空氣系數 的英文怎麼說

中文拼音 [kōngqìxìshǔ]
空氣系數 英文
air factor
  • 空 : 空Ⅰ形容詞（不包含什麼; 裏面沒有東西或沒有內容; 不切實際的） empty; hollow; void Ⅱ名詞1 （天空） s...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 空氣 : 1 （大氣） air; atmosphere 2 （氣氛） atmosphere 3 （氣閘） air brake4 pneum ; pneumo ; pneumat ;...
  • 系數 : [數學] coefficient; ratio; modulus; quotient; factor
  1. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。
  2. Influence of hydrogen - air ratio on combustion efficiency for microcombustor

    過量空氣系數對微細腔內氫氣預混燃燒效率的影響
  3. After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %

    摘要通過對加熱爐幾種工況進行熱力計算、冷態試驗的流場分佈及阻力測定和熱態試驗的爐膛溫度場分佈及管壁溫度等參數的測定，確定將管式加熱爐爐膛內直流燃燒改為旋流場燃燒和增加輻射筒，增設煙氣含氧量分析，可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下，極好地改善爐膛內的燃燒狀況和對流輻射傳熱效果，從而降低排煙溫度45 ，減少加熱爐排煙損失，節約了煤氣量6 %以上。
  4. There are 3 parts of heat loss for gas boiler, including heat emission loss, uncompleted burning loss and fume hot loss, uncompleted burning loss decreases following the increase of excess air coefficient, while fume hot loss increases. it is obvious that there exit an optimum coefficient of excess air which make boiler own highest efficiency which is the purpose of burning control

    不完全燃燒熱損失隨過量空氣系數的增大而減小，而排煙熱損失隨過量空氣系數的增大而增大，不難看出，存在一最佳的過量空氣系數使得兩者之和最小，即使得鍋爐的熱效率最高，燃燒控制的目的即在於此。
  5. Under the condition of constant phosphorus mass flow rate, the smog exit temperature would increase slowly while other parameters would decrease with increasing excess air coefficient

    在燃磷量不變情況下，最高燃燒溫度、壁面最大熱流和平均熱流均隨過剩空氣系數的增大而減小，但煙氣出口溫度緩慢增加。
  6. The predicted results showed that maximum combustion temperature, smog exit temperature, maximum wall heat flux and averaged wall heat flux would increase with increasing phosphorus mass flow rate when excess - air coefficient or air flow rate was constant

    模擬結果表明，無論過剩空氣系數固定還是空氣流量固定，隨燃磷量的增大，最高燃燒溫度、煙氣出口溫度、壁面平均熱流和最大熱流都呈上升趨勢。
  7. The effects of parameters on maximum combustion temperature, smog exit temperature, maximum wall heat flux, averaged wall heat flux of a new phosphoric acid tower with circular water wall were discussed, including phosphorus consumption, excess - air coefficient, wall temperature and radiation absorption coefficient, with the mathematical model developed in part

    摘要利用已建立的數學模型考察了燃磷量、過剩空氣系數、壁面溫度、輻射吸收系數對新型燃磷塔的最高燃燒溫度、煙氣排放溫度、壁面最大熱流和平均熱流的影響。
  8. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  9. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  10. It is the foundation of boiler burning control to find optimum excess air coefficient, in addition, it is key to adjust the damper opening and valve opening use fuzzy control algorithm according to the content signal of o2 and co in fume road

    尋找最佳過量空氣系數是鍋爐燃燒控制的基礎，而鍋爐燃燒控制的關鍵是根據煙道含氧量、煙道一氧化碳含量信號，調整氣風門開度，使過量空氣系數保持在最佳值附近。
  11. Discussed taking advance condensation heat of water in waste fume. at the same time, the water can absorbed several pollutants in waste fume

    對比了不同空氣系數下，不同排煙溫度時的余熱回收溫度效率，探討了利用燃燒過程中生成水的冷凝熱及其對污染物的吸收作用。
  12. Using this system, research on nox emission and burnout characters of the test facility are carried out. the results of influence on nox emission and carbon in fly ash by coal type, coal particle diameter, furnace temperature and excess air are reached through tests. then micronized coal reburning tests are processed, which show a remarkable effect results on nox reduction and burnout rate

    通過大量的試驗，得出了煤種、煤粉細度、爐膛溫度和過量空氣系數等因素對nox排放和煤粉燃燼率的影響趨勢；並在此基礎上研究了超細粉再燃對脫氮效果和燃燼性能的作用，試驗結果表明超細煤粉再燃對降低nox排放和飛灰含碳量具有明顯的效果。
  13. Coefficient of excess air

    過量空氣系數
  14. Effects of intake temperature and air fuel ratio on hcci combustion of ethanol

    進氣溫度和過量空氣系數對乙醇均質壓燃燃燒過程的影響
  15. Influence of blending gas fuels to air - charged efficiency and over - air coefficient in diesel engine

    柴油機摻燒氣體燃料對充氣效率和過量空氣系數的影響
  16. What ’ s more, the emissions of the nox and pm are quite lower because of its unique homogeneous charge and low temperature combustion process

    分析了進氣溫度、過量空氣系數和egr率對乙醇燃料hcci燃燒的影響規律。
  17. In order to achieve this purpose this paper emphases on finding the optimum excess air coefficient and feedback control of burning effect

    為達這一目的，本文著重討論了鍋爐燃燒系統過量空氣系數的尋優以及燃燒效果的反饋控制。
  18. The paper creatively puts forward a kind of gradual adapt algorithm based genetic algorithms to dynamical find optimum excess air coefficient of boiler

    本文創造性地提出了一種基於遺傳演算法的逐步自適應尋優演算法，來動態地尋找鍋爐最佳過量空氣系數。
  19. Because of the great disturbance of boiler burning system, on the spot, we do n ' t find absolute excess air coefficient but its optimum interval

    由於鍋爐燃燒系統的擾動較大，我們實際尋取的是相對的最佳過量空氣系數，更為重要的是找到最佳過量空氣系數區間。
  20. It is likely to surmount the limitations of heat efficiency and pollutant emissions of traditional diesel and gasoline engines and become the wide using combustion mode

    並給出了三維map圖。定義了以過量空氣系數為基礎的失火限制限、爆震限制限和部分燃燒限制限。
分享友人
分享到 Line

分享到臉書