稀漿結度 的英文怎麼說

中文拼音 [jiāngjiē]
稀漿結度 英文
thin flowing consistency
  • : Ⅰ形容詞1 (事物出現得少) rare; scarce; uncommon 2 (事物之間距離遠; 空隙大) sparse; scattered 3...
  • 漿 : 漿同「糨」
  • : 結動詞(長出果實或種子) bear (fruit); form (seed)
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  1. Through researching the rhythmic change regularity of ore texture and structure, mineral composition and content, rare element " s change feature and the exploding temperature of mineral inclusion, combining the theory of magmatic ore - forming, the forming process of panzhihua vanadic titano - magnetite deposit could be divided into four periods : rock - forming period, main ore - forming period, hydrothermal period and surficial processing period

    通過對礦石組構、礦物成分及含量、土元素變化特徵、礦物包裹體爆裂溫的韻律式變化規律的研究,合巖漿成礦理論,將攀枝花釩鈦磁鐵礦礦床的形成過程劃分為四個期:成巖期、主成礦期、熱液期、表生期。
  2. Alkali basite, which came from upper mantle or lower crust, invaded through those structure, which not only bring cu et al mineralizing elements, but also the most important is that thermal energy. it cycled the formation water ( yinmin fonnation and luoxue formation ), and form alkali - rich, middle - high temperature and salinity fluid mixed with alkali - rich magmatic water. there were high rate of percolation and well voidage in the contact zone between yinmin purple stratum and yinmin rubblerocks, which is in favor of the transposition and mineralization of minerogenetic fluids

    因此,總東川礦山式銅礦成礦模式為沉積( fe 、 cu ) ?熱液疊加( cu )改造:晉寧-澄江期,小江深大斷裂發生走滑運動,在東川礦區造成右行旋扭及其派生構造,形成「 z 」字形落因破碎帶,同時來自深源(下地殼或上地幔)堿基性巖漿侵入,不僅帶來了大量cu等成礦物質,更重要的是提供了熱源,促使地層水(落雪組白雲巖和因民組紫色層)循環,與富堿( na和k )巖漿水混合,形成富堿中高溫高鹽流體。
  3. A lot of indoor and in - suti test to the properties of the chemical grouting material, especially the properties requested by actual engineering has proceeded. active - diluent of furfural - acetone, low poison hardener. surfactant and a series of formula have been selected by experiment. cw series material has low glue degree, time last of it harden can be adjust, surface tension and contact angle of the material is low

    漿材性能特別是工程實際對漿材要求的性能進行了大量室內、現場試驗測試,選擇性能優良的糠醛?丙酮活性釋劑、低毒憎水性固化劑、表面活性劑及系列漿材配比, cw系漿液粘、固化時間大范圍可調、表面張力及接觸角小、漿材固化及固高,具有優良的浸潤性能和工藝性能。
分享友人