第三迴路 的英文怎麼說

中文拼音 [dìsānhuílù]
第三迴路 英文
tertiary circuit
  • 第 : Ⅰ助詞（用在整數的數詞前 表示次序） auxiliary word for ordinal numbers Ⅱ名詞1 [書面語] （科第） gr...
  • 三 : Ⅰ數詞1. （二加一后所得） three 2. （表示多數或多次） more than two; several; many Ⅱ名詞（姓氏） a surname
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 第三 : third第三帝國 [德國] the third reich （1934 1945）; 第三 （層）樓 [美國] third story; [英國] seco...
  1. In the third chapter, the mathematical models of project system have been established, and simulation has been done on the simulink enviroment of matlab software kits. the simulation focus on the effects of main parameters on the dynamic characteristics of speed control system, and the main parameters include viscosity damp coefficient and friction torque of electrical motor shaft, internal leakage coefficient of pump / motor of hydraulic circuits, gas volume of pressure accumulator, viscosity damp coefficient of cylinder piston and different running building floors, etc. at last, theoretical research effects of the flow and pressure pulsation of pump / motor on car speed and oil volume leakage theory are discussed. the fourth chapter of this thesis concerns the research on the key items about hydraulic power control system according to the ens 1 - 2 and other hydraulic elevator standards

    論文第三章針對組成系統的各個模塊進行了機理建模，並且通過matlab軟體中的simulink圖形化模擬環境進行了本課題系統的模擬研究，主要針對影響系統特性的主要參數變化，動態分析系統的輸出特性，在上下行工況中，分析了電機軸系粘性阻尼系數、軸系摩擦力矩、主迴路蓄能器迴路液壓泵馬達內泄漏系數、蓄能器氣體容積、液壓缸柱塞粘性阻尼摩擦系數以及不同運行樓層工況等參數對系統特性的影響；最後對軸向柱塞泵馬達的流量壓力脈動對電梯轎廂速度的影響和蓄能器內油液體積損失機理進行了理論研究。
  2. Based on the question of eapl addressed in the third chapter, there will discuss the relative rules from the forth chapter to the eighth chapter

    根據第三章提出的行動? ?利潤迴路模型，在第四章至第八章中討論相應的企業行為規則。
  3. Chapter three is the trial part. the test of the every technical parameters of the trial tube has been finished in company. the test and verify of the ability of the short circuit electric

    第三章為試驗部分，在公司內完成了試驗管的各項技術參數測試，並在合成迴路上進行了真空滅弧室短路電流能力開斷的試驗驗證。
  4. Crosstalk via tertiary circuit

    經由第三迴路的串音
  5. The third, some groping researches are made on broadband coaxial line filter output circuit of klystron. a broadband output circuit - mode four coupling slots double - gap output cavity loaded with coaxial filter, which has a workable relative bandwidth bigger than 14 % and fits in with l - band multi - beam klystron, is designed. meanwhile some analysis of its stability and peak power capacity is made

    第三，對速調管同軸線濾波器寬帶輸出迴路進行研究和探索，設計出了一個適合用於l波段多注速調管、相對帶寬超過14的四耦合槽模強耦合雙間隙腔加載同軸線濾波器輸出迴路，並對其穩定性和峰值功率容限做了一些分析。
  6. Four parameters for determining the type of circuit of spherical four - bar linkage are defined. according to the relationship of these parameters, three types of circuit of spherical four - bar linkage are found, which is proved in view of geometry point. base on the theory of sphere triangle, an approach of identifying the circuit and branch defect of spherical four - bar linkage is proposed

    首先提出了四個迴路類型判斷參數，根西安理工大學博士學位論文據這些參數之間的關系，將球面4r機構迴路分為三種類型，並從幾何的觀點進行了證明;然後基於球面三角理論，提出了球面4r機構迴路及分支缺陷識別的轉角符號法，而由空間第一組機構與其等效球面4r機構迴路特性的等效性，此方法對空間第一組機構的迴路和分支缺陷的識別同樣有效。
  7. Third, the center of mass stabilization loop is designed by the proportion control law in variable structure control, the design method of the proportion control law is deducted elaborately. the result is the character points is unified on parameter. the two simulation results of the different methods are compared in this paper

    第三，利用變結構控制中的比例控制規律對導彈的質心穩定迴路進行了設計，詳細推導了比例控制規律的設計方法，實現了各個特徵點設計參數上統一，並對前面兩種設計方法的模擬結果進行了比較，最後還討論了兩種設計方法對干擾的抑制作用。
  8. In chapter 3, according to the requirements of high voltage power supply used for charging capacitors with constant current, the series resonant converter ( src ) was chosen as the main circuit frame. the dynamic process of src was discussed by using mathematical analyses and numeric simulation to study the operational characteristics, the effects of parameters of resonant circuit on them and the relationship between switching frequency and out put power, which provided the bases of designing the power supply

    第三章中根據高壓電容恆流充電電源的運行特點，選擇了串聯負載諧振變換器作為主電路結構形式，並對其動態過程進行了數學分析及數值模擬，討論了該電路的運行特點、諧振迴路參數對運行特性的影響以及開關工作頻率與功率輸出的關系，為電源的設計提供了依據。
  9. The second, a complete simulation computation method for output circuit of broadband klystron is developed, basing on existing program isfel3d for simulation computation of three dimensions electromagnetic field, principle of output circuit of broadband klystron and microwave network theory. some practical examples are calculated and the calculated results are compared with cold test results, so that the reliability of the simulation computation method is proven

    第二，基於現有的三維電磁場模擬計算軟體isfel3d 、寬帶速調管輸出迴路原理和微波網路理論，建立了一套完整的寬帶速調管輸出迴路模擬計算方法，並通過實際例子的計算結果和冷測結果的比較，驗證了該模擬計算方法的可靠性。
分享友人
分享到 Line

分享到臉書