空氣預熱器 的英文怎麼說

中文拼音 [kōngqìyùrèqì]
空氣預熱器 英文
air heater
  • 空 : 空Ⅰ形容詞（不包含什麼; 裏面沒有東西或沒有內容; 不切實際的） empty; hollow; void Ⅱ名詞1 （天空） s...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 預 : Ⅰ副詞（預先; 事先） in advance; beforehand Ⅱ動詞（參與） take part in
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 空氣 : 1 （大氣） air; atmosphere 2 （氣氛） atmosphere 3 （氣閘） air brake4 pneum ; pneumo ; pneumat ;...
  1. Firstly, simulate flow field of rear smoke channel, plot velocity magnitude and ash concentration distribution in section of entry of heat pipe air preheater, compare with data which were measured in guiyang power station, verify simulation to be reasonable and right. secondly, simulate all kinds of factors which affect flow field ' s uniformity such as length, thickness, location of diffluent board, ash concentration, ash diameter, and so on, find the chiefly factors. thirdly, install guide board in curve channel in rear smoke channel, then simulate its " flow field, plot velocity magnitude and ash concentration distribution

    在此基礎上模擬在冬夏兩季不同情況下，不同流速對熱管空氣預熱器壁面溫度的影響；然後對影響整個流場分佈的各種因素：包括分流板長度、厚度、偏離中心流道位置的偏離度、飛灰濃度、飛灰粒徑等因素進行數值模擬；最後提出在分流煙道轉彎處加裝導流板，並模擬加裝導流板后的流場分佈，得到下級空氣預熱器出口、熱管空氣預熱器進口處的斷面速度場分佈、濃度場分佈，以論證加裝導流板能達到流場均勻化的作用。
  2. Wearproof porcelain plate developed by this factory can be used as inside lining plate, coal delivery pipework, bin, bunker, separation port, wind pipe bend, exhauster, inner pipe of mill fan, air preheater, air fule and various dedust equipment for antifriction. besides, it can extend the service life of equipment

    耐磨瓷板系是我廠自行研製的適用於磨煤機內襯板，輸煤管道、料倉、料斗、粗、細粉分離口、一、二次風管彎頭、引風機、排粉機內殼、空氣預熱器、尾部煙道等以及各類除塵系統設備的防磨抗蝕、延長設備的使用壽命。
  3. From simulations and data of fire site, most air preheater fire often appear when boiler is started in cool state and standby which fuels of insufficient combustion coagulate and congregate on the parts of air preheater. when the temperature of smoke inpouring air preheater increases, aggregate fuels and sediments will combust in stated temperature conditions. it is called the second combustion of air preheater

    這些起火起因於燃料油的不充分燃燒，其結果是未充分燃燒的燃料油凝結和聚集在空氣預熱器的部件上，當進入空氣預器的煙氣溫度增高時，沉積的燃料油被烘烤，當達到一定溫度條件時，則可點燃這些燃料油污沉積物，造成火災發生，這通常被稱為空氣預熱器的二次燃燒。
  4. Control on intimate terms of the air preheat device

    空氣預熱器的間隙控制
  5. The new developments of htm station technique were introduced from the aspects such as changing the htm pipeline type in pet htm station, increasing the switch forms of steam atomization and compressed air atomization, increasing the steam generator, sending stripping tower off - gas to combination and using new material nd steel in air preheater

    摘要從改變聚酯熱媒站的熱媒爐熱媒管線形式、增加蒸汽霧化與壓縮空氣霧化的切換形式、增加蒸汽發生器、汽提塔尾氣送燒、空氣預熱器採用新型材質nd鋼等方面介紹熱媒站技術的新發展。
  6. 2. design scheme of gravity heat pipe air pre - heater is proposed which fits the actual situation of injecting steam boilers. detailed heat calculation and design on heat recovery of flue gas is carrying out

    提出了採用適合於注汽爐實際工況的重力熱管式空氣預熱器的設計方案，對煙氣的余熱回收進行了詳細的熱力計算和設計。
  7. In this thesis, several advanced control methods are adopted to improve the performance of the traditional air preheater leakage control system using non - touched sensor

    本文採用了多種先進控制方法，用來改進傳統的非接觸式空氣預熱器密封間隙控制系統。
  8. Based on can bus, this thesis develops an innovational air preheater leakage control system, with pcs structure to fulfil the optimal control over system structure and the multi - signals transfer

    為了優化控制系統結構並解決系統中多種信號的傳遞問題，本課題以can總線為基礎，建立了fcs結構的新一代空氣預熱器密封間隙控制系統。
  9. Clearance control strategy in rotary air - preheater

    回轉式空氣預熱器密封間隙控制策略
  10. Application of heat pipe type air pre - heaters

    熱管空氣預熱器的應用
  11. Regulations for operation and maintenace of rotary air preheater

    回轉式空氣預熱器運行維護規程
  12. Heat pipe air pre - heater is adopted to recover gas heat to heat up cold air for burning, reducing flue gas temperature and increasing heat efficiency of injecting steam boiler

    採用熱管式空氣預熱器，利用排煙熱量加熱冷空氣，降低了煙氣溫度，減少排煙熱損失，提高注汽爐熱效率。
  13. Since the air leakage rate of the air preheaters in waigaoqiao 900 mw units is too high, and the opening of the primary fan stationary blades can not meet the requirement of the unit loads, a retrofit was carried out for the air preheater sealing system in according to the scheme proposed by alstom germany

    摘要針對外高橋900mw機組空氣預熱器漏風率偏高、一次風機靜葉開度不能滿足機組負荷要求這一影響機組運行的安全性和經濟性的問題，依據alstom德國公司提出的改進方案，對該空預器密封系統進行了改造。
  14. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  15. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  16. It works in the field where the temperature of gas is lowest of all components that be heated in the boiler. in general, air pre - heater is made of smooth pipes

    鍋爐設備中的低溫段管式空氣預熱器位於鍋爐煙氣溫度比較低的區域，它的管子通常採用光管構成。
  17. However, there lies a particular air leakage problem of revolving type air preheater, which will lead to serious energy waste

    但是容克式空氣預熱器有一個獨特的漏風問題，空預器漏風會引起嚴重的能源浪費。
  18. Research for improving the performance of rotary air preheater

    提高回轉式空氣預熱器性能途徑的研究
  19. Application of new steam soot - blower on heat pipe preheater

    用於熱管式空氣預熱器的新型蒸汽巡掃吹灰器
  20. Testing methods for air preheaters

    空氣預熱器試驗方法
分享友人
分享到 Line

分享到臉書