磨損、消耗和其他原因減少的一種估量稱為折舊，這些價值的減少是由於使用中的磨損、時間的推移或技術的進步及市價的變動引起的價值損失。分享友人