穿通擊穿 的英文怎麼說

中文拼音 [chuāntōngjīchuān]
穿通擊穿 英文
punch through breakdown
  • 穿 : Ⅰ動詞1 （破; 透） pierce through; penetrate 2 （通過孔、隙、空地等） pass through; cross; go thro...
  • 通 : 通量詞（用於動作）
  1. What was known as avalanche breakdown occurred.

    通常所謂的雪崩式擊穿現象爆發了。
  2. Do processing of preliminary emergency treatment to want to notice : eye ministry is bumped by stupid thing, local generation strut reachs ache, without the cut that the skin opens, can use cold towel cold compress, reach with subsidence of a swelling reduce ache ; if eye ministry is traumatic, bleed, the gauze of usable cleanness wraps up ; if the eyewinker flies inside pleasant to see, must not rub rubs an eye, should close double key point gently or blink a bit, let express light foreign body to be poured out of along with tear ; if the eyewinker has entered eyeball deep, eyeball already break - through, cannot oppress absolutely right now eyeball, lest emergence is organized inside the eye ; if forehead and eyebrow bend ministry are contused to want to note the eyesight case of seasonable self - check eye, preliminary judgement has injure secondhand without optic nerve

    做初步急救處理要注重：眼部被鈍物撞擊，局部產生腫脹及疼痛，無皮膚開放的傷口，可用冷毛巾冷敷，以消腫及減輕疼痛；若眼部外傷引起眼瞼裂傷或出血，可用清潔的紗布包紮；若有異物飛入眼內，千萬不要搓揉眼睛，要輕閉雙眼或稍眨眼，讓表淺的異物隨淚水流出；假如異物已經進入眼球深部，眼球已經穿通，此時絕不可壓迫眼球，以免眼內組織脫出；若額頭和眉弓部被撞傷要注重及時自我檢查眼睛的視力情況，初步判定有無視神經間接損傷。
  3. This heating helps to break down weak spots in the dielectric that otherwise might pass through the electrode undetected, only to fail during a later spark or hipot test

    這熱量幫助擊穿電線絕緣較薄的地方?否則線材通過電極而沒有被檢測到?結果在以後的火花測試和高壓絕緣試驗將會失效。
  4. Her hand reached for the tent peg, her right hand for the workman ' s hammer. she struck sisera, she crushed his head, she shattered and pierced his temple

    26雅億左手拿著帳棚的橛子，右手拿著匠人的錘子，擊打西西拉，打傷他的頭，把他的鬢角打破穿通。
  5. She put her hand to the tent peg, and her right hand to the workman ' s hammer ; then she struck sisera ; she smashed his head ; indeed she shattered and pierced his temples

    26雅億伸手拿著帳棚的橛子，伸右手拿著匠人的錘子，擊打西西拉，打傷他的頭，把他的鬢角打破穿通。
  6. In order to improve process quality and increase probability, we optimize ohm contact resistance and breakdown voltage of devices by adjusting process conditions. finally, dc - 500mhz midf switch is fabricated, in which some important conclusions and suggestions are introduced

    工藝研究的重點是改進工藝質量，提高成品率，為此我們通過調整工藝條件來優化歐姆接觸電阻和提高器件的擊穿電壓。
  7. Investigation of a low prepulse multi - channel self - breaking water switch

    低預脈沖水介質多通道自擊穿開關實驗研究
  8. Author analyzed the relationship between the length and the impurity concentration of drift region and thickness of buried oxide layer and thickness of soi and the charges of oxide layer and bias voltage of bulk and breakdown voltage and on - resistance by numerical simulation

