空心板梁 的英文怎麼說

中文拼音 [kōngxīnbǎnliáng]
空心板梁 英文
hollow slab beam
  • : 空Ⅰ形容詞(不包含什麼; 裏面沒有東西或沒有內容; 不切實際的) empty; hollow; void Ⅱ名詞1 (天空) s...
  • : Ⅰ名詞1 (片狀硬物體) board; plank; plate 2 (專指店鋪的門板) shutter 3 [音樂] (打拍子的樂器) ...
  • : 名詞1 (屋架中架在柱子上的長木) beam 2 (通常也指檁) purlin 3 (橋) bridge4 (物體中間條狀隆起...
  • 空心 : 空心on an empty stomach
  1. Hollow concrete plats construction with post - tension pre - stress method

    后張法預應力空心板梁施工
  2. The method is as follows : calculating the length, angles and coordinates of pre - cast hollow slab in cartesian coordinate system, and then adjusting the width of hollow slab beams and length of cantilever boards to make the linear cantilever slabs close to the transition of mute

    具體方法是:採用直角坐標系計算預制斜長、首尾夾角和起終點坐標,根據計算結果與路線線形之差,多次調整空心板梁寬度和懸臂長度,使外懸臂折線滿足路線的緩和曲線線形。
  3. From above analysis, it is proved that, because the internal force distribution of cast - in - situ concrete hollow floor is notably different to that of waffle slabs, designed as grillage beams and reinforced by these results, the technical advantage of this structure may not be exerted sufficiently so that leading to the increase of reinforcement

    通過以上分析證實,由於現澆樓蓋的與肋樓蓋具有顯著不同的內力分佈規律,現澆格進行計算並配筋,將不能充分發揮該結構的技術優勢,導致配筋量的增加。
  4. Tests on mould pressure for void concrete plate

    空心板梁砼模壓力試驗
  5. Static loading tests of a 20m hollow slab beam

    空心板梁靜載試驗研究
  6. Construction technique for cast - in - situ continuous hollow - slab beam

    現澆連續空心板梁施工技術
  7. Abstract : combined with the design of two prestressed hollow cement plate - bridge on west circle expressway of hainan province, the generall thought of design and structure disposal for straight girder bridge is explained

    文摘:結合海南省環島西線高速公路上兩座預應力混凝土橋設計,介紹了在曲線上採用直橋的總體設計構思和結構處理方法。
  8. The weight of this floor is small and the span of this floor is large. compared with the flat - slab floor, the flat - plate floor and the waffle floor, the cast - in - place reinforced concrete hollow flat - plate floor adapts the demands for the flat - plate floor system of this age. it has been used in some projects and has gained great social effects and economical profits

    現澆鋼筋混凝土樓蓋是一種新型的無樓蓋體系,它自重輕,跨度大,是繼帶柱帽的無樓蓋、平樓蓋、密肋無樓蓋之後,順應了時代對無樓蓋體系要求的新型無樓蓋體系,目前已經在一些工程項目上投入使用,取得了良好的經濟效益和社會效益。
  9. Quality supervision on prestressed hollow girder construction with post - tensioning method

    后張法預應力空心板梁的施工質量監理
  10. Finite tension element analysis of post tensioning prestressed concrete hollow slab

    后張法預應力混凝土空心板梁張拉有限元分析
  11. Supervision of construction quality of prestressed hollow slab beam by post - tensioning method

    后張法預應力空心板梁的施工質量監理
  12. Introduction on putting prestressing in prestressed concrete hollow slab beam of qutan bridge

    曲潭大橋預應力砼空心板梁施加預應力簡介
  13. Hollow slab beam

    空心板梁
  14. Construction technology of pre - stressing concrete hollow plate beam precasted by monolithic tension method

    整體張拉法預制預應力混凝土空心板梁
  15. Compared with the normal flat - plate floor, the cast - in - place reinforced concrete hollow flat - plate floor has two special characteristics. to produce the hollow floor, the hollow columns are pre - buried in the floor. there are concealed wide - flat beams between the frame columns

    和普通平樓蓋相比,現澆鋼筋混凝土樓蓋有兩個突出的不同點,一是在樓內預埋圓筒形成,二是在框架柱之間設有暗扁
  16. Based on the design case of shuangjianghe bridge on the segment from tongdao to jili in g209 national high - way which was being built, the linear cantilever slabs was made to fit transition curve of the route

    摘要以國道g209通道至吉利段改造工程中的雙江河大橋設計實例,研究位於小半徑緩和曲線上預制空心板梁的外懸臂折線逐步逼近緩和曲線線形,與橋上路線線形一致。
  17. By using the calculating method of the flat - plate floor, the bend moments of the slab in different place are calculated. the moment distribution ratio between the column trip and the middle trip of the cast - in - place reinforced concrete hollow flat - plate floor calculated by the equivalent frame method is demonstrated. the moment of the cast - in - place reinforced concrete hollow flat - plate floor calculated by the experience coefficient method is also demonstrated

    進而將無樓蓋體系的計算方法應用於現澆樓蓋中,通過對格彎矩的分析,得出了現澆樓蓋按等效框架法計算的帶彎矩分配比例系數,按經驗系數法計算的帶彎矩設計值。
  18. The two ways stiffness ratio of the reinforced concrete hollow slab is studied and the results show the reinforced concrete hollow slab is bent in two ways under the vertical loads providing the length of the two rims of the slab are near. the analysis for the concealed wide - flat beams demonstrates that it belongs to the column strip and it does not possess the function of the frame girder

    本文首先從理論上分析了兩方向剛度比,認為兩邊長接近的在豎向荷載作用下為雙向受彎,其受力性能為雙向;分析了柱上暗扁在樓蓋中的作用,認為它不能起到框架的作用,應為柱上帶的一部分。
  19. On the basis of the theoretical analysis and the finite element calculating, the conclusions show that the cast - in - place reinforced concrete hollow flat - plate floor should adopt the calculating method of the flat - plate floor

    通過理論分析和有限元計算,本文認為現澆鋼筋混凝土樓蓋應按無樓蓋體系的設計方法進行結構計算。
  20. The structure analysis studies and design - essentials of the continuous hollow slab beam erected as simple - supported beam in advance

    先簡支后連續預應力空心板梁受力分析研究及設計要點
分享友人