等軸晶粒 的英文怎麼說

中文拼音 [děngzhóujīnglì]
等軸晶粒 英文
equiaxed grain
  • 等 : Ⅰ量詞1 （等級） class; grade; rank 2 （種; 類） kind; sort; type Ⅱ形容詞（程度或數量上相同） equa...
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  • 粒 : Ⅰ名 （小圓珠形或小碎塊形物） small particles; grain; granule; pellet Ⅱ量詞（用於粒狀物）
  1. In one, equiaxed dendrites form and subsequently ripen into more - or - less spheroidal shape, suitable for forming

    一個是先形成由等軸晶粒構成的晶枝體，再熟化形成類似的球狀體。
  2. 4. after continuously heated and isothermally soaked, the equiaxed grain, as the result of the recrystallization, was the necessary texture condition of the semi - solid grain ' s globalization processing

    4 、連續升溫和等溫保溫過程中再結晶形成等軸晶，為半固態晶粒球狀化提供了必西安理工大學碩士學位論文要的組織條件
  3. The globalization course was that the preformed texture recrystallized and became the granular equiaxed grain, when the temperature rose and the holding time prolonged, the granular grain melted at some area and at the liquid - solid interface the grain globalized at the role of the curvature overheated

    過程機制為：擠壓形變組織在加熱過程中首先發生再結晶長大變為顆粒狀等軸晶；隨溫度升高和保溫時間延長，等軸晶發生局部熔化，液固界面的曲率過熱使晶粒外形向球狀轉變。
  4. The microstructure of lamellae pearlite has evolved ultrafine cementite particles throughout the ferrite matrix uniformly after five passes. the ferrite matrix is homogeneous grains, average grain size is - 0. 3 m. 2

    變形五道次后，片層狀的珠光體組織演變成了超細的滲碳體顆粒均勻分佈於鐵素體基體的組織，鐵素體基體為均勻的等軸晶，平均晶粒大小為0 . 3 m 。
  5. Abstract : the crystal structures obtained by static solidification and vibration solidification were compared. it was showed that, in the case of vibration solidification, the orientation growth of the columnar crystal was not obvious, the equiaxial crystal appeared more early. the grains of both types of crystals were quite fine, hardness in the full section was relatively high, and the hardness distribution was uniform. in the former case, the solute segregation in dendritical austenite more severe, and there were lumps of distortion inclusion

    文摘:對球鐵金屬型靜凝固與振動凝固的結晶組織對比表明：後者柱狀晶方向性生長較弱，等軸晶出現較早，且兩者的晶粒均較細，全斷面硬度較高且分佈均勻；前者枝晶奧氏體內溶質偏析大，有畸變夾雜團塊。
  6. The ecap results of different initial grain show initial grain have a great influence on the refinement of grain. more equiaxial and uniform the initial grain is, it is more favorable for the refinement of grain

    對不同初始晶粒純銅室溫ecap行為的研究發現：初始晶粒對其ecap行為有很大的影響，初始晶粒越等軸、越均勻，越有利於晶粒細化。
  7. The key problem of magnesium application is its poor forming ability, so it is very important to find an effective grain refiner for magnesium alloys

    實踐證明，細小等軸的晶粒組織能改善其塑性變形能力，因此找到一種實用有效的工藝來細化鎂合金晶粒就顯得非常重要。
  8. Prepared technical parameters were optimized by l9 ( 34 ) experiment analysis. a unique method for cleaning and drying of substrate - cleaning used by scour, drying used by infrared light was fished out by large numbers of experiment. chemical mechnism of zno thin film prepared by sol - gel technique was discussed by dta for the first time. by the measurements of sem, xrd and uvs, the thin film was analysed. the result proved that the thin film with strongly preferred orientation of c - axis perpendicular to the substrate surface which surface was homogenous, dense and crackfree was the crystalline phase of hexagonal wurtzite. the thin film was composed of plentiful asteroidal crystal which crystal dimension approximately 10 30nm. the average transmittance of thin film in visible region was above 90 %. the results of measurements else also proved that the thickness of single dip - coating was 75 240nm, this films resistivity was found to be 3. 105 102 3. 96 105 ? cm. the thickness and resistivity of thin film influenced by dope - content, withdrawal speed, pre - heat - treatment, anealing were reseached respectively

    利用xrd 、 sem以及uvs光譜儀等分析方法對薄膜進行了研究，結果顯示，所制備的薄膜為六方纖鋅礦型結構，具有高c軸擇優取向性；表面均勻、緻密，薄膜材料由許多星狀晶粒組成，晶粒尺寸大約為10 - 30nm左右；薄膜可見光透過率平均可達90 % ；對薄膜厚度以及電學性能進行了測定后發現：單次鍍膜厚度約為75 - 240nm ， al ~ （ 3 + ）離子摻雜型氧化鋅薄膜的電阻率在3 . 015 102 - 3 . 96 103 ? cm范圍內；分別研究了摻雜濃度、提拉速度、預燒溫度、退火溫度等工藝參數對薄膜厚度和電阻率的影響。
  9. The formation of a new set of strain - free grains within a previously cold - worked material ; normally an annealing heat treatment is necessary

    在冷塑性變形材料的內部生成等軸狀新晶粒的過程叫再結晶，通常發生於再結晶退火熱處理過程中。
  10. It was confirmed that the first reaction layer of tic with very fine crystal grains is due to the reaction ti + sic - tic + si. this reaction is a reaction - controlled one. however, the other reactions in the second step a re controlled by elements diffusion

    Scs一6sic / ti3ai復合材料的界面反應產物可多達6層，依次為:緊挨著纖維的晶粒細小的tic層、晶粒細小的tissi ;層、等軸晶粒的tic層、 ti3si層、 ti3aic層及ti5si3層。
分享友人
分享到 Line

分享到臉書