    採用數值模擬分析方法，深入研究了漂移區長度、漂移區濃度、埋氧層厚度、頂層硅厚度、氧化層電荷以及襯底偏壓對resurf效應、擊穿電壓和導通電阻的影響。
  9. Test results indicated : with the hoist of altitude, the increase of ice amount and the rise of pollutant, the average flashover voltage reduced. the character exponent generally depends on the insulator profile, ice amount, ice state and pollution severity etc. by means of a high - speed camera, a data acquisition system and high voltage test facilities, a series of the flashover processes on ice surfaces were record. the experimental results form this study and the subsequent theoretical analyses suggested : the thermal ionization of the air in front of an arc root resulted in arc movement ; the electrostatic force had an auxiliary effect of impelling arc propagation ; the electrical

    通過對攝像機、數據採集系統及高壓試驗裝置記錄覆冰絕緣子表面閃絡電弧的發展過程的試驗結果進行理論分析得出：弧根周圍空氣的熱電離導致了電弧的發展，靜電場力對電弧的發展起到了加速作用，電擊穿僅發生在閃絡最終的跳躍階段；通過測量閃絡過程中的放電電壓、泄漏電流、閃絡時間、覆冰水電導率、電弧長度及電弧半徑等參數，得到了不同階段電弧（電弧起弧階段、電弧發展階段及完全閃絡）的發展速度、臨界電弧長度均隨覆冰水電導率的增加而減小。
  10. It also put forward that how to select appropriate epilayer doping concentration and thickness, pn junction depth and jte technology to increase the breakdown voltage of 4h - sic mps. a power dissipation model of 4h - sic mps was established

    通過對4h - sicmps擊穿特性的二維模擬，提出如何選擇合適的pn結深度、外延層摻雜濃度和厚度以及如何運用jte終端技術來提高擊穿電壓。
  11. In this paper, the theory of negatively charged surface states is used to investigate dynamic breakdown characteristics and the increase of gate - drain breakdown voltage as well as the reduction of saturated drain - source current after sulfur passivation. the measure which can improve the stability of sulfur passivation is proposed

    本論文通過對gaasmesfet擊穿機理和硫鈍化機理的研究，用負電荷表面態理論，解釋了gaasmesfet動態擊穿特性及硫鈍化后柵漏擊穿電壓增大、源漏飽和電流減小的機理，提出了改善硫鈍化穩定性的措施。
  12. The result of numerical simulation indicated the tradeoff of breakdown voltage and on - resistance. the selection of structure prefer the thicker buried oxide layer and the thicker soi layer and the shorter drift length when the breakdown was happened at the interface of soi and buried oxide layer

    模擬結果表明，擊穿電壓與導通電阻存在明顯折衷關系，因此在選擇器件結構時要選擇埋氧層厚度大，漂移區濃度高，在保證擊穿發生在縱向的情況下，漂移區長度越小越好。
  13. According to the thickness of the soi film, high voltage ic based on soi material ( soi - hvic ) can be divided into thin - film and thick - film. for thin - film soi - hvic, linear drift region doping profile is adopted to satisfy a certain breakdown - voltage, but this process is too complex and its self - heating effect is obvious ; for thick - film soi - hvic, it can take advantage of cmos technology on silicon to obtain the high voltage

    Soi高壓集成電路根據頂層硅厚度可分為厚膜和薄膜兩大類。為了滿足一定的擊穿電壓，薄膜soi高壓電路一般採用漂移區線性摻雜技術，但其工藝復雜，且自熱效應嚴重;而厚膜soi高壓集成電路可以通過移植體硅cmos技術來實現高壓，但是由於其硅膜較厚，介質隔離成為厚膜soi高壓集成電路的關鍵技術。
  14. I have already observ d how i brought all my goods into this pale, and into the cave which i had made behind me : but i must observe too, that at first this was a confus d heap of goods, which as they lay in no order, so they took up all my place, i had no room to turn my self ; so i set my self to enlarge my cave and works farther into the earth, for it was a loose sandy rock, which yielded easily to the labour i bestow d on it ; and so when i found i was pretty safe as to beasts of prey, i work d side - ways to the right hand into the rock, and then turning to the right again, work d quite out and made me a door to come out, on the out - side of my ale or fortification

    現在我必須補充說一下，就是那些東西起初都雜亂無章地堆在那裡，以致占滿了住所，弄得我連轉身的餘地都沒有。於是我開始擴大和挖深山洞。好在巖石質地是一種很松的沙石，很容易挖，當我覺得圍墻已加固得足以防禦猛獸的襲擊時，我便向巖壁右邊挖去，然後再轉向右面，直至把巖壁挖穿，通到圍墻外面，做成了一個可供出入的門。
  15. Hot - carrier induced oxide breakdown shows different characteristics compared with that induced by conventional fn stress

    與通常的fn應力實驗相比較，熱載流子導致的超薄柵氧化層擊穿顯示了不同的擊穿特性。
  16. The conclusion that ez is more important during the breakdown of rf ion source is made out by comparing ez and e 6 before breakdown, and then, the breakdown criterion of rf ion source is deduced, and the relation between breakdown voltage and pressure is analyzed too

    通過比較擊穿前高頻電場的軸向和幅向分量，得出了軸向電場在高頻離子源擊穿中起主要作用的結論，並進而推導出了高頻離子源的擊穿判據，得出了氣體擊穿時離子源擊穿電壓和放電管內氣壓的關系。
  17. Through the relations of temperature - time, pressure - time and pressure - breakdown voltage, the relation between the breakdown voltage in different stages and time is derived

    通過金鹵燈的溫升?時間關系、氣壓?時間關系以及壓力?擊穿電壓的關系，得出了金鹵燈在不同階段的時間?擊穿電壓的關系。
  18. Tddb and hce always take place simultaneously under device operation conditions. hot - carrier enhanced tddb effect of ultra - thin gate oxide is investigated by using substrate hot - carrier injection technique

    在通常的工作條件下，氧化層的經時擊穿和熱載流子效應總是同時存在的。
  19. Jdy - 280b double electromagnetic lock product characteristic : strong holding force, no left magnet easily installed, low noise, durable no mechanical failure with signal feed back function applications : can be used with intercoms and access control systems, especially for fireproof door working voltage : 12vdc 24vdc working current : 12vdc 0. 27a, 24vdc 0. 46a power consumption : 3. 3w, 3. 5w, absolutely insulative power supply mode : successively working temperature : - 40 50 dimension : 473 x 45 x 30mm weight : 3920g yiwu qimingxing computer company copy right

    Jdy - 280b雙開門磁力鎖產品特性:吸力強無剩磁安裝方便噪音低壽命長具故障保護功能，無機械故障可具資訊回饋功能鎖狀態有指示燈指示：鎖門時綠燈指示燈亮開門時，紅色指示燈亮帶鎖狀態指示燈及聯網信號輸出適用范圍：可與樓宇對講門禁系統配套使用特別適用於逃生門防火門電氣性能：電氣性能：使用電壓： 12vdc 24vdc電流： 12vdc 0 . 53a 24vdc 0 . 27a絕緣電阻測試： dc500v 1分鐘無擊穿通電形式連續使用溫度： 40 50外形尺寸： 473 x 45 x 30mm重量： 3920g
  20. The paper studied withstand voltage level, influence factors, breakdown process and breakdown mechanism of covered with snow or ice through some theory calculation results, many test data and phenomena. the paper got the conclusions that withstand voltage strength of insulator covered with snow or ice descended largely, and the amount of ice or snow build - up, number of flashover, string length, environment temperature and leak current etc had obvious effects on flashover voltage values of insulators

    通過大量的試驗數據和現象研究冰雪條件下絕緣子的耐壓水平、影響因素及其擊穿機理，如串長的影響、環境溫度、絕緣子形狀及冰的干濕程度、閃絡次數、冠雪量和積冰量的影響、雪的密度、氣壓和濕度的影響等，並對試驗結果與理論分析結果進行了對比，分析其是否一致。
分享友人
分享到 Line

分享到臉